Epson Stylus Photo Quick Setup Guide

Quick Setup

Here’s how to set up your new EPSON® Stylus Photo
printer . . .

Unpack the Printer

Remove any packing material from the printer, as described on
the Notice Sheet in the box. Save all the packaging so you can
use it if you need to transport the printer later. You’ll find these
items inside:

black ink
cartridge

○○○○○○

paper
support

○○○○○○

○○○○○○○

color ink
cartridge

Place the printer flat on a stable desk near a grounded outlet.
Leave plenty of room in back for the cables and enough room
in front for opening the output tray.

Do NOT put the printer:

◗ In an area with high temperature or humidity
◗ In direct sunlight or dusty conditions
◗ Near sources of heat or electromagnetic interference, such

as loudspeakers or cordless telephone base units.

Also, be sure to follow the Safety Instructions in the
Introduction of your User’s Guide.

4007082

Attach the Paper Support

Insert the paper support in the top slot on the back of the
printer.

Plug In the Printer

First make sure the power is off.

Caution:

Do not plug the printer
into an outlet
controlled by a wall
switch or timer, or on
the same circuit as a
large appliance. This
may disrupt the power,
which can erase
memory and damage
the power supply.

power

○○○○○○○○○○○○○○○○

Plug the power cord into a properly grounded outlet.

Install the Ink Cartridges

1. Lower the output tray and raise the printer cover.

2. Press the power button to turn on the printer. The power
light flashes, the and ink out lights come on, and the ink
cartridge holders move to the installation position.

3. Pull up the two ink cartridge clamps.

Caution:

You must remove the
tape seal from the top
of the cartridge or you
will permanently
damage it. Don’t
remove the tape seal
from the bottom or ink
will leak.

4. Open the ink cartridge packages. Remove the disposable

yellow portion of the tape seal on top.

black ink
cartridge

○○○

○○○○

color ink
cartridge