Fender Bassman 410 Pro SL Owner's Manual

Your new Bassman®410 Pro SL Bass Loudspeaker Enclosure is constructed from 3/4” (1.9 cm) 7-ply Birch Maple Plywood and is capable of handling 300 watts of continuous power. The Bassman®410 Pro SL features four 10” (25.4cm) speakers with 44 oz (1.25 kg) magnets and is designed for use with a Fender®Bassman®1200, Bassman®300, Bassman®400 Head or other professional quality bass amplifier. Please read these instructions and the instructions that accompanied your amplifier before making connections. Follow all equipment caution and safety labeling.

SPEAKER AND AMPLIFIER CONNECTIONS

Use 16 gauge (or heavier) speaker cable with standard 1/4” plugs to make connections. You may also connect to your Bassman 410 Pro SL with a dual “banana” plug or stripped wires using the red and black binding posts. Multiple 410 Pro SL cabinets can be linked as illustrated, when additional output is needed. Note: Follow the speaker impedance load guidelines set

by the manufacturer of your amplifier to avoid damage to your equipment.

HORN TWEETER

The horn tweeter is protected from power-overload damage by an incandescent lamp. If the horn tweeter stops responding, replace the lamp as you would a blown fuse. The lamp and a spare (reorder P/N 051857) are located on the circuit board on the inside of the input jack panel.

Lamp Replacement:

1) Remove the 4 screws from the input jack panel corners.

2) Pull the panel out, then up.

3) Use a small flathead screwdriver to remove the blown lamp which is visible through a cutout in the circuit board.

4) Remove the spare lamp stowed on the side of the circuit board and install it where the blown lamp was located.

5) Install the input jack plate in the reverse order of removal.

SPECIFICATIONS

PART NUMBER: 2217000000

DRIVERS: Four 10“ (25.4 cm) Fender Special Design

Cast Frame Woofers 2” (5.1 cm) voice coil, 44 oz (1.25 kg) magnet

One Horn Tweeter 1” (2.5 cm) voice coil, 8 oz (0.23 kg) magnet

CABINET: 3/4” (1.9 cm) 7-ply Birch Maple Plywood

SENSITIVITY: 94 dB, 1 Watt - 1 Meter

POWER HANDLING: 300 Watts, Continuous

600 Watts, Program

IMPEDANCE:8Ω

CONNECTIONS: Dual, Parallel Wired, 1/4” High Current Input Jacks

and Binding Posts

ENCLOSURE VOLUME: VB = 4.4 ft

(125 l)

DIMENSIONS:

Height: 25.5 in (64.8 cm)

Width: 25.5 in (64.8 cm)

Depth: 18.5 in (47.0 cm)

WEIGHT: 78 lb (35.5 kg)

Product specifications are subject to change without notice.

A PRODUCT OF:

FENDER MUSICAL INSTRUMENTS CORP.

CORONA, CA USA

Bassman®and Fender®are registered trademarks of FMIC

P/N 057981 REV B

THE FENDER®BASSMAN®410 PRO SL LOUDSPEAKER ENCLOSURE