Page 1
Manual Supplement
Manual Title: 1587/1577 Users Supplement Issue: 3
Part Number: 2401027 Issue Date: 5/13
Print Date: April 2005 Page Count: 2
Revision/Date: 2, 6/09
This supplement contains information necessary to ensure the accuracy of the
above manual.
© 2010-2013 Fluke Corporation. All rights reserved.
Page 2
1587/1577 Users Manual Supplement
Change #1, 54524
On page 34, replace the Ohms Measurement table with the following:
Ohms Measurement
Range Resolution
600.0 0.1
6.000 k 0.001 k
60.00 k 0.01 k
600.0 k 0.1 K
6.000 M 0.001 M
50.0 M
[1] Accuracies apply from 0 to 100 % of range.
[2] Up to 80 % relative humidity.
[2]
0.01 M (1.5 % + 3) (2.0 % + 3)
Accuracy 1587 and 1587T
+(% of Rdg+Digits)
(0.9 % + 2) (1.2 % + 2)
Change #2, 63834, 65441
On page 3, add the following to the Symbols table:
CAT II
5/13 1
Conforms to relevant South Korean EMC Standards.
Measurement Category II is applicable to test and measuring circuits connected
directly to utilization points (socket outlets and similar points) of the low-voltage
MAINS installation.
[1]
Accuracy 1577
+(% of Rdg+Digits)
[1]
Page 3
Manual Supplement 1587/1577 Users
CAT III
CAT IV
Measurement Category III is applicable to test and measuring circuits connected to the
distribution part of the building’s low-voltage MAINS installation.
Measurement Category IV is applicable to test and measuring circuits connected at
the source of the building’s low-voltage MAINS installation.
On page 29, under General Specifications, remove the Shock, Electromagnetic Compatibility,
Safety, Certifications, IP Rating and add:
IP Rating .................................................... IEC 60529: IP40
Safety ......................................................... IEC 61010-1: 600 V CAT IV / 1000 V CAT III, Pollution Degree 2
Electromagnetic Environment ................. IEC 61326-1: Portable
Electromagnetic Compatibility .................. In an RF field of 3 V/m, accuracy = specified accuracy except in temperature accuracy =
specified accuracy ±5 °C (9 °F).
Applies to use in Korea only. Class A Equipment (Industrial Broadcasting &
Communication Equipment)
[1] This product meets requirements for industrial (Class A) electromagnetic wave
equipment and the seller or user should take notice of it. This equipment is intended
for use in business environments and is not to be used in homes.
[1]
2 5/13
Loading...