QUICKLOOK
User Manual
Please read the
“Important Instructions for Use”
overleaf
Important Instructions for Use
• Use only the charger provided. Use of
another charger could result in
irreparable damage to Quicklook Zoom
and will void the warranty.
• Quicklook Zoom should be stored in the
“off” position when not in use.
• Do not use Quicklook Zoom in a
bathroom, near water or other damp
conditions.
• Do not open Quicklook - there are no
user serviceable parts inside and opening
it will invalidate your warranty.
• At the end of its life, Quicklook should be
disposed of responsibly in accordance
with local ordinances. Never dispose of
the unit by fire.
• If the display is cracked, liquid crystal
may leak. Do not allow the liquid into
your eyes or mouth and wash your hands
with soapy water.
Introduction
Congratulations on the purchase of your
new Quicklook Zoom magnifier. Quicklook
has been designed for simple and intuitive
use and will aid people with low vision to
read and write. However you should consult
with your eye care professional to determine
the suitability of this product in your
particular case. We recommend that you
read this manual carefully to obtain the best
service from your new product.
Contents of the Package
Quicklook Zoom is supplied with the
following items:
o Main unit with integrated display, camera
& battery
o Protective pouch
o Wrist strap
o Charger with power lead
Charging the battery
Quicklook Zoom is supplied with the battery
partially charged, we recommend that you
charge it for three hours or until the red
charge indicator is extinguished.
Plug the power supply into a wall socket and
insert the connector into Quicklook as
shown in the diagram.
The red light beside the power connector
should illuminate indicating that the battery
is being charged. The light will go off when
the battery is substantially charged. It
takes about three hours to charge the
battery from a discharged state. Additional
charging will not cause any damage to the
unit. Quicklook Zoom can be used while the
battery is being charged.
Charge input
and indicator
Freeze /
Brightness
button
Operation
The Quicklook Zoom is powered on by
rotating the camera to either of its operating
positions. It is powered off by rotating the
camera back to the closed position.
Reading
Rotate the camera
ninety degrees to its
first click position so
that the camera is
looking downwards.
Place the unit on or
slightly above the
item you wish to
read. You will have
to position the camera directly over the
area of interest. In this respect Quicklook
Zoom differs from a magnifying glass in that
the image you see does not correspond to
the area directly beneath.
Quicklook Zoom can be viewed from any
orientation, but to obtain the most accurate
colour reproduction you should ideally look
directly down on the screen.