Franke FF3350, FFP3350 User Manual

STANDARD MAINTENANCE AND TROUBLESHOOTING
Replacing the Cartridge
1. Shut off the water supply to the faucet
2. Turn on the faucet briefly to relieve any pressure inside the faucet
3. Move the faucet handle to the “OFF” position
4. Remove set screw from handle using an allen key
5. Pull the lever handle H from the faucet body
6. Unscrew the cartridge cap G
7. Unscrew the cartridge nut F
8. Lift ceramic disk cartridge E from the body and replace it with new cartridge. Ensure the 2 lugs on the bottom of the cartridge sit properly in the locating holes in the faucet body.
9. Re-assemble faucet in reverse order
10. Test for leakage
General Maintenance
• Clean aerator periodically for any buildup
• Do not use harsh detergents, solvents, chemical agents, especially any containing CHLORINE, or metallic sponges as these can damage the surface finish
• Clean only with soft sponge and soapy water
ATTENTION! For outdoor installation product must be protected from freezing temperatures. Disconnect hot and cold supply hosesfrom home, open the handle to drain out all water.Cover faucet with protective covering to keep warm.
Spare/Replacement List
A. F3507 Spray Hose Assembly
B. F3303 Spray Head Assembly
C. F3305 Aerator and O-ring
D. F3306 Aerator Key
E. F206502 Cartridge
F. F3505 Cartridge Nut
G. F3504 Cartridge Cap
H. F3301 Handle Assembly
I. F3415 Fastening Set
J. F3508 Cold Supply Hose
K. F3507 Hot Supply Hose
L. F3510 Spray Supply Hose
M. F205514 Weight
B.
C.
E. F. G. H.
LIMITED LIFETIME WARRANTY
Franke Kitchen Systems, LLC (Franke) extends the following warranty to the original purchaser of its faucets effective January 1, 2003.
This warranty applies only to the original owner, providing the product has been installed in accordance with our installation instructions, used as recommended and in a normal residential application. In the event of a warranty claim, the owner will be required to provide proof of purchase - save sales receipt. This warranty covers all components which make the product operational. Franke, at its option, may repair or replace the product or components necessary to restore the product to good working condition. Franke reserves the right to inspect the installation prior to the actual replacement of the product or component part. This warranty does not cover misuse or abuse, accidental damages, scuffs or scratches, improper installation, abnormal usage, negligence or damage caused by improper maintenance or cleaning. Normal wear of parts is excluded from the warranty. Damage caused by impurities or acts beyond our control are not covered. Any product or part which has been repaired or altered in any manner outside of Franke’s factory, unless previously authorized in writing by Franke, will void warranty. Any replacement excludes transportation and any labor re-installation costs. This warranty does not allow recovery of incidental or consequential damages such as loss of use, delay, property damage or other consequential damage, and Franke accepts no liability for such damages.
The Franke warranty is limited to the above conditions and to the warranty period specified herein and is exclusive. Franke DISCLAIMS all other warranties, expressed or implied, including IMPLIED WARRANTIES OF MERCHANTABILITY AND/OR FITNESS FOR A PARTICULAR PURPOSE. This warranty gives you specific legal rights that may vary from state to state.
Further information
For any further information about our products, about the installation of them or about the guarantee, please contact the customer service department at:
INSTALLATION MANUAL
EOS
FF3350 Pull-Down Kitchen Faucet FFP3350 Pull-Down Prep Faucet
D.
I.
M.
A. L. K. J.
Franke Kitchen Systems, LLC Kitchen Systems Division 800 Aviation Parkway Smyrna, TN 37167 Phone: 1-800-626-5771 Fax: 1-888-685-0007 www.franke.us/ks.com
TECHNICAL DATA
INSTALLATION INSTRUCTIONS
• Flow rate –1.75 gpm at 60 psi
• Recommended water pressure – 30-85 psi
• Max water pressure – 115 psi
• Max water temperature – 158 oF
• Hole size for faucet – 1 3/8"
Note
Contact us immediately if you see inconsistencies:
• Phone: 1-800-626-5771
• Email: ks-customerservice.us@franke.com
• Website: www.franke.us/ks.com
Contents in Box
A. Faucet assembly B. Supply hoses C. Allen wrench D. Weight E. Aerator wrench F. O-ring G. Plastic flange H. Rubber and steel washer I. Fixing nut J. Spray hose
A.
1. Remove all contents from the package and check for completeness.
2. Turn off water supply.
3. Remove faucet (1) and hardware from its protective packaging – faucet comes assembled. Remove fixing hardware.
4. Cut mounting hole 1-3/8" in diameter (35mm) in the desired position (if one isn’t available).
5. Ensure rubber o-ring (2) is in the base of the faucet and install faucet into mounting hole – DO NOT use putty or other sealant at this location.
1
2
3
4
5
6
6. Install the mounting hardware to the base of the faucet body in the following order: Rubber washer (3), plastic flange (4), steel washer (5), and fixing nut (6). Tighten screws in fixing nut to secure faucet.
7. Connect spray hose (7) to the spray hose supply in the base of the faucet (9).
8. Attach the clip-on weight (8) to the spray hose approximately 2" above the bend in the bottom of the spray hose.
9. Connect the supply hoses (10 & 11) to the water supply in the home.
10. Remove the aerator using the aerator wrench, turn on the water and flush the faucet for any debris. Check for leaks, and reinstall the aerator.
F.
J.
7
9
B.
C.
D.
E.
G.
H.
I.
8
2"
10
11
Loading...