Dod SR 460 H User Manual

5 (1)

A Harman International Company

ELECTRONICS

isit DOD on the W

orld W

ide W

eb at: http://www

.dod.com

Headphone Amp Man. 6/8/99 10:57 AM Page 1

INTRODUCTION

Congratulations, and thank you for your purchase of the DOD SR 460 Stereo Headphone Amplifier. The SR 460

provides you with Left, Right and Stereo inputs, and 6 outputs. In addition, each output has independent level

control as well as a master level for all 6 channels. Another unique feature to the SR 460 is its slow audio ramp-

up feature. The audio has an approximate 750 millisecond ramp-up time on power-up to prevent damage to

hearing caused by loud audio pops. It also gives you time to turn down the volume if previous settings are too

loud. All inputs and outputs are 1/4 inch TRS

The SR 460 is another innovative product brought to you by DOD Electronics.

FRONT PANEL FUNCTIONS

The front panel and controls of the SR 460 headphone amplifier are as follows:

1. STEREO FRONT INPUT/OUTPUT - A high impedance, high sensitivity plug-in connection that acts as an

output or a Loop-through input.

2. CLIP LED - This LED indicates internal signal clip from input device.

3. MASTER OUTPUT - This control controls the overall amount of signal fed to each channel.

4. OUTPUT LEVEL CH. 1 - This knob controls the output of signal in channel 1.

5. OUTPUT CHANNEL 1 - This jack is used for the headphone output in channel 1.

6. OUTPUT LEVEL CH. 2 - This knob controls the output of signal in channel 2.

7. OUTPUT CHANNEL 2 - This jack is used for the for the headphone output in channel 2.

8. OUTPUT LEVEL CH. 3 - This knob controls the output level in channel 3.

9. OUTPUT CHANNEL 3 - This jack is used for