Epson DM-KR084 Installation Manual

Page 1
Keyboard Unit
DM-KR084
English
Copyright© 1997, 2004 by Seiko Epson Corporation
Unpacking
Please confirm that this package contains these items:
Keyboard Unit Manual (this document)
Keytop covers
1 x 1 -- 100
2 x 1 -- 8
2 x 2 -- 2
Remover
Keytops 2 x 2 --- 2 2 x 1 --- 8
Numeric Keys/ --- 11 Double width 0 key/ --- 1
401347902
Please refer to the “IM-300 User’s Manual” for information on connection to the IM-300.
1
Page 2
Please refer to the “IR-310 Developer’s Guide” for information on connection to the IM-310.
When connecting to the IM-310, set jumper JP1 on board LVDS to [2-3], and set the LCD-Type in BIOS setup to [VGA-STN].
Please refer to the “IR-320 Technical Reference Manual” for information on connection to the IM-320.
When connecting to the IM-320, set jumper switch JP1 on the POS board to [1-2].
KeyTop Cover
Please refer to the “IM-300 User’s Manual,” “IR-310 Developer’s Guide” or “IR-320 Technical Reference Manual” for the usage of the keytop covers.
Safety Precautions
This document uses the two headings shown below to call attention to potential hazards. Failure to observe the information provided under or alongside these headings may lead to injury or damage to your equipment. Be sure that you understand the meaning of each heading before you proceed.
WARNING
Indicates a potentially lethal hazard. Failure to observe a WARNING may result in severe injury or death.
CAUTION
Failure to observe a CAUTION may result in personal injury, or in damage to equipment or other property.
2
Page 3
WARNING
Shut down your equipment immediately if it produces smoke,
a strange odor, or unusual noise. Continued use may lead to fire or electric shock. Immediately turn the power off and contact your dealer or a Seiko Epson service center for advice.
Never disassemble or modify this product.
Tampering with this product may result in injury, fire, or electric shock.
Do not allow foreign matter to fall into the equipment.
Penetration of foreign objects may lead to fire or shock.
If water or other liquid spills into this equipment, immediately
turn the power off and contact your dealer or a Seiko Epson service center for advice. Continued usage may lead to fire or shock.
CAUTION
Do not plug the cable differently from the instructions in this
manual. Wrong connection may cause equipment damage and fire.
Do not use in locations subject to high humidity or dust levels.
Excessive humidity and dust may cause equipment damage, fire, or shock.
English
Do not place heavy objects on top of this product. Never
stand or lean on this product. Equipment may fall or collapse, causing breakage and possible injury.
EMC and Safety Standards Applied
Product Name: Type Name:
The following standards are applied only to the units that are so labeled.
Europe: EMC: CE marking
North America: EMI: FCC/ICES-003 Class A
Keyboard Unit M139A
Safety: EN 60950
3
Page 4
Safety: UL 1950/ CSA C22.2 No. 950
Japan: EMC: VCCI Class A
JEIDA 52
Oceania: EMC: AS/NZS 3548
WARNING:
The connection of a non-shielded printer interface cable to this device will invalidate the EMC standards of this device.
You are cautioned that changes or modifications not expressly approved by Seiko Epson Corporation could void your authority to operate the equipment.
CE Marking
The unit conforms to the following Directives and Norms:
Directive 89/336/EEC
EN 55022 Class A EN 55024
IEC 61000-4-2 IEC 61000-4-3 IEC 61000-4-4 IEC 61000-4-5 IEC 61000-4-6 IEC 61000-4-11
WARNING:
This is a Class A product. In a domestic environment this product may cause radio interference in which case the user may be required to take adequate measures.
FCC CLASS A
FCC COMPLIANCE STATEMENT FOR AMERICAN USERS
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiat e radio frequ e ncy en ergy and, if n ot installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense.
4
Page 5
For Canadian Users
This Class A digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe A est conforme à la norme NMB-003 du Canada.
For Taiwanese Users
Part Names
Power LED HDD LED
English
Lock switch
MSR/28keyboad unit connector
Power LED
On and green when the IR series is turned on. The LED turns orange during battery backup, such as during a power outage (only when using the OI-R03 battery pack).
HDD LED
On when the HDD is being accessed.
5
Page 6
Lock switch
Locks and unlocks the Keyboard unit. When the Keyboard is unlocked by sliding this switch to the right, you can adjust the position of the Keyboard up and down, and lock the Keyboard in place at the best position. After adjusting the Keyboard for best visibility, slide the switch to the left to lock the Keyboard unit.
MSR/28 keyboard unit connector
A MSR unit (DM-MR111/MR123) or an 28 keyboard unit (DM-KR028) can be connected.
Precautions During Use
Use the key function definition utility 84KEYCFG.EXE for the IR
series to define programmable keyboard functions.
General Specifications
Key Switch 7 x 12 keyboard matrix External I/F For the MSR unit or the 28 keyboard unit LED Power LED, HDD LED Power supply +5V (supplied from the IR series) Dimensions 277mm (W) x 208mm (D) x 68mm (H)
excluding projections
Case color Epson cool white Mass Approximately 1.1 kg Environmental conditions
Conforms to the environmental conditions of the IR series.
6
Loading...