Plus A4
POWER
READY
Plus A3
1
SEALED EDGESEALED EDGE
2
Letter, Legal, Menu, etc. Irregular shaped item
4
3
!
5
Plus A4
Pouch Entry
Power Indicator
Ready Indicator
On/Off Switch
Hot/Cold Switch
Plus A3
Release Lever
Power Cord
Release Lever
Power Cord
Pouch Exit
Power Indicator
Ready Indicator
Pouch Entry
Cold /Off / Hot Switch
Pouch Exit
Safety instructions
YOUR SAFETY AS WELL AS THE SAFETY OF OTHERS IS
IMPORTANT TO ACCO BRANDS. IN THIS INSTRUCTION
MANUAL ARE IMPORTANT SAFETY MESSAGES. READ
THESE MESSAGES CAREFULLY.
THE SAFETY ALERT SYMBOL PRECEDES EACH
SAFETY MESSAGE IN THIS INSTRUCTION MANUAL.
THIS SYMBOL INDICATES A POTENTIAL PERSONAL
SAFETY HAZARD THAT COULD HURT YOU OR
OTHERS, AS WELL AS CAUSE PRODUCT DAMAGE
OR PROPERTY DAMAGE.
Important safeguards
WARNING: FOR YOUR PROTECTION DO NOT
CONNECT THE POUCH LAMINATOR TO
ELECTRICAL POWER UNTIL YOU READ THESE
INSTRUCTIONS COMPLETELY. KEEP THESE
INSTRUCTIONS IN A CONVENIENT LOCATION
FOR FUTURE REFERENCE. TO GUARD AGAINST
INJURY, THE FOLLOWING BASIC SAFETY
PRECAUTIONS MUST BE OBSERVED IN THE
SET-UP AND USE OF THIS PRODUCT.
Special notice
Thank you, for your recent purchase of a GBC Pouch Laminator.
Your new laminator may emit a slight odour during the initial
stage of operation. It is normal and will diminish after several
hours of operation.
WARNING: TO AVOID ELECTRICAL
SHOCK OR OTHER INJURY, THE
FOLLOWING SAFETY PRECAUTIONS
MUST BE OBSERVED.
Electrical safeguards
• The unit must be connected to a supply voltage
corresponding to the electrical rating shown on the unit.
• Unplug the unit before moving it, or when it is not in use
for an extended period of time.
• Do not operate with a damaged supply cord or plug. Do
not alter the attachment plug. The plug is configured for
the appropriate electrical supply.
• Do not overload electrical outlets beyond their capacity; fire
or electrical shock could result.
• The unit is intended for indoor use only.
• Never push objects through the housing slots. Do not spill
liquid of any kind on this product.
• Close supervision is required when this product is used
near children.
General safeguards
• Use the unit only for its intended purposes of laminating
documents.
• Do not place anything in the throat opening of the
laminator other than pouches/documents.
• Place unit on a secure, stable work area to prevent the unit
from falling and possibly causing personal injury and
damage to the unit.
• Follow all warnings and instructions marked on the unit.
• The socket outlet shall be installed near the equipment
and shall be easily accessible.
• Do not attempt single side lamination, this will destroy the
laminator.
• Do not block the vent slots, this will cause the laminator to
overheat.
Technical specifications
GBC Inspire™ Plus Laminator A4
Electrical
Machine Dimensions
Machine Weight
Maximum Pouch Width
Maximum Pouch Thickness
Maximum Thru-put Thickness
Warm-Up Time
EU VER: 220-240V~ 50/60Hz / 295W / 1.35A
KR VER:
220-240V~ 50/60Hz / 275W / 1.25A
350 x 147 x 65 mm
1.0 kg
230 mm
2 x 100 mic (Total 200)
0.5 mm
3-5 minutes
GBC Inspire
EU VER: 220-240V~ 50/60Hz / 400W / 1.85A
KR VER: 220-240V~ 50/60Hz / 375W / 1.7A
440 x 147 x 65 mm
1.6 kg
330 mm
2 x 100 mic (Total 200)
0.5 mm
4-6 minutes
™ Plus Laminator A3
Operation, hot lamination
1
Connect power cord to appropriate power source.
2
To use the laminator:
For Plus A4: Switch the temperature button to “HOT”
position and the power button to “ON” (I) position . The
power indicator will glow.
For Plus A3: Switch the power button to “HOT” (II)
position (fig. 1). The power indicator will glow.
3
Position the document to be laminated into a GBC
laminating pouch, so that the document is aligned to the
folded sealed edge and the right and left borders are equal
(fig. 2).
