Esotec 102090 Operating Manual

olar LED Lighting System

S

G

B

Customer support:

f you have problems or questions regarding this product, simply contact us!

I

onday to Friday 8 am to 12 noon and 1 pm to 4 pm.

M

By phone: [phone]
By e-mail for ordering spare parts: [e-mail]

y e-mail for questions about the product: [e-mail]

B

roduct: Manufacturer Item No.: 102090

P

These instructions relate ONLY to this product and contain important information for

sing the product for the first time. Please keep these instructions for later reference

u
and should always accompany the product in the event of transference to a new user.

1. Introduction

ear Costumer,

D

hank you for purchasing the solar light. With this solar light you purchased a product

T
manufactured according to the current state of technology.

his product fulfils all requirements of the valid European and national regula-

T

ions. The conformity was proved. The relevant declarations and documentati-

t

n are deposited with the manufacturer.

o

To maintain this state and guarantee a safe operation, you as the user will have to fol-

ow this operating manual!

l

2. Safety Instructions

In case of damages caused by not

­ollowing this operating manual, the

f

arranty rights will expire! We exclude

w
liability for any consequential damages!
We exclude liability for property or

!

- In these cases any guarantee rights will expire.

ue to safety and admission reasons (CE) it is not allowed to arbitrarily reconstruct

D
and/or change the solar light.

herefore, please keep to the operating manual.

T

he accident prevention rules of the association of the industrial trade cooperative

T

ssociation for electric plants and working material are to be considered in industrial

a
environments.

-

ersonal damages caused by inappropriate

p
handling or not following the safety instructions.

3. Intended Use

Universal LED-lighting system to be used in the garden, for leisure activities and
camping.
The LED-light is mounted inside a room (or tent) and the powerful solar module is
mounted within reach of the cable at a shadow-free, sunny place outside. The bat­teries inside the light are charged when the sun shines. Via a cord switch, the
lighting may be switched on in two levels.
The operating time of the LEDs amounts to up to 8 hours, depending on the switch
setting.

Note: Please make sure that the solar module is installed on a shadow-free south-,
east- or west side. The product cannot be used if installed on north sides, under
bushes or similar. In winter, the solar module shall always be free of snow.

4. Initiation

1. Please carefully take all parts out of the package.

2. Install the light on a wall using the enclosed screws (insert the screws in the
slots on the back of the light). Please make sure that you are always able to
safely and comfortably reach the cord switch.

3. Now, mount the solar module within reach of the cable on a wall, floor, pole, bar
or similar.

Note: Please make sure that the solar module is installed on a shadow-free south-,
east- or west side. The product cannot be used if installed on north sides, under
trees or similar. In winter, the solar module shall always be free of snow.

4. Now, connect the cable on the solar module with the light and insert the plug
into the socket of the light. The charge control LED will flash if the solar module
is exposed to the sun.

5. Switch the toggle switch (main switch) on the light to the position “I”.
The light is activated!

6. The light may now be operated in two levels. This is done via the cord switch.

Note: During the winter months the duration of illumination will generally be shorter.
If the lamp should not yet start working on the first evening, please wait for a sunny
day.

. Exchange of the rechargeable batteries

5

he capacity of the rechargeable batteries will diminish after two years and they will

T

ave to be exchanged. The ordinary rechargeable batteries are available at your

h
local retailer or from the manufacturer. The battery type used is the following:

ignon NiMh 1.2 V/ 1300 mAh.

M

. Switch the main switch on the light into the

1

position “O” and disconnect the socket from the
cable of the solar module.

. Take the light off the wall.

2

. Open the cover on the back side of the light by

3

unscrewing the two screws.

4. Remove all rechargeable batteries from the
racket.

b

. Re-insert the new rechargeable battery with

5

correct polarity and re-assemble the light in
reverse order.

ote: Used batteries or accumulators must be dis-

N

osed of in an environmentally sound manner.

p
They do not belong into the domestic waste. Your
dealer is legally obliged to take back.

6. Applications

obile Light

M

he enclosed cord allows a mobile use of the light.

T
For this purpose, simply fix the cord on the plastic

racket.

b

7. Technical Data

Solar module:

-

ower rating: 2 Wp

P
Protection class: IP 44

Light:

-

amps/illuminants: 10 pieces. 0.25 W LEDs

L
Operating voltage: 6 V DC
Rechargeable batteries: 5 pieces NiMh 1.2 V/1300 mAh (Mignon AA)

uration/battery life: max. 8 hours with 5 LEDs

D

Protection class: IP 20 – only for dry rooms (inside)

Battery take-back

- Batteries must not be discarded into domestic waste.

- The consumer is legally required to return batteries after
use, e.g. to public collecting centers or to battery distribu­tors.

- Contaminant-containing batteries are labeled with the sign
“crossed-out trashcan“ and one of the chemical symbols.
Used batteries should be disposed environmentally friend­ly and should not be discarded into domestic waste. Your
dealer is legally required to take back old batteries.

Rechargeable battery notes

- Rechargeable batteries should not be played with by children. Never leave rechar­geable batteries lying around; they could be swallowed by children or pets.

- Rechargeable batteries must never be short-circuited, disassembled or thrown into
fire. This leads to a danger of explosion!

- Leaking or damaged rechargeable batteries can cause chemical burns when they
come into contact with skin. For this reason, please make use of suitable protecti­ve gloves.

- Rechargeable batteries should only be replaced by structurally identical recharge­able batteries from the same manufacturer. Normal batteries must not be used
since these are not rechargeable.

- Make sure the rechargeable batteries are inserted with the correct polarity.

- For long periods of time of non-use (for example, storage), remove the inserted
rechargeable batteries to avoid damages via the leaking rechargeable batteries.

Manufacturer / Importer

esotec GmbH - Gewerbegebiet Weberschlag 9 - D-92729 Weiherhammer

Tel.-Nr: [phone] - Fax.-Nr: [phone] - Internet: www.esotec.de

Disposal:

Dear customer,
please cooperate in avoiding waste. When you intend to dispose of the product in
future, please consider that it contains valuable raw materials suited for recycling.
Therefore, do not dispose it of with domestic waste but bring it to a collection point
for the recycling of waste electrical and electronic equipment.
Thank you very much for your cooperation!

Copyright, esotec GmbH

max. 4 hours with 10 LEDs

NiMh

Pole/
post mounting

floor/wall
mounting

charge
control
LED

solar
module

main
switch

cord
switch