General Machine Products 71637 User Manual

TRAVELING GROUND KIT

P/N 71637

OPERATION MANUAL

Copyright 2013 by General Machine Products Co., Inc

All rights reserved. No part of this publication may be copied, reproduced or

transmitted in any form whatsoever without the

written permission of General Machine Products Co., Inc.

GMP • 3111 Old Lincoln Hwy • Trevose, PA 19053 • USA

TEL: [phone] • www.gmptools.com

Page 1 of 8

General Machine Products Co., Inc.

MAY 2013 USA ver 2

Manual P/N 31378

REVISION HISTORY

Rev # Date Details Author

01 11/05/06 Ver 1 ADSPEAK

02 06/02/13

added instructions for short jumper

Reformatted and

This equipment should be used only by per­sonnel who have been given the appropriate

training and who are competent to use it.

These instructions are to be made available
to operators of this equipment at all times.
Failure to observe these safety instructions
could result in serious personal injury and/or

property damage.

A KONSCHAK

Page 2 of 8

General Machine Products Co., Inc.

GROUNDING ROLLER

This section covers the description and use of the grounding Kit.

Defined as: Kit, Traveling Ground, 1 each, aluminum, 3 roller, trav­eling ground equipped with two 5/8” buss bars for 2 jumper cable
and clamps and two each, 1” tie back holes in frame. 1 each,
jumper cable composed of 30’, 1/0, clear PVC jacketed, copper
jumper cable with each end fitted with copper compression fer­rules and two 5/8” – NC threaded bronze grounding clamps. 1
each, jumper cable composed of 2’, 1/0 clear PVC jacketed, cop­per jumper cable with each end fitted with copper compression fer­rules and two 5/8” – NC threaded bronze ground clamps. 1 each,
instruction card which outlines use of grounding kit as per OSHA

requirements.

The grounding roller provides a means of maintaining a continu­ous ground connection to moving conductors such as strand, open

wire, or pull line being placed from a stationary reel.

Page 3 of 8

General Machine Products Co., Inc.