FUJIFILM FinePix 6900 TROUBLESHOOTING GUIDE
DIGITAL CAMERA
FinePix6900Zoom
TROUBLESHOOTING GUIDE
U/E/EG-Model
WARNING
THE COMPONENTS INDENTIFIED BY MARK IN THE PARTS LIST SHOULD
BE REPLACED ONLT BY THE COMPONENTS SPECIFIED IN THE P ARTS LIST.
RISK OF FIRE AND ELECTRIC SHOCK.
FUJI PHOTO FILM CO., LTD.
Ref.No.:ZM00369-400
Printed in Japan 2001.11(NT)
SAFETY CHECK-OUT
After correcting the original problem, perform the following
safety check before return the product to the costomer.
FinePix6900Zoom TROUBLESHOOTING GUIDE
1. Check the area of your repair for unsoldered or
poorly soldered connections. Check the entire board
surface for solder splasher and bridges.
2. Check the interboard wiring to ensure that no wires
are “pinched” or contact high-wattage resistors.
3. Look for unauthorized replacement parts, particularly transistors, that were installed during a previous repair. Point them out to the customer and recommend their replacement.
4. Look for parts which, though functioning, show obvious signs of deterioration. Point them out to the
customer and recommend their replacement.
5. Caution:
For continued protection against
2.5A 125/250V
2.5A 125/250V
RISK OF FIREREPLACE FUSE
AS MARKED
fire hazard, replace only with same
type 2.5 amperes 125/250 volts
fuse.
Attention:
Afin d’assurer une protection
permanente contre les risques
d’incendie, remplacer uniquement
par un fusible de meme, type 2.5
amperes, 125/250 volts.
6. Warning:
To reduce the electric shock, be
WARNING!
HIGH VOLTAGE
careful to touch the parts.
2
FinePix6900Zoom TROUBLESHOOTING GUIDE
Contents
1.POWER..................................................................................................................4
2.LENS ......................................................................................................................5
3.AUTO FOCUS ........................................................................................................ 5
4.IMAGE ....................................................................................................................5
5.CARD CONNECTOR ............................................................................................6
6.LCD.........................................................................................................................6
7.OPERATION ..........................................................................................................7
Page
3
Loading...