Data Sheet Model No.: SS103A
Model No. : SS103A
Application : 12V Gasoline Engines (up to 3.0L)
Casing Material : ABS
Color : Yellow
Battery Type : 6 cells of 9/5 Sub C Size Lead Acid TMF (Thin Metal
Film) batteries, 39 cells of AA alkaline batteries (13 cells
inside the compartment for warning alarm & backing up
TMF pack; 13 cells welded in series for long storage
backup; 13 additional cells provided for customer to
change). The alkaline batteries float charge the TMF
batteries for a long storage life. The design expectancy
is approximately 1 year at 25°C / 77°F.
Nominal Voltage : 12.0V (TMF pack)
Charge Voltage : 14.4V (TMF pack)
Maximum Discharge Current : 900A
Nominal Capacity : 1Ah
Charger Power : 10.5W
Continuous Discharge Time : 7.5 Seconds at 200A
Frequency of cranking between full charges : 5 times (It is recommended to recharge immediately
after each crank).
Operating Temperature Range (Recommended) : 20 to 25°C (for optimum life; however it can be operated
at temperature of -20 to 50°C. Operation at higher or
lower temperature will affect battery life or performance).
Storage Temperature Range : -20 to 25°C (with alkaline batteries back up)
Typical Weight : 1.66 Kg
Package Weight : 2.53 Kg
Charge Duration
- With Car Alternator : 3 minutes after each successful crank (to allow a top up
charge of the SS103A in case of reuse within short time)
- With Wall Adaptor : at least 4 hours continuous charging
- With Car Adaptor : 4 hours cumulatively charging with engine running.
(Recommend to recharge SS103A with either the car
adaptor or wall adaptor continuously to keep battery at
full charge. It is also recommended to recharge
SS103A every month when not in use to enhance the
backup life.)
Other Features:
Audible Charge-Minder : Reminder for recharge & alkaline batteries replaceme nt.
LED Fuel Gauge Indicator:
- when charging : RED - FAST Charging
GREEN - SLOW Charging (ready)
- when storage : GREEN - Ready to jumpstart
ORANGE - Recharge is needed
RED - Immediately recharge and replace 13 x AA
alkaline batteries.
Safety : Do not allow both the positive (red) and negative (black)
clamps to come into contact.
Actual performance characteristics may vary depending on vehicle, environmental conditions, operation and
care.
Document No. : B-DS-ETD-04 Rev. 2