Esotec 102154 Operating Manual

Using Instructions

These instructions relate ONLY to this product and contain important
information for using the product for the first time. Please keep these
instructions for later reference and should always accompany the
product in the event of transference to a new user.

GB

1. Introduction

Dear Costumer,
Thank you for purchasing the solar light. With this solar light you purcha­sed a product manufactured according to the current state of technology.

This product fulfils all requirements of the valid European and natio­nal regulations. The conformity was proved. The relevant declarati­ons and documentation are deposited with the manufacturer.

To maintain this state and guarantee a safe operation, you as the user will
have to follow this operating manual!

2. Safety Instructions

.

1

2.

5. Battery replacement

Battery capacity will be lower after one or two years requiring replace­ment. The battery is available from the manufacturer and other suppliers.
Only batteries of identical design must be used.

- In case of damages caused by not
following this operating manual, the
warranty rights will expire! We exclude

!

- In these cases any guarantee rights will expire.

Due to safety and admission reasons (CE) it is not allowed to arbitrarily
reconstruct and/or change the solar light.
Therefore, please keep to the operating manual.
The accident prevention rules of the association of the industrial trade
cooperative association for electric plants and working material are to be
considered in industrial environments.

liability for any consequential damages!

- We exclude liability for property or
personal damages caused by inappropriate
handling or not following the safety instructions.

3. Intended use

The LED lights will automatically switch on in the dark and switch off at
daybreak. The maximum illumination time is about 10 hours with a full
battery without re-charging. The solar module integrated into the upper
part of the assembly recharges the integrated battery. The LED lights can
be switched on and off with a switch. The lights are intended for exterior
use. The LEDs must not be submerged into water (ponds, etc.).

Note: The solar module oriented towards the South and exposed to the
sun without shade, if possible. The product cannot be used when expo­sed to the North. In wintertime, care should be taken to keep the module
free from snow.

4. Operation

Carefully remove the parts from the packaging and lay the LED lights

1.
as a line. The lights must not be permanently submerged into water
(ponds, etc.). However, they are intended for exterior use and insensi­tive to rain or snow

3. Switch the slide switch on the bottom of the assembly into the ”ON”
position. The LED lights are now switched on.

Note: In the “OFF” position, the LED lights are switched of
ry will not be recharged in this position.

4. Stick the assembly into the ground or flowerpot using the ground

The solar LED lights are
activated now.

Note: The maximum illumination
time in wintertime is normally
somewhat reduced. Should the solar lights not illuminate in the first eve
ning, wait for a sunny day.

spear

.

.

f; the batte

-

1. Remove the lower part of the assembly (Figure 1).

2. Remove the battery from the support.

3. Insert the new battery ensuring proper polarity. Close the assembly.

Note: Used batteries should be disposed of environmentally friendly, i.e.
not as a part of domestic waste. Return them to the supplier, who is obli­gated by law to take them back.

6. Malfunctions

- Lamp is not automatically switched on at darkness

- An outside light source (e.g. streetlight) simulates daylight and pre­vents the lamp from switching on. Place the lamp at a darker location.

Lamp is not switched on at darkness or only for a short period of

­time.

- Is the lamp connected?

- Accumulator weak or defective. Exchange of the accumulators.

7. Specifications

- Operating voltage: 1.2 V

- Battery: NiMh 1.2 V/600 mAh

- Illuminating units: white LEDs

- Illumination time: max. 10 h with a full battery

Battery take-back

- Batteries must not be discarded into domestic
waste.

- The consumer is legally required to return batteries
after use, e.g. to public collecting centers or to batte­ry distributors.

- Contaminant-containing batteries are labeled with
the sign “crossed-out trashcan“ and one of the che
mical symbols Cd (= battery contains cadmium), Hg
(= battery contains mercury), Pb (= battery contains
lead). Used batteries should be disposed environmentally friendly and
should not be discarded into domestic waste. Your dealer is legally
required to take back old batteries.

Manufacturer/Importer:

esotec GmbH, Etzenrichterstr. 14, D-92729 Weiherhammer

el.-Nr: 09605-92206-28, Fax.-Nr: 09605-92206-10,

T
e-mail:[e-mail]
Internet:www.esotec.de

-

Product Art.-Nr: 102154

-

Disposal:

Dear customer,
please cooperate in avoiding waste. When you intend to dispose of the
product in future, please consider that it contains valuable raw materials
suited for recycling.
Therefore, do not dispose it of with domestic waste but bring it to a col
lection point for the recycling of waste electrical and electronic equip­ment.
Thank you very much for your cooperation!

Copyright, Änderungen vorbehalten!

NiMh

-