Fellowes KATAEX1-DC-FM-BLK, KATAEX1-GM-FM, KATAEX1-DC-FM-SLV, KATAEX1-GM-FM-BLK, KATAEX1-GM-FM-SLV Installation Instructions Manual
...
Kata™EX-FM
installation instructions
single xed+motion monitor arm
Model# KATAEX1-DC-FM-___
Model# KATAEX1-GM-FM-___
___ = SLV, BLK or WHT
KataEX-FM Components and tools
Caution
• Hand tighten screws only. Do not use power tools.
Please review these instructions before beginning the installation. Use the illustrations below to check that all the components needed for your
installation were provided with your order. Do not discard the packaging until the product works to your satisfaction.
Components and tools
monitor arm assembly (1)
VESA plate screws (4)
M4x10
clamp or grommet mounting:
set screws (3)
M4x15
decorative covers (set of 4)cable clip (1) cable clip (1)
connection
sleeve (1)
dual Allen key (1)
2mm and 4mm
clamp mounting only:
base
cover (1)
clamp base
assembly (1)
grommet mounting only:
base
cover (1)
grommet base
assembly (1)
Additional tools required
• Phillips screwdriver
grommet bar (1)
grommet knob (1)
Page 2
KataEX-FM Assembly
Follow either step #1a for clamp mounting or step #1b for grommet mounting. All other steps apply to both mounting methods.
Step #1a: attach base assembly to worksurface — clamp mounting
The thickness of the worksurface must be between 0.5" and 2.1". To mount the clamp flush against
the worksurface, the thickness must be no more than 1.5".
• Loosen the clamp suciently to be able to slide it easily onto the worksurface.
• Clamp the assembly to the worksurface in the desired position. Be sure to tighten the clamp securely.
• Place the base cover onto the mounting post and fit the cover over the base.
fit base cover
over base
flush
against
clamp
clamp to
worksurface
0.5" – 2.1"
gap
0.5" – 1.5"
Step #1b: attach base assembly to worksurface — grommet mounting
Maximum thickness of the worksurface for grommet mounting is 1.7".
• Place the base assembly over the grommet hole with the bolt centered.
• Insert the grommet bar onto the grommet bolt and then screw on the grommet knob. Tighten the grommet knob securely to hold the base assembly in position.
• Place the base cover onto the mounting post and fit the cover over the base.
fit base cover
over base
grommet base assembly
center bolt in grommet hole
maximum thickness = 1.7"
grommet bar
tighten grommet knob to secure
Page 3
Loading...