Fisher & Paykel DD60SCX9 User Manual

QUICK START GUIDE

DishDrawer

NZ AU US CA GB IE

Keep this document handy for easy reference.

●

For detailed information on the features of your dishwasher, see your ‘User guide’.

●

Before using your dishwasher, make sure you read the full ‘User guide’, with special attention to the ‘Safety and warnings’ section.

●

For contact information or if you require service, assistance or replacement parts, see the end of this document or your ‘Service & warranty’ booklet.

dishwasher

YOUR MODEL

Double models

DD60DCW9 DD60DCX9 DD60DCHW9 DD60DCHB9 DD60DCHX9 DD24DCTW9 DD24DCTB9 DD24DCTXP DD24DCTHX9

Note: each drawer can run independently of the other drawer.

Single models

DD60SCTW9 DD60SCTX9 DD60SCW9 DD60SCX9 DD60SCTHX9 DD24SCTW9 DD24SCTB9 DD24SCTX9 DD24SCTHX9

OPERATING INSTRUCTIONS - STARTING A WASH

Rotating Spray arm

Discard scraps

Scrape large food particles off (e.g. bones, fruit stones) and remove any foreign objects (e.g. toothpicks, strings, paper).

Load dishes carefully

To help with wash performance, arrange dishes so they are evenly spaced and not nesting.

Check spray arm(s) are mounted correctly and can rotate fully around

Check the spray arm is mounted correctly by physically rotating it around with your hand.

Before a wash, ensure there are no items blocking the spray arm(s) from rotating.

Powdered Detergent

Rinse aid

Tablet or Gel Pouch

Add detergent

Fill the detergent dispenser (A) with powdered detergent and close the dispenser door.

IMPORTANT!

Do not place liquid detergent or tablets in the detergent dispenser.

If using a tablet or gel pouch, place it in the cutlery basket (B) or at the bottom of the drawer.

Check rinse aid

If the indicator on its plug (C) glows bright red, refill the rinse aid dispenser (D) with liquid rinse aid. Make sure you then refit the rinse aid plug back into its original position, by rotating the plug back

into an upright position.

Select wash

Power the dishwasher on then select wash program .

Start wash or set Delay start

To start wash: Close the drawer and press

To set delay start: Press and hold to enter delay start, then press and hold again to increase the delay start time.

CONTROLS AND DISPLAY

Single models

Double models

Controls Description

Off/On

Opening the drawer will automatically turn the dishwasher on.

Single models:

Press

to turn the dishdrawer on or off.

Double models:

●

Press to turn the dishdrawer on.

●

Press and hold to turn the dishdrawer off.

Drawer selector (Double models only)

Press to scroll between drawers.

Wash selector

Press to scroll through wash program options.

Wash modifiers selector

Press

to scroll through the wash modifier options. Note: Not all modifiers are available for all wash programs.

WASH PROGRAMS

Double models interface shown

Wash program indicators

These show which program is selected.

Wash program modifiers (optional)

These show which wash modifier is selected (see ‘Setting wash modifiers’ in your User guide).

KKL

Start / Delay Start

Press

to start the wash.

To pause:

Press again. The wash stage indicator

and (Double

models) will flash.

●

Wait for the 3 short and one long tone before opening the drawer. Forcing it open mid cycle may cause damage or injury.

●

If the drawer is not restarted within 7 minutes it will tone intermittently until it is restarted.

To Delay start

1 Press and hold until appears

on the display, then release. You are now in Delay start mode.

2 Press until the display shows the

number of hours you want to delay the start of a wash by (1 to 12 hours).

●

Note: If you scroll past 12 hours the dishwasher will exit Delay start mode. To re-enter delay start follow step 1 above.

●

The wash will start once the delay time is over, provided the drawer is closed.

DD24 models only

If the drawer is opened after delay start has been set (for example if you need to load more dishes), delay start will be paused after the drawer is closed.

To restart delay start:

Close the drawer.

●

Single models: will flash.

●

Double models: and will flash.

●

Press to resume.

Cancel wash / Cancel Delay start

Single models:

Press to cancel a wash that has already started or to cancel the Delay start setting.

Double models:

Press and hold to cancel a wash that has already started or to cancel the delay start setting.

●

If there is any water in the drawer, it will automatically drain before the dishwasher turns off.

PROGRAM DESCRIPTION

Heavy Heavily soiled pots, pans and dishes.

Normal

(default setting)

Dishes that are quite heavily soiled or food soils that have been left to dry overnight.

Normal Eco Normally soiled dishes for optimum water and energy

usage. The US/Canada Energy Guide is based on this cycle.

Fast Lightly soiled dishes.

Delicate Lightly soiled and heat sensitive crockery.

Rinse Prevents odours and soils from drying on dishes.

