Haier DW12-TFE5 User Manual

DISHWASHER OPERATION MANUAL

PLEASE READ THIS OPERATION MANUAL BEFORE USING THE DISHWASHER.

DW12-TFE5

0120504965D

Electrical Connection (Uk Only)

For your safety please read the following information.

Warning: This appliance must be earthed.

The appliance must be connected to a 220-240 volts 50 cycle AC supply by means of a three pin

socket, suitably earthed and should be protected by a 13 amp fuse in the plug.

The appliance is supplied with a rewireable 13 amp 3-pin plug fitted with a 13-amp fuse. Should the

fuse require replacement, it must be replaced with a fuse rated at 13 amp and approved to BS1362.

If the mains plug is unsuitable for the socket outlet in your home or is removed for any other reason,

then the cut off plug should be disposed of safely to prevent the hazard of electric shock. Remove the

fuse before disposal.

There is a danger of electric shock if the cut off plug is inserted into any 13-amp socket outlet.

How to wire a 13 amp plug.

Important

The wires in the mains lead on this appliance are coloured in accordance with the following code:

Green and Yellow-Earth Blue-Neutral Brown-Live

As the colours may not correspond with the markings identifying the terminals in your plug proceed as

follows.

The green and yellow wire must be connected to the terminal in the plug which is marked with the letter

E or with the earth symbol or coloured green and yellow.

The blue wire must be connected to the terminal marked N.

The brown wire must be connected to the terminal marked L.

You must make sure the lead is firmly secured under the cord clamp.

Important safety information

This appliance must be earthed. It is intended for use on a 220-240Volt 50Hz mains supply.

Check that the voltage marked on the rating plate matches that of your local supply before plugging in for the first time. Improper connection of the grounding conductor can result in the risk of an electric shock. Check with a qualified electrician or service representative if you are in doubt whether the appliance is properly grounded. Do not modify the plug provided with the appliance; if it does not fit the outlet. Have a proper outlet installed by a qualified electrician. Check packaging and dishwasher immediately for signs of transport damage. If the appliance is damaged, do not put it into use but contact your supplier or customer service without delay. This dishwasher must be plugged into a separate mains socket that is earthed and remains all times, even after installation. The dishwasher must only be used for the washing of household dishes and cooking utensils. This appliance cannot be installed outdoors, not even if the area in which it is installed is covered by a roof; it is also very dangerous to leave it exposed to rain. Check that the voltage marked on the rating plate matches that of your local supply. If the supply cord is damaged, it must be replaced by the manufacture, its service agent of similarly qualified person with a cord of the same type and rating in order to avoid a hazard. Never disconnect from the mains by pulling on the mains cord, always grasp the plug. Never touch the dishwasher when barefoot or with wet hands or feet; We discourage the use of extension cords and multiple sockets as they constitute a tripping Hazard and might cause a fire. Do not open the door during a wash cycle as hot steam and water may be ejected. Do not touch the heating element during or just after a wash cycle. Do not overload the dishwasher; the maximum number of place settings is 12. Do not sit or stand on the door or place heavy objects on it as the dishwasher will tip forward. Do not let children play on or near the dishwasher. Do not let anything including carpets block ventilation openings in the base of the appliance. Do not use the dishwasher if the mains cord is damaged, if it is damaged in any way or does not operate as expected, contact the store where you purchased the dishwasher for advice. The inlet water pressure must be no lower than 0.03 MPa and no higher than 1 .0 MPa. Connect to the water mains using new hose sets; do not re-use old hose sets. This appliance is not intended for use by persons (including children) with reduced physical sensory or mental capabilities or lack of experience and knowledge unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. Check Plastic items are dishwasher safe. You must prevent them coming into contact with the heating elements during a washing cycle. The door shall not be left in the open position since this could present a tripping hazard.

accessible

WARNINGS:

Knives and other utensils with sharp points must be loaded in the basket with their points down or placed in a horizontal position. THIS APPLIANCE IS INTENDED FOR DOMESTIC USE ONLY; ANY OTHER USE MAY INVALIDATE THE WARRANTY AND MIGHT BE DANGEROUS. USE THIS APPLIANCE FOR ITS INTENDED USE ONLY. Dishwasher detergent is strongly alkaline! Take care to keep it out of reach of children If you are discarding an old appliance with a lock / catch fitted to the door, ensure that it is in a disabled condition to avoid the entrapment of children when playing. Disconnect from the mains, remove the plug and cut the mains cable off close to the appliance before disposal at end of life, take the appliance to your local recycling point.

