Emerson ACM1600M-108, ACM1400M-108, ACM1000M-108, ACM2000M-108, ACM1000M Series Owner's Manual

EMERSON_

Media Air C|eaner

With Media Fi|ter

Model Number

ACM1000M-XXX
ACM1400M-XXX

ACM1600M-XXX
ACM2000M-XXX

OWNERS MANUAL

• Installation

• Operation

• Maintenance

(_lease read and familiarize yourself with the contents of this manual beforeh

_nstalling, operating or performing maintenance on the unit. J

i

EMERSON

White-Rodgers is a division

of Emerson Electric Co.

www.white- rodge rs.com

PART NO. 37-7001A

0922

iNTRODUCTiON

The Emerson Media Air Cleaner comes complete with a 4"

media furnace air filter. This filter must be changed every three

to six months to maintain efficiency of the filter and furnace

system.
Please read instructions before installing and using the Air

Filter Compartment.

The fiber filter used in this cabinet for air cleaning
must be replaced every 90 to 180 days. Your heating
and cooling efficiency will decrease due to insufficient
air flow when filter becomes dirty.

Do not attempt installation of this unit unless you
are familiar with the necessary tools, equipment, and

potential hazards.

Installation should be performed only by a qualified
service provider.

Failure to do so could result in reduced performance
of the unit, serious personal injury or death.

GUARANTEE

Emerson will not assume any responsibility for component

failures due to incorrect installation procedures.

RULES FOR SAFE INSTALLATION

AND OPERATION

1. Read the Owners Manual and the Rules for Safe Operation
carefully. Failure to follow these rules and instructions could

cause a malfunction of filter or unsatisfactory service.

Installation of this unit must comply with local electric
codes or other applicable codes.

Review and understand local codes prior to

installation.

Before installing or servicing, always
shut off electricity. This will prevent any

electrical shocks.

2. Follow a regular service and maintenance schedule for
efficient operation.

TABLE OF CONTENTS

Rules for Safe Installation and Operation ...................... 2

How the Air Filter Works ................................................ 3

Construction of the Air Filter Compartment ................... 3

Preinstallation ................................................................ 4

Installation ..................................................................... 6

Maintenance .................................................................. 6

BASIC TOOLS REQUIRED

• Tin Snip

• Screwdriver

• Ruler orTape Measure

• Drill

DIDYOU GETTHE RIGHT SIZE

AIR FILTER COMPARTMENT

Model ACM1000M are designed for heating or cooling blowers
delivering 600 to 1200 cubic feet of air per minute (cfm.)

Model ACM1400M are designed for heating or cooling blowers
delivering 1000 to 1600 cfm.

Model ACM1600M are designed for heating or cooling blowers
delivering 1200 to 1800 cfm.

Model ACM2000M are designed for heating or cooling blowers
delivering 1600 to 2200 cfm.

Before installing the filter, make sure you have selected

the proper size unit for your heating and cooling system

requirements. See specifications on page 4.

HOWTHE AiR FILTER WORKS

Dirty air flows through your return air ducts and enters the

compartment where particles (hair, lint, etc.) are removed by
the filter. See figure 1.

Filtered air re-enters to the supply duct system of your
building.

DIRTY AIR IN ."

,..., o.'i

, . , . .o o

4" FILTER

o_ooooooee
ooeooooooo
eeo_oooe*o

_o*oQo_o*®
ooQo_ooo_
_o_eoooole
_oooooooeo
o_ooo_ooo

'o eoeoooeo

o.

-, ,,to.

FILTERED AIR OUT

Figure 1

CONSTRUCTION OFTHE AIR FILTER
COMPARTMENT

Not only is your air filter compartment easy to install, it is also easy to
maintain. Its basic components, and their functions, are as follows: (See

Figure 2)

Air Filter Cabinet - mounts to existing duct work and houses the filters
4" Filter - collects dust, dirt and other particles.

FILTER CABINET

Figure 2