Keylock

Keylock disables all the buttons – helpful when cleaning the dishwasher. To activate: press and hold and

together until you hear one tone. The keylock indicator will come on. To cancel: press and hold and

together until you hear another tone and the keylock indicator stops flashing and goes out

Childlock

Childlock disables all the buttons and locks the drawer closed, preventing unauthorized use by children. To activate: press and hold and

together until you hear a second tone. The keylock indicator will come on. To cancel: press and hold and

together until you hear another tone and the keylock indicator stops flashing and goes out.

Wash program indicators

These show which program is selected.

Drawer indicator (Double models only)

White: drawer is running and selected. Dim: drawer is running but not

selected. Flashing: drawer is paused

Display

●

Time remaining (minutes)

●

Fault code numbers (see ‘If there is a fault’ in User guide).

Wash stage indicators

(See ‘During and after the wash cycle’).

Keylock/Childlock indicator

If lit: keylock or childlock is activated.

Delayed start indicator

If lit: delayed start is set.

Salt indicator

(Water softener models only) If lit: salt reservoir is empty.

Wash modifiers indictors

If lit: wash modifier is selected.

continued >

DURING AND AFTER THE WASH

PREFERENCE OPTIONS

As the wash progresses, the display will count down the minutes remaining and show what stage the program is at. When the program has finished, the display will show 0 and the dishwasher will sound a tone. After 30 seconds the display will go out.

You may notice the following noises at the end of the wash. These are all part of normal operation:

●

Both drawers may be draining simultaneously.

●

The drying fan may continue to run after a wash program has finished for a set time or until the drawer is opened. The fan assists with drying and uses negligible amounts of energy.

For best drying results, we recommend unloading the dishes once they have cooled.

DOS AND DON’TS OF LOADING

Sharp or pointed items must be placed horizontally or with sharp edges/points facing down to avoid risk of injury.

Protruding items will stop the internal lid of the dishwasher from sealing properly, which could result in a service call.

You can change the setting of these options to suit your preferences or circumstances. We recommend selecting the most suitable settings before you start using your dishwasher.

OPTION RINSE AID

What does it do?

How to change the setting of an option

1 CHECK

Check that there is no wash underway, press

2 ENTER MENU & SCROLL TO OPTION

To enter the menu: Press and hold the and together for four seconds.

●

To scroll to the next option: press . To know which option you’re in, watch the letters in the display (see table below). When you have scrolled to the end of the sequence, the menu will start again with Rinse aid.

Regulates the amount of rinse aid dispensed. Reduce this setting if there is excess foam after a wash. Increase this setting if dishes are wet or streaky after a wash.

You are now in the Rinse aid option of the preference options menu. If you want to change the Rinse aid setting, go to step 3 now. If you want to change the setting of another option, you will need to scroll to that option first.

WATER SOFTENER

(SOME MODELS ONLY)

Refer to the ‘Water softener’ section of the ‘User guide’ for details.

OPEN DRAWER AUTO POWER-ON

Your dishwasher is factory-set to automatically power on for 30 seconds whenever you open the drawer. You can turn this setting off.

TURN TONES OFF

This turns all tones off except for fault alerts.

CLOSED DRAWER AUTOLOCK

When this setting is on, the drawer will automatically lock 30 seconds after it’s closed. It can then be unlocked by pressing Keylock or Childlock is also activated). Useful in boats or motor homes.

(unless

A neatly arranged load with evenly spaced dishes helps wash performance.

Ensure there is enough space between plates. Mix spoons, knives and forks within the cutlery basket to prevent them from nesting.

Overcrowding reduces wash performance.

If plates and cutlery are nesting, they are less likely to be cleaned well.

OPTION RINSE AID

Which option am I in?

Possible settings

Example setting is 1

Off to Max (rA5) Off to Max (Hd5) On or Off On or Off On or Off

WATER SOFTENER

(SOME MODELS ONLY)

HD AP BP LD

setting is 1

OPEN DRAWER AUTO POWER-ON

TONES AT END OF WASH

CLOSED DRAWER AUTOLOCK

RA1 HD1 APo BPo LDo

setting is 4

3 CHANGE SETTING

Press to change the setting within an option. For example, to change the Rinse aid setting from 4 (factory default) to 2, you need to press 3 times.

4 SAVE SETTING & QUIT MENU

Press . This will save the new setting and quit the preference options menu.

RA4 HD4 AP- BP- LD-

FOR MORE INFORMATION

For detailed information on the features of your dishwasher

setting is 4

see your ‘User guide’

Off

Ensure that water reaches all items on the racks.

Dishware is blocking water from reaching items on the racks.

For warranty information

If you…

●

have any questions or comments

●

need a Fisher & Paykel authorized technician to service your product

●

need replacement parts or accessories

●

want to register your product

see your ‘Service and warranty’ booklet

see your ‘Service and warranty’ booklet or contact us via our website:

www.fisherpaykel.com

591218A 07.16