Fisher & Paykel DW60FC2W1, DW60FC2X1, DW60FC4W1, DW60FC4X1 Installation Guide
INSTALLATION INSTRUCTIONS
Dishwasher
DW60
models
NZ AU
www.fi sherpaykel.com
591217A 11.16
1 SAFETY AND WARNINGS
!
WARNING!
Electrical shock hazard
Before installing the dishwasher, remove the house fuse or open the circuit
breaker.
This appliance must be earthed. In the event of a malfunction or breakdown,
earthing will reduce the risk of electric shock by providing a path of least
resistance for electric current. This appliance is equipped with a cord having
an equipment-earthing conductor and an earthing plug. The plug must be
plugged into an appropriate outlet that is installed and earthed in accordance
with all local codes and ordinances.
WARNING- Improper connection of the equipment-earthing conductor can
result in a risk of electric shock. Check with a qualified electrician or service
representative if you are in doubt as to whether the appliance is properly
earthed.
Do not modify the power supply plug provided with the appliance - if it will
not fit the outlet, have a proper outlet installed by a qualified electrician. Do
not use an extension cord, adapter plug or multiple outlet box.
Failure to follow this advice may result in electrical shock or death.
!
WARNING!
Cut Hazard
Take care - panel edges are sharp.
Failure to use caution could result in injury or cuts.
IMPORTANT SAFETY INSTRUCTIONS
●
Installation of this dishwasher requires basic mechanical and electrical skills.
●
Be sure to leave these Instructions with the Customer.
●
Installation must comply with your local building and electricity regulations.
●
At the completion of the dishwasher installation, the Installer must perform the Final
Checklist.
●
Remove all packaging materials supplied with the dishwasher.
●
This dishwasher is manufactured for indoor use only.
●
Ensure all water connections are turned OFF. It is the responsibility of the plumber and
electrician to ensure that each installation complies with all Codes and Regulations.
●
The dishwasher MUST be installed to allow for future removal from the enclosure if service
is required.
●
The switched power outlet must be outside the dishwasher cavity, so that it is accessible
after installation.
●
Care should be taken when the appliance is installed or removed to reduce the likelihood
of damage to the power supply cord and hoses.
IMPORTANT SAFETY INSTRUCTIONS
●
If the dishwasher is to be relocated from one installation to another it must be kept
upright to avoid damage from water spillage.
●
Make sure only new hoses are used for connection (supplied with the dishwasher). Old
hoses should not be reused.
●
Failure to install the dishwasher correctly could invalidate any warranty or liability claims.
●
If the power supply cord is damaged, it must be replaced by a dealer or Authorised
Repairer or a similar qualified trades person in order to avoid a hazard.
●
Ensure the dishwasher is placed between cabinetry. Failure to do so may result in an
unstable product, which may cause damage or injury.
●
Do not operate this appliance if it is damaged, malfunctioning, partially disassembled or
has missing or broken parts, including a damaged power supply cord or plug.
●
Do not store or use petrol, or other flammable vapours and liquids in the vicinity of the
dishwasher.
●
Connect to a properly rated, protected and sized power supply circuit to avoid electrical
overload.
●
Make sure that the power supply cord is located so that it will not be stepped on, tripped
over or otherwise subject to damage or stress.
●
Do not install or store the dishwasher where it will be exposed to temperatures below
freezing or exposed to weather.
●
Do not use an extension cord or a portable electrical outlet device (e.g. multi-socket
outlet box) to connect the dishwasher to the power supply.
●
This appliance must be earthed. In the event of a malfunction or breakdown, earthing
will reduce the risk of electric shock by providing a path of least resistance for electric
current.
●
This appliance is equipped with a cord having an equipment-earthing conductor and a
earthing plug. The plug must be plugged into an appropriate outlet that is installed and
earthed in accordance with all local codes and ordinances.
●
EARTHING INSTRUCTIONS - This appliance must be connected to a earthed metal,
permanent wiring system, or an equipment-earthing conductor must be run with the
circuit conductors and connected to the equipment-earthing terminal or lead on the
appliance.
IMPORTANT!
SAVE THESE INSTRUCTIONS
The models shown in this installation guide may not be available in all markets and are subject to change at any time. For current details about model and specification availability in your country, please go to our
website www.fisherpaykel.com or contact your local Fisher & Paykel dealer.
1
Drain hose
support (1)
2 PARTS SUPPLIED 3 TECHNICAL DATA
Technical data
Check the electrical data on the rating label (located on the left-hand side of the
dishwasher’s stainless steel inner door). Should the data on the rating label be different
to those specified below, consider those on the rating label as correct.
DW60FC2
DW60FC4
DW60FC6 models
0.03-1 MPa
(= 0.3-10 bar)
DW60FC2W1 DW60FC4W1
DW60FC6W1
DW60FC2X1 DW60FC4X1
DW60FC6X1
Inlet hose (1)
Rubber washer
for inlet hose (2)
(comes already
fitted)
DW60FC1 models
Capacity 14 place settings 15 place settings
Mains water
pressure
0.03-1 MPa
(= 0.3-10 bar)
Power voltage 220-240 V (50 Hz) 220-240 V (50Hz)
Maximum current
10 A 10 A
intensity
Total absorbed
1900-2050 W 1720-2050 W
power
Colour
White
DW60FC1W1
Stainless Steel
DW60FC1X1
Installation and
Anti-flood protection
User Instructions
This dishwasher has anti-flood protection, which will stop the water flowing in the event
of a leak within the machine.
4 PRIOR TO INSTALLATION
Unpacking and handling
●
Check packaging and dishwasher for signs of transport damage. If the dishwasher is in any way damaged, do not install it. Contact the dealer the dishwasher was purchased from.
●
Disposal of packaging: some of the packaging is recyclable. Check the symbols and labels and recycle if possible.
●
Never lift the dishwasher from the door handle or the top panel. Doing so may cause damage.
●
Always be careful with the hoses and power cord at the back of the dishwasher. Careful handling will prevent damage and malfunction from squashing, kinking or cuts.
●
While installing the dishwasher, check the drain hose is not restricted or kinked.
Connections and services
●
Check that the power cord is long enough to reach the outlet. If it isn’t, it must be replaced by a Fisher & Paykel authorised technician. Extension cords or multi-outlet power boards should not
be used to connect the dishwasher to the power supply.
●
Check that the hoses are long enough to reach the services. If a hose needs extending, ensure that the extension hose is new and of equal quality and diameter to the one already fitted. Note:
the drain hose should not be longer than 4 m, as a longer drain hose will cause reduced performance.
●
The dishwasher should not be connected to a water system where the temperature exceeds 60oC, or where there is no temperature control, e.g. wetback system, unless the system is fitted with a
suitable tempering valve.
●
The dishwasher must not be connected to an undersink high-pressure “push-through” type hot water system, as damage to the system will result.
2
5 PRODUCT DIMENSIONS
Top panel (removable)
PLAN
B
A
C
PROFILE
PRODUCT DIMENSIONS MM
Overall height of product
A
with top panel in place
with top panel removed*
Overall width of product 597
B
Overall depth of product 600
C
Depth of open door (measured from front of kickstrip) 595
D
CABINETRY DIMENSIONS MM
Inside height of cavity
E
with top panel in place
with top panel removed*
Minimum inside width of cavity 600
F
Minimum inside depth of cavity 605
G
* The top panel may be removed to suit underbench cavity height. See instructions opposite.
**Depending on feet height adjustment.
850 - 870**
820 - 840**
855 - 875**
825 - 845**
C
F
FRONT
E
G
D
ISO
3
Loading...