4
When the ready indicator glows (fig. 3), insert pouch with
the sealed edge first into the machine (fig. 4).
5
The laminated item will automatically exit rear of the
machine. After the pouch has stopped moving,
immediately place it on a flat surface to cool for one
minute before handling.
6
If you have finished laminating, switch the power button to
“OFF” (O) position (fig. 1).
NOTE: DO NOT LAMINATE AN EMPTY POUCH.
Operation, cold lamination
1
Connect power cord to appropriate power source.
2
To use the laminator:
For Plus A4: Switch the temperature button to “COLD”
position and the power button to “ON” (I) position . The
power and ready indicator will glow.
For Plus A3: Switch the power button to “COLD” (I)
position (fig. 1). The power and ready indicator will glow.
3
Use and laminate your cold pouch.
CAUTION: If you have just done hot lamination,
please wait at least 30 minutes for the machine to
cool down before attempting to do cold lamination.
Service
Do not attempt to service or repair the pouch laminator
yourself. Unplug the unit and contact an authorised ACCO
Brands service representative for any required repairs.
Release Button
In the event of a misfeed or a jam follow these instructions.
1
Turn off the laminator immediately.
2
Press the release button to release the motor from the
rollers. Pull out your document from the front of the
laminator while pressing the release button left. (fig. 5).
3
Clean the rollers as described in the cleaning section.
4
The laminator will be ready to use again within seconds.
NOTE: DO NOT LAMINATE AN EMPTY POUCH.
CAUTION: Be careful when removing the
laminated pouch from the machine. It may be hot.
Cleaning
WARNING: UNPLUG THIS PRODUCT
BEFORE CLEANING THE EXTERIOR.
WIPE EXTERIOR ONLY WITH A
DAMP CLOTH AND DO NOT USE
DETERGENTS OR SOLVENTS.
Adhesive may exit the pouch and stick to the rollers while
laminating or if a jam occurs. Regularly feed a cleaning card
or sheet of paper through the laminator to clean the rollers.
1
Run the cleaning card or sheet of paper through the
machine two or three times.
2
Turn off the machine when finished laminating and
cleaning.
Laminating Tips
• DO NOT LAMINATE AN EMPTY POUCH.
• Never insert the loose end of the pouch into the machine
first. This could cause the machine to jam.
• Before laminating important or unique documents, always
run a test pouch through the laminator using a similar type
of document.
• Do not attempt to do single sided lamination. This will
destroy the laminator.
• As soon as hot lamination is completed, remove the
lamination from the front of the machine and place on a cool
flat surface for cooling to prevent the pouch from curling.
• Do not block the vent slots, this will cause the laminator to
overheat.
• Do not cut pouches prior to lamination.
Certificate of Warranty
(For use in Singapore only)
Model :
Serial No. :
Validity : 1 year from date of purchase
IMPORTANT: Certificate of Warranty must be produced together with proof of
purchase (e.g. sales invoice, receipts, etc) when your equipment requires our
service. All services provided after warranty period will be chargeable.
Terms and conditions
ACCO Brands Asia hereby certify that all machines of whatever designs are free
from any defects in materials and in workmanship under normal use and service for
twelve (12) months from date of purchase. Should any defects occur within the
aforesaid period, ACCO Brands Asia shall at their absolute discretion, effect repairs
or replacement of any part of the said machine free of costs.
1. This warranty shall not be transferable, negotiable or assignable to any third
party.
2. This warranty shall be considered VOID under the following circumstances:
a. The serial number of the machine has been altered or removed.
b. The machine has been subjected to misuse, accident, and negligence.
c. The machine has not been installed, maintained or operated in
accordance with the instructions given in the instruction manual.
d. The machine has undergone repairs, adjustments or corrections made to
it by unauthorised person.
e. The machine has been dismantled by unauthorised person.
3. This warranty is applicable only in Singapore.
4. This warranty shall exclude all faults/defects caused by natural wear and tear.
5. This warranty shall exclude all other warranties & guarantees, expressed or
implied other than mentioned above.
6. No notices will be given on expiry of this warranty. ACCO Brands Asia reserves
the rights to amend or modify the terms and conditions of this warranty without
giving any prior notice.
No. 280316
CARRY-IN
WARRANTY
Ref: InspirePlus/SG/V1/280316
ACCO BRANDS ASIA PTE LTD
5A Toh Guan Road East
#06-03 Singapore 608830
Tel: +65 6776 0195
Fax: +65 6779 1041
singapore.webmaster@acco.com
Loading...