Goldstar FFH-2165AX Service Manual SPEC

- 6 -
SPECIFICATIONS
1. AMP SECTION
Output Power(4, 2ch, HTD 10%) 10W + 10WT.H.D 0.15%Frequency Response (3dB down) 40Hz~25kHzSignal-to-noise Ratio 81dBInput Impedance 47kInput Sensitivity 400±30mVSeparation(AUX) 100Hz/1kHz/10kHz 50dB/50dB/40dB
2. TUNER SECTION
(1) FM(OIRT)
Frequency Range(50kHz or 100kHz Step) 65.0MHz~74MHz, 87.5MHz~108MHz
or 87.5MHz~108MHz
Intermediate Frequency 10.7MHzSensitivity 90/98/106MHz 11dBSignal-to-noise Ratio (Mono/Stereo) 60dB/55dBImage Rejection 106MHz 38dBIF Rejection 90MHz 65dBDistortion (Mono/Stereo) 1.0%/1.2%Frequency Response (-3dB) 60Hz~14kHzSeparation 100Hz/1kHz/10kHz 25dB/25dB/20dB
(2) AM(MW)
Frequency Range(9kHz or 10kHz Step) 522(530)kHz~1611(1720)kHzIntermedite Frequency 450kHzUsable Sensitivity 603/1008/1404kHz 56dB/mImage Rejection 1404kHz 28dBIF Rejection 603kHz 48dBSensitivity 1008kHz 28dBSignal-to-noise Ratio 1008kHz 37dBDistortion 1008kHz 1.6%Frequency Response (-6dB) 100Hz~2000Hz
(3) SW
Frequency Range 5.8MHz~18.0MHzIntermedite Frequency 450kHzUsable Sensitivity 40dBSelectivity
28dB
Signal-to-noise Ratio 11MHz 37dB
- 7 -
(4) LW
Frequency Range 153kHz~281kHzIntermediate Frequency 450kHzUsable Sensitivity 65dBImage Rejection 254kHz 25dBSignal-to-noise Ratio 200kHz 30dBDistortion 200kHz 3%
3. TAPE DECK
Tape Speed (MTT-111) 4.75 cm/secWow Flutter (MTT-111) 0.25%Fast Forward & Rewind Time (C-60) 120secFrequency Response (Playback:5dB Range) 125Hz~8kHzSignal-to-noise Ratio (Playback/Record) 48dB/43dBDistortion (Playback/Record) 2% / 3.5%Cross Talk (Playback/Record) 55dB/53dBChannel Separation (Playback/Record) 50dB/43dBErase Ratio 55dB
4. CDP
Frequency Response (40Hz~20kHz) 3.0dBSignal-to-noise Ratio 73dBDynamic Range 73dBT.H.D 0.4%Separation 60dB
5. GENERAL
Power Requirement Refer to the back panel of unitPower Consumption 60WDimension (Net:W x H x D) 161 x 249 x 275(mm)Weight (Net)
4.1kg
NOTE : Specification are subject to change without notice in the course of product improvement.
Loading...