Please read this instruction manual carefully before installation and first
use, and store it in a safe place. If you pass on the product to another
person, hand over this instruction manual along with it.
Safety instruction: Failure to observe this instruction can cause fatal or
serious injury.
CAUTION!
Safety instruction: Failure to observe this instruction can lead to injury.
NOTICE!
Failure to observe this instruction can cause material damage and impair
the function of the product.
NOTE
Supplementary information for operating the product.
2General safety instructions
The manufacturer accepts no liability for damage in the following cases:
• Faulty assembly or connection
• Damage to the product resulting from mechanical influences and excess voltage
• Alterations to the product without express permission from the manufacturer
• Use for purposes other than those described in the operating manual
2.1General safety
CAUTION!
!
• Only use the device only as intended.
• Do not operate the device in wet or damp environments.
• Maintenance and repair work may only be carried out by qualified
personnel who are familiar with the risks involved and the relevant
regulations.
• Persons (including children) whose physical, sensory or mental capabilities or lack of experience and knowledge prevents them from using
the appliance safely should not use this appliance without initial supervision or instruction by a responsible person.
5
Page 6
EN
General safety instructionsMPS35
For Sales Information Please Contact RoadTrucker Inc (www.RoadTrucker.com)
• Electronic devices are not toys!
Keep electrical appliances out of reach of children or infirm persons.
Do not let them use the appliances without supervision.
2.2Safety when installing the device
CAUTION!
!
A
Electrical cables
!
A
• Ensure that the device is standing firmly!
The device must be set up and fastened in such a way that it cannot tip
over or fall down.
NOTICE!
• Do not expose the device to a heat source (such as direct sunlight or
heating). Avoid additional heating of the device in this way.
• For installation on boats:
If electrical devices are incorrectly installed on boats, corrosion damage might occur. Have the inverter installed by a specialist (marine)
electrician.
CAUTION!
• Lay the cables so that they cannot be tripped over or damaged.
NOTICE!
• If cables have to be fed through metal walls or other walls with sharp
edges, use ducts or tubes to prevent damage.
• Do not lay cables which are loose or bent next to electrically conductive material (metal).
• Do not pull on the cables.
• Do not lay the 110 – 240 Vw mains cable and the 12/24 V DC cable
in the same duct.
• Fasten the cables securely.
6
Page 7
EN
MPS35Scope of delivery
For Sales Information Please Contact RoadTrucker Inc (www.RoadTrucker.com)
The mains rectifier can operate all coolers and refrigerators with BD 35F compressors
at 110 – 240 Vw.
With a 110 – 240 Vw mains connection, the rectifier automatically switches from battery to mains operation.
When disconnected from the 110 – 240 Vw mains supply, the rectifier automatically
switches back to battery operation. Mains operation via the rectifier always takes priority over battery operation.
5.1Control elements
Item
in fig. 1, page 3
1Mains cable
2Battery input terminals
3Compressor output terminals
4Fastening holes
Explanation
6Mounting the mains rectifier
If you wish to mount the mains rectifier in a fixed position, please observe the following mounting instructions:
NOTICE!
A
• Do not mount the device
–In wet or damp environments
–In the vicinity of combustible materials
–In areas where there is a danger of explosions
• Make sure the socket is near the device and is easily accessible.
Fix the mains rectifier in upright position only. In case you have to install
the rectifier in a different position put the rectifier in a fire resistant housing to prevent any fire being roused to other objects by hot plastic tripping through the air slots.
8
Page 9
EN
MPS35Using the mains rectifier
For Sales Information Please Contact RoadTrucker Inc (www.RoadTrucker.com)
• The place of installation must be well-ventilated. A ventilation system which is at
least equivalent to the air openings in the device must be present for installations
in closed housings.
• The air intake on the underside or the air outlet on the back of the device must
remain clear.
• The installation surface must be level and sufficiently sturdy.
➤ Fasten the mains rectifier with screws through the fastening holes in the front and
the rear of the device (fig. 1 4, page 3).
7Using the mains rectifier
WARNING!
!
A
Do not reverse the polarity. If the poles are reversed device may overheat and be damaged.
NOTICE!
Replace defective fuses with new ones of the same rating (15 A slowblow).
WARNING!
!
➤ Determine the required cross section of the cable in relation to the cable length
according to fig. 3, page 3.
Key for fig. 3, page 3
Protect the positive connecting cable to the battery by an external fuse
of 10 A (fig. 2 4, page 3).
Insert the fuse as near as possible to the battery.
Co-ordinate axisMeaningUnit
lCable lengthm
∅Cable cross sectionmm²
9
Page 10
EN
Maintaining and cleaning the mains rectifierMPS35
For Sales Information Please Contact RoadTrucker Inc (www.RoadTrucker.com)
➤ Connect the mains rectifier according to the circuit diagram in fig. 2, page 3.
Key for fig. 2, page 3:
ItemExplanation
1Mains cable
2Battery input terminals
3Compressor output terminals
4Fuse (not included in scope of delivery)
5Battery
rtred
swblack
8Maintaining and cleaning the mains
rectifier
WARNING! Danger of electrocution!
!
Always disconnect the mains plug before you clean and service the
device.
NOTICE! Danger of damaging the device!
A
➤ Occasionally clean the device with a damp cloth.
Never clean the device under running water or in dish water.
Do not use abrasive cleaning agents or hard objects during cleaning as
these can damage the device.
10
Page 11
EN
MPS35Guarantee
For Sales Information Please Contact RoadTrucker Inc (www.RoadTrucker.com)
The statutory warranty period applies. If the product is defective, please contact the
manufacturer's branch in your country (see the back of the instruction manual for the
addresses) or your retailer.
For repair and guarantee processing, please include the following documents when
you send in the device:
• A copy of the receipt with purchasing date
• A reason for the claim or description of the fault
10Disposal
➤ Place the packaging material in the appropriate recycling waste bins wherever
possible.
If you wish to finally dispose of the product, ask your local recycling centre
or specialist dealer for details about how to do this in accordance with the
M
applicable disposal regulations.
11
Page 12
EN
Technical dataMPS35
For Sales Information Please Contact RoadTrucker Inc (www.RoadTrucker.com)