Epson ELP-3300 User Manual

Electrical

EPSON ELP-3300 Data/Video Projector

Data/Video Specifications

General

Type of display

Size of liquid crystal panels

Resolution Image size Projection

distance

Poly-silicon Thin Film Transistor (TFT) Active Matrix LCD

1.32 inches (33.6 mm)

640 (horizontal) x 480 (vertical) pixels 21 to 300 inches (.5 to 7 meters) 4 to 41 feet (1.2 to 12.4 meters)

Voltage

Rated frequency 50/60 Hz Fuse type Power

consumption

Environmental

Temperature

Humidity

Supported Monitor Displays

The projector displays images at a resolution of 640 x 480 pixels. When displaying a higher resolution image, the

projector compresses it to 640 x 480. The following table lists the display formats supported by the projector.

l00-120VAC and 220-240VAC ± 10%

25OV, 6.3AT, 5 x 20 mm

220W (50W in standby mode)

120VAC

100-

240VAC

220

Operation: 41° to 104° F (5° to 40° C) Storage: -4° to 140° F (-20° to 60° C)

Operation: 20 to 80% RH, non-condensing Storage: 10 to 90% RH, non-condensing

3.5

1.3

Amps, Amps,

50/60 50/60

Hz Hz

Remote control range

Audio Amp power

Optical

Aspect ratio Zoom ratio

Projector Lamp

Model number Type

Life

Power Brightness

Dimensions

Height Width

Depth

Weight

33 feet (10 meters)

1W X 1W stereo

4 x 3 (horizontal x vertical) 1:1.4

MSCR150E3H Metal halide Typically 600 hours (w/ 50% minimum

illumination) 150W 330 ANSI lumens typical

5.9 inches (14.9 cm)

11.2 inches (28.5 cm)

16.3 inches (41.3 cm)

16.98 1bs (7.7 kg)

Projector Placement Guidelines

The distance between the projector and the screen determines the actual image size. Use the following general guidelines to determine the proper distance.

4/96

ELP-3300 - 1

EPSON ELP-3300 Data/Video Projector

Status Lights

The status lights at the top of the projector monitor its operation.

temperature light 1power light

lamp light

VGA and Monitor connector Pin assignments The VGA connector is a male video RGB, 15-pin micro-D

style connector, and the Monitor connector is a female video RGB, 15-pin micro-D style connector. The pm assignments

To reset the lamp indicator after replacing the bulb, turn off

the projector, hold the ‘Menu” and ‘Sync-” buttons down then turn the power switch back on. Continue to hold the buttons down until all three monitor lights flash orange for about 3 seconds. The lamp dectector is now reset.

Pin Assignments

The following tables describe the pin assignments for the three connectors of the Y-cable: the LCD connector, the VGA connector, and the Monitor connector. The pin assignments for the VGA and Monitor connectors are identical.

LCD

connector pin assignments

The

LCD connector is a 26-pin D-style connector. Its pin

assignments are as follows: