Gorenje BO75SY2-WGC6SY2WPK, GC6SY2W-AU User Manual

1 2

Dear customer!

Instructions for use

Instructions for
connection

Rating plate

This electric integrated gas hotplate cooker is manufactured for household use.
Our appliances are packed in the environmentally friendly materials which may be
recycled, deposited or destroyed without any hazard to the environment. Such
packaging materials are also labeled accordingly.
Once the life cycle your appliance is over, make sure not to pollute the environment,
and deliver it to the authorized collectors of old household appliances.

Instructions for use have been prepared for the user, and describe the appliance and
the way it is handled. These instructions are intended for various types of the appliance,
so you may find some descriptions for the functions that your
particular appliance may not have.

These instructions are only valid of the country symbol is indicated on the appliance. If
there is NO county symbol in the appliance, technical instructions should be observed
for adapting the appliance to comply with the requirements and regulations for use in
your country.

The appliance must be connected in compliance with the instructions attached to it, as
well as in compliance with relevant regulations and standards. The connection may only
be performed by a qualified person.

The rating plate indicating the basic information on the appliance is attached to the
lower side of the hob.

Safety warnings

DO NOT USE OR STORE FLAMMABLE MATERIALS IN OR NEAR THIS APPLIANCE

DO NOT SPRAY AEROSOLS IN THE VICINITY OF THIS APPLIANCE WHILE IT IS IN
OPERATION.

WHERE THIS APPLIANCE IS INSTALLED IN MARINE CRAFT OR IN CARAVANS, IT
SHALL NOT BE USED AS A SPACE HEATER.

DO NOT MODIFY THIS APPLIANCE

DO NOT PLACE ARTICLES ON OR AGAINST THIS APPLIANCE

Important warnings
Installation
Connecting to the power mains
Connecting to the gas supply
Technical information
Operation
Cleaning and maintenance
Problem solving guide

3
4
5
6

8
10
11
13

TECHNICAL INSTRUCTIONS AND INSTALLATION

Important warnings

• Installation of the appliance (installation class:3) into a kitchen worktop and its
connection to the power mains and the gas supply may only be performed by an
adequately qualified technician.

• When the appliance is in use, additional heat and moisture are emitted into the room.
When the appliance is used for a prolonged period of time at a high performance level,
intensive ventilation or use of kitchen hood may is required in the room where the
appliance is installed.

• Do not use the gas burners, if the flame seems unstable.

• If you smell gas in the room, immediately close the gas supply valve either on the gas
bottle or gas pipeline, extinguish all sources of open fire (including cigarettes), aerate
the room, do not turn on any electric appliances, and call a natural gas expert.

• The main gas supply valve should also be closed if gas burners will be out of use for a
long period of time (e.g. when going on holiday).

• The appliance and its accessible parts become hot during use. Care should be
taken to avoid touching heating elements. Children less than 8 years of age shall
be kept away unless continuously supervised.
Prevent the children to hang around the appliance and warn them properly against the
danger of burns.

• This appliance can be used by children aged from 8 years and above, and persons
with reduced physical, sensory or mental capabilities or lack of experience and
knowledge if they have been given supervision or instruction concerning use of the
appliance in a safe way and understand the hazards involved. Children shall not play
with the appliance. Cleaning and user maintenance shall not be made by children
without supervision.

• WARNING: Unattended cooking on a hob with fat or oil can be dangerous and

may result in fire.Be sure have the preparation of such food (fries) under constant
control. Never try to extinguish a fire with water, but switch off the appliance and then
cover flame e.g. with a lid or a fire blanket.

• WARNING: Danger of fire: do not store items on the cooking surfaces.

• WARNING: If the surface is cracked, switch off the appliance to avoid the

possibility of electric shock.

• Do not use high-pressure steam cleaner or hot steam to clean the appliance.

• Never place any metal objects upon the hob surface, such as knives, forks, spoons,
pot lids, and the like, as they may get very hot.

• The hob can not be activated by external timers or remote controls systems.

• Do not use the cooking hob for room heating.

• Do not place empty pans on the hob.

• Make sure that the parts of the burners are correctly positioned / installed.

• Hob surface should not be used as a worktop. Sharp objects may cause scratches.

• Preparing food in thin aluminum of plastic containers on hot cooking zones is not
allowed. Do not place any plastic objects or aluminum foil on the hob surface.

• If there is a wall power outlet located near the hob and another appliance is plugged
into it, make sure the power cord does not come into contact with the hot cooking
zones.

• Do not store any temperature-sensitive objects, materials, or substances underneath
the hob, e.g. detergents, sprays, etc.

• In case of a failure of the appliance, immediately disconnect the appliance from the
power mains and contact the service center.

• The appliance is manufactured in compliance with the relevant effective safety
standards.

• After a prolonged use of cast iron plates, the area of the plate and the edge of the
cooking zone may discolour. Repair service is not covered by the warranty.

• Don't connect the hob to the power supply with an extension cable or multiple sockets,
because they don't assure a sufficient safety (e.g. overheating risk of multiple sockets).