Index

Safety information

Installation

Getting to know your dishwasher

How to fill the salt

How to fill rinse aid

How to fill the detergent dispenser

Not suitable for the dishwasher

Arranging crockery, glasses, etc. in the dishwasher

Programme overview

Washing dishes

How to keep your dishwasher in shape

Care and maintenance

Trouble Shooting

Technical data

Important information

Disposal

The symbol on the product or on its packaging indicates that this product may not be treated as household waste. Instead it shall be handed over to the applicable collection point for the recycling of electrical and electronic equipment. By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product. For more detailed information about recycling of this product, please contact your local city office, your household waste disposal service or the shop where you purchased the product.

Safety information

At time of delivery

Check packaging and dishwasher immediately for signs of transport damage. If the appliance is damaged, do not put it into use but contact your supplier or customer service without delay. Please dispose of packaging materials properly.

During installation

Site the dishwasher and connect it up in accordance with the installation instructions. The dishwasher must not be connected to the electricity supply while installation is being carried out. Ensure that the domestic wiring is properly earthed. The mains electricity supply must conform to the details shown on the dishwasher nameplate. Do not connect the dishwasher to the electricity supply via an extension cable. Built-under and built-in appliances should always be installed under a continuous work surface which is attached to the adjacent cupboards, in order to ensure that the appliance is entirely stable. After the appliance has been installed,the mains plug should still be easily accessible. During installation, the power supply cord must not be excessively or dangerously bent or flattened.

During normal use

The dishwasher must only be used by adults for the washing of household dishes and cooking utensils. This appliance cannot be installed outdoor, not even if the area in which it is installed is covered by a roof; it is also very dangerous to leave it exposed to the rain and elements. Do not place any heavy objects or stand on the door when it is open. The appliance could tip forward. The water inside the dishwasher is not suitable for drinking. Do not use solvents of any kind inside your dishwasher. They could cause an explosion danger. Open the door very carefully if the dishwasher is operating. There is a risk of water squirting out. Do not touch the heating element during or after a wash cycle. Fundamental rules to follow when using the appliance:

- Never touch the dishwasher when barefoot or with wet hands or feet;

- We discourage the use of extension cords and multiple sockets;

- If the appliance is not operating properly or maintenance must be performed, disconnect the appliance from the power supply.

If your family includes children

This appliance is not intended for use by persons (including children) with reduced physical,sensory or mental capcabilities, or lack of experience and knowledge,unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. Children should be supervised to ensure that they to not play with the appliance. Keep detergents out of the reach of children, who must also be kept away from the dishwasher when it is open.

If a fault occurs

If the appliance malfunctions, turn off water supply to the appliance and disconnect the power supply turn off and the plug from the wall socket. Then, consult the section entitled, "Fault finding" .If you cannot solve the problem, contact a service center. Only specialised personnel are authorised to make repairs. If the supply cord is damaged, it must be replaced by the manufacture, its service agent of similarly qualified persons in order to avoid a hazard. To maintain the EFFICIENCY and SAFETY of this appliance,we recommend:

- call only the Service Centers authorized by the manufacturer, or the approved Service agents.

- always use original Spare Parts.

When disposing of old appliances

Appliances which are no longer being used must be made inoperable by cutting the power supply cord and removing the door lock. Take the appliance to a designated waste disposal center.

Dangerous voltage

Warning

Children could get locked in the appliance (risk of suffocation)

or get stuck in other positions. Therefore: Remove the mains

plug, cut the mains wire and set aside. Damage the door lock so

that the door can no longer be closed.

Installation

Positioning the appliance

Positioning the appliance in the desired location. The back of the appliance should rest against the wall, and the sides, along the adjacent cabinets or wall. The dishwasher is equipped with water supply and drain hoses that can be positioned to the right or the left to facilitate proper installation.

Levelling the appliance

Once the appliance is positioned, adjust the feet (screwing them in or out) to adjust the dishwasher, making it level. The appliance should not be inclined more than 2˚. If the appliance is level, it will help ensure proper performance.

Cold water connection

Connect the water supply hose to a threaded 3/4 (gas) connector, making sure that it is fastened tightly in place (see fig.A). Some models are fitted with an "Aquastop" water supply hose (see fig.B) in which the small filter is already housed in the threaded end. If the water pipes are new or have not been used for an extended period of time, let the water run to make sure that the water is clear and free of impurities. If this precaution is not taken, there is a risk that the water inlet can get blocked and damage the appliance.

fig.A

Warning

The appliance is to be connected to the

water mains using new hose-sets and

that old hose-sets should not be reused.

fig.B

Anti-Flooding protection

The dishwasher is equipped with a system that stops the supply of water in the event of a problem with the water supply hose, or leaks within the unit, in order to prevent damage to your home. If for any reason the box containing the electrical components happens to get damaged, appliance from the socket immediately. In order to guarantee that the anti-flooding feature operates properly, the "A" box with water supply hose must be attached to the water supply tap as shown in fig.B. No other type of connection is acceptable.The water supply hose must not, under any circumstances, be cut, as it contains electrical parts which are live. If the length of the hose is not adequate to make a proper connection, the hose must be replaced with one which is long enough. This hose is available upon request from specialised retailers and

approved

service center.

turn off the power supply and

remove the plug for the

Drain hose connection

Insert the drain hose into a drain pipe with a minimum diameter of 4cm, or let it run into the sink, making

sure to avoid bending or crimping it. If necessary, fit a syphon trap (U-bend) with a connecting piece for

the electrical drain hose (fig.C). The free end of the hose must be at a height between 40 and 100 cm

and must not be immersed in water.

fig.C

Attention:

The connecting piece for syphon trap (U-bend) must be securely fastened to the wall to prevent the drain hose from moving and allowing water to spill outside the drain.

Electrical Connection

After making sure that the voltage and frequency values for the current in the home correspond to those

on the rating plate (located on the stainless steel inner door of the appliance) and that the electrical

system is correct for the maximum voltage on the rating plate, insert the plug into an electrical socket

which is earthed properly (the earthing of the appliance is a safety requirement mandated by law).

If the electrical socket to which the appliance must be connected is not appropriate for the plug, replace

the whole cable, rather than using adaptors or the like as they could cause overheating and burns.

Caution:

The dishwasher plug must be accessible even when the appliance

is installed as a built-in unit so that maintenance can be done safely.

Getting to know your dishwasher

Close-up view (control panel)

BAD FCGEI

State Indicator

ON-OFF Button

"1/2" Indicator

"1/2" Button

Delayed Start Indicator

Dishwasher interior

Delayed Start Button

Time-remaining Indicator

Low Rinse Aid Indicator

Low Salt Indicator

Knob For Selecting Cycle

Upper Rack

Lower Rack

Top Spray Arm

Cutlery Basket

Bottom Spray Arm

Salt Container Cap

Washing Filter

Detergent and Rinse Aid Dispenser

Water Inlet Hose

Drain Hose

Power Supply Cord

How to fill the salt

Salt

The hardness of the water varies from place to place. If hard water is used in the dishwasher, deposits will form on the dishes and utensils. The appliance is equipped with a special softener that uses a salt specifically designed to eliminate lime and minerals from the water.

Loading the salt into the container

Always use salt intended for use with dishwashers. The salt container is located beneath the lower rack and should be filled as follows:

When the low salt indicator “I” lights, you must fill the salt. Remove the lower rack and then unscrew and remove the cap from the salt container; If you are filling the container for the first time, fill it with water; Place the end of the funnel (supplied) into the hole and introduce about 2 kg of salt. It is normal for a small amount of water to come out of the salt container. Carefully screw the cap back on.

Important

To prevent the formation of rust, load the salt just before beginning a wash cycle.

Adjusting salt consumption

The dishwasher is designed to allow for adjusting the amount of salt consumed based on the hardness of the water used. This is intended to optimize and customize the level of salt consumption so that it remains at a minimum. To adjust salt consumption, proceed as follows:

Unscrew the cap from the salt container; There is a ring on the container with an arrow on it (see figure to the side). If necessary, rotate the ring in an anticlockwise direction from the "-" setting towards the "+" sign, based on the hardness of the water being used.

It is recommended that adjustments be made in accordance with the following table:

Hardness of the water

ºdH ºmmol/l

0J10 MJNT MJNIT

ORJRM QRJUV QIRJUIV

The default setting of the water softening system is -. - If using multi-functional tablets fill the salt

dispenser and set the adjuster to -; if the hardness of the water is greater than 60ºfH, set it to +.

ºfH

NIUJQIQNUJQQNMJOR

[UV[RM [UIV

Selector knob position

=?J?

jba

Salt consumption (Grams/cycle)

SM?H?

Autonomy (cycles/2kg)

+ 22 hidden pages