Eskimo HD08 User Manual
Instruction Sheet
Eskimo® Hand Augers
INCLUDES THE FOLLOWING MODELS:
HD06
HD07
HD08
BEFORE USING YOUR ICE AUGER REMEMBER:
1. Always leave your blade protector on when not using your Eskimo
hand auger. The blades are sharp and can cause injury if proper precautions are not taken.
2. Be extremely careful when using your auger in shallow waters, as a rocky
water bottom can damage your blades and the auger if they come in
contact.
3. Never try to adjust the cutting angles of your auger blades, especially by
bending them. The angles are specically engineered and critical to the
auger’s performance.
4. Always start a new ice hole instead of reopening an old one with your
ice auger. The sides of an old ice hole often freeze, shrinking the hole’s
diameter. This can cause your auger to jam. Using your ice auger in these
conditions can damage the auger and blades.
5. When using your ice auger, remember that the under-surface of ice is
often uneven. This can cause your auger to become jammed as you break
through the ice. If you nd yourself in this situation, do not force your
auger. Lift it approximately 1” and make several half turns, lowering the
drill 1/4” each turn until a clean hole is cut.
6. Never hit your auger on the ice when trying to start a hole, as this can
bend your auger and damage the blades. Lower your auger gently when
starting to drill.
ASSEMBLY
To assemble your Eskimo® hand auger, insert the pommel handlebar assembly into the auger weldment. The handle can be adjusted to three dierent
lengths (49”, 53.5” or 58”) by aligning the appropriate hole on the handle bar
with the hole in the auger weldment. To secure the handle in place, insert
the wing bolt and tighten.
SHARPENING
Sharp blades make cutting through ice easier. If your blades becomes dull, a
new set of blades can be ordered from Eskimo® . Contact customer service at
1-800-3145-6007 for more information. Replacement parts also can be found
by visiting our website at www.geteskimo.com.
PARTS BREAKDOWN AND REPLACEMENT PARTS
Pommel handle
bar assembly
Wing nut
Auger weldment
Blade Protector
(includes rubber
strap)
PART NO. DESCRIPTION
252V HAND AUGER HANDLE WITH POMMEL
1018V HAND AUGER HANDLE POMMEL
63285 WING BOLT, HAND AUGER
303A BLADE PROTECTOR FOR HD06
304 BLADE PROTECTOR FOR HD07 AND HD08
RB6 HAND AUGER BLADES 6”
RB7 HAND AUGER BLADES 7”
RB8 HAND AUGER BLADES 8”
HD08 shown with dual at blades
Auger blades
ONEYEAR LIMITED WARRANTY
Ardisam, Inc., warrants this Eskimo® Silvertip™ hand auger under a one-year limited warranty to be free from defects in materials or workmanship or both for a period not
exceeding twelve consecutive months from the date of original purchase by the rst retail consumer or commercial end user. “Consumer use” means personal recreational use
by a retail consumer. “Commercial use” or “commercial application” means all other uses, including use for commercial, income producing or rental purposes. Once a product has
experienced commercial use, it shall thereafter be considered as a commercial product for purposes of this warranty. This warranty applies to the original owner that provides a
proof of purchase. The warranty is not transferable. The warranty period begins on the date of purchase by the rst retail consumer or commercial end user, and continues for
the twelve month consecutive period thereafter. Any unit used in a commercial application is covered for a period of 90 days after purchase. For the warranty to be valid, the
product must be registered online at www.GetEskimo.com, or the warranty card must be lled out and received by Ardisam, Inc., within 30 days of purchase. Ardisam,
Inc. shall not be obligated to ship any repair or replacement product to any location outside of the United States of America or Canada.
*This warranty applies only to products which have not been subjected to negligent use, misuse, uses other than those indicated in the product’s owner’s manual, alteration,
accident, use of unauthorized parts, failure to perform periodic maintenance as specied in product’s owner’s manual, normal wear and tear, use of unauthorized
parts or repairs performed at non-authorized service centers. There is no other expressed warranty. Implied warranties, including those of merchantability and tness
for a particular purpose, are limited to one year from purchase, or to the extent permitted by law. All other implied warranties are excluded. Liability for incidental or
consequential damages are excluded to the extent exclusion is permitted by law. Ardisam, Inc. does not assume, and does not authorize any other person to assume
for us, any liability in connection with the sale of our products. To obtain warranty service, you must have prior approval by calling our customer service department
at 1-800-345-6007. If you choose to ship your product to Ardisam for warranty repair, you must rst have prior approval from Ardisam by calling our customer service
department for a return material authorization number (RMA#). Under these circumstances, all items must be shipped prepaid. Ardisam will at no charge, repair or
replace, at their discretion, any defective part which satises all conditions stated above. Ardisam retains the right to change models, specications and price without
notice. Ardisam, Inc. shall not be obligated to ship any repair or replacement product to any location outside of the United States of America or Canada.
Check for parts online at www.GetEskimo.com or call 800-345-6007 M-F 8-5 CT
ECN # 9828 Rev. 1 06/04/2013
© Copyright 2013 Ardisam, Inc.
All Rights Reserved.
15910
Loading...