Duke RUF-48 Installation Manual
RUF – 48
REFRIGERATED UNIT
OPERATING / INSTALLATION
INSTRUCTION MANUAL
TO HELP AVOID ANY INSTALLATION PROBLEMS AND TO HELP
ASSURE TROUBLE-FREE PERFORMANCE OF YOUR NEW
REFRIGERATOR, PLEASE READ THESE INSTRUCTIONS BEFORE
INSTALLATION AND OPERATION OF YOUR NEW UNIT.
FOR YOUR OWN SAFETY:
ELECTRICITY AND WATER DO NOT MIX, UNPLUG THE UNIT BEFORE CLEANING.
IF REPAIRS ARE REQUIRED, USE A QUALIFIED SERVICE AGENT.
WHILE REPAIRS ARE BEING MADE, BE SURE THE UNIT IS NOT PLUGGED IN.
BE SURE THE COMPRESSOR COMPARTMENT HAS ADEQUATE VENTILATION.
219602
04/07/08
(800) 735-3853 / (314) 231-1130 / (314) 231-5074 fax
Duke Manufacturing Co.
2305 N. Broadway; St Louis, MO 63102
1
IMPORTANT INSTALLATION INSTRUCTIONS
When installing the refrigerated unit, it is essential to insure proper air flow into and out of the
cabinet surrounding the unit. Improper ventilation will cause your compressor to burn out and will
void the warranty.
This unit ventilates from the front slotted kick plate. Do not block this kick plate and clean
periodically.
To assure long life of your unit, please insure that the above instructions are followed.
INSTALLATION:
This unit was shipped from the factory assembled and requires only the necessary electrical
connections.
ELECTRICAL CONNECTION:
The unit is designed to be operated on one (1) 15 amp dedicated circuit. The unit must be
grounded. The receptacle, wired circuit and protection should meet the required local codes for
proper operation.
GENERAL INSTRUCTIONS
Prior to use, the unit should be turned on to lower the temperature before the product is set in
place.
Cleaning should be done by wiping the unit out using a mild soap and water solution. Abrasive
cleaners should not be used.
TO ADJUST THE THERMOSTAT
The thermostat is located inside the unit. It is a black knob with settings of 1 – 9, and Nine being
the coldest setting.
Set the thermostat on 5 and cool the unit for 1 hour. Load unit with foods and after 1 hour check
thermometer located on rack inside unit for 120V or digital display located in rear riser for 220V
units. Temperature should be approximately 36° - 42° F/2°
accordingly.
PARTS: Contact the Duke Service Department at the number below.
:
– 6° C.
Adjust the thermostat
219602
04/07/08
Duke Manufacturing Co.
2305 N. Broadway; St Louis, MO 63102
(800) 735-3853 / (314) 231-1130 / (314) 231-5074 fax
2
Loading...