Dometic RM3662, NDR1292, RM3863, NDR1492, RM1272 User Manual

...
INSTALLATION INSTRUCTIONS
FOR
3307896.005 REFRIGERATOR HINGE REPAIR KIT (Beige) and
3307910.004 REFRIGERATOR HINGE REPAIR KIT (Black)
KIT CONTAINS:
(1) 3307888.002 Hinge Plate, RH Top/LH Btm-Blk or
3307886.006 Hinge Plate, RH Top/LH Btm-Beige
(1) 3307889.000 Hinge Plate, LH Top/RH Btm- Blk or
3307887.004 Hinge Plate, LH Top/RH Btm-Beige
(2) 2931171066 Bushing, Black or
2931171041 Bushing, Beige (3) --------------- Screw, #4x0.75 Philips PH (1) 33078997.003 Installation Instructions
INSTALLATION INSTRUCTIONS
1. Remove refrigerator door(s)(Refer to Owners Manual for detailed instructions on this procedure).
2. Examine the broken area to determine if hinge kit will properly repair the hinge. A substantial amount of the door hinge socket must be remaining to hold the bush­ing or the repair kit will not allow the door to properly align. See FIG. 1 and FIG. 1A.
FIG. 1
Small chip out of Hinge
FIG. 1A
Small chip out of Hinge
This Kit is applicable for the following refrigerator models:
NDR1062 NDR1292 NDR1492 RM1272 RM1282 RM2652 RM2852 RM3662 RM3663 RM3862 RM3863
4. Locate the correct Hinge Plate in the contents of the kit. Fit the bracket on the broken hinge. Place the bush­ing in the hinge to properly center the Hinge plate on the broken hinge. Use a scratch awl to mark the loca­tion for the screws. See FIG. 3.
Use Hinge Plate
FIG. 3
For Template
Use Scratch Awl to Mark Hole Locations
5. Predrill three 3/32” holes into the door hinges as marked in step 4.
3. If the door hinge socket is broken in a way that the bushing cannot be held by the hinge, the entire door must be replaced. See FIG. 2 and Fig. 2A.
FIG. 2
FIG. 2A
Front Half of Door Hinge
Large
Socket Missing
Crack
REVISION:
Form No. 3307897.011 4/02 (Replaces 3307897.003) (French 3307898.019) ©2002 Dometic Corporation LaGrange, IN 46761
6. Place new bushing in the door hinge socket. Put the hinge plate in place and install the three #4x3/8” screws.
7. Re-install the door back on the refrigerator.
Loading...