• Connect the equipment to a permanent connection.

The symbol on the product or on its packaging indicates that this product may
not be treated as household waste. Instead it shall be handed over to the
applicable collection point for the recycling of electrical and electronic
equipment. By ensuring this product is disposed of correctly, you will help
prevent potential negative consequences for the environment and human health,
which could otherwise be caused by inappropriate waste handling of thisproduct.
For more detailed information about recycling of this product, please contact
your local city offi ce, your household waste disposal service or the shop where
you purchased the product.

3

INSTALLATION

Important warnings

This appliance must be installed by an authorised person in accordance with this instruction manual, AS/NZS 5601 –
Gas installations (installation and pipe sizing), local gas fitting regulations,
local electrical regulations, local water regulations, local health regulations, Building Code of Australia and any other
government authority.

• Installation of the appliance into a kitchen worktop and its connection to the power mains may only be performed by an
adequately qualified technician.

• Veneer or other finish of the piece of kitchen furniture into which the hob is to be built in should be treated with heat
resistant glue (100°C); otherwise, the worktop finish may be discolored or deformed.

• Cooking hob is dimensioned to be built into the worktop over a piece of kitchen furniture, with a width of 600 mm or
more.

• After installation, the front two fastening elements should be freely accessible from below.

• The kitchen furniture element underneath the hob should not be fitted with a drawer. If the kitchen furniture element as
a horizontal partition wall, it should be installed no less than min 20mm from the lower surface of the worktop. The space
between the partition wall and the hob must be empty; no objects should be placed into that gap.

• Hanging, or wall-mounted kitchen elements should be installed high enough not to interfere with the work process.

• The distance between the cooking hob and the kitchen hood should be no less than indicated in the instructions for
kitchen hood installation. The minimum distance is 700 mm.

• The distance between the appliance edge and the adjacent tall kitchen furniture element should amount to no less than
150 mm.

• Use of massive wood decoration plates or boards on the worktops behind the cooking hob is permitted, if the minimum
distance remains the same as indicated in the installation drawings.

• Minimum distance between the built-in cooking hob and the rear wall is indicated on the installation drawing.

• Cooking hobs can be installed into worktops that are 25 to 40 mm thick.
The front part must have an opening of no less than 5 mm.

Overhead clearances—(Measurement A) Range hoods and exaust fans shall

be installed in accordance with the manufacturer’s relevant instructions.
However, in no case shall the clearance between the highest part of the hob of
the gas cooking appliance and a range hood be less than 600 mm or, for an
overhead exhaust fan, 750 mm.

Side clearances—(Measurement B & C) Where B, measured from the

periphery of the nearest burner to any vertical combustible surface, or vertical
combustible surface covered with toughened glass or sheet metal, is less than
200 mm, the surface shall be protected to a height C of not less than 150 mm
above the hob for the full dimension (width or depth) of the cooking surface area.
Where the gas cooking appliance is fitted with a „splashback“, protection of the
rear wall is not required.

Gas inlet is located at the rear right 25mm from the edge.

4

A (mm)
B (mm)
C (mm)
D (mm)
E (mm)
F (mm)
G (mm)

585
510
560
480

40

5

50

Installing the foam
gasket

Kitchen worktop cutoff
dimensions

Installation procedure

(with springs)

Before inserting the appliance into the opening in the kitchen worktop, the supplied
foam gasket must be attached to the lower side of the glass ceramic (glass) cooking
hob (see fi gure above).

Do not install the appliance without the foam gasket!
The gasket should be attached to the appliance in the following way:

- Remove the protective film from the gasket.

- Then, attach the gasket to the lower side of the glass, approximately 2-3 millimetres
from the edge (as shown in the figure). The gasket must be attached along the entire
length of the glass edge and should not overlap at the corners.

- When installing the gasket, make sure that the glass does not come into contact with
any sharp objects.

• Only ovens fitted with a cooling fan may be installed underneath this cooking hob.

• Before installing an oven, the rear wall of the kitchen furniture element should be
removed in the area of the cooking hob cutout. Furthermore, a gap of at least 5 mm
should be left at the front side.

• Worktop must be placed absolutely horizontal.

• Suitably protect the edges of the cut aperture.

• Connect the cooking hob to the mains power supply (see instructions for the
connection of the cooking hob to mains power supply).

• Put the supplied springs in their places.

• Insert the hob into the cut aperture.

• Press the hob firmly towards the worktop from above.

Installation procedure
(with fixing brackets)

The cook top is fixed to the unit by means of the brackets and accessories provided.
Holes are provided in the bottom of the tray where you can attach the screws (C) that
hold the brackets (B) in place.

CONNECTING THE APPLIANCE TO THE POWER MAINS

• The appliance may only be connected by an authorized skilled technician.

• Electric system protection should comply with all relevant regulations.

• The connection clips can be accessed when the connection clip covers are opened /
removed.

• Before connecting the appliance, make sure the voltage indicated on the rating plate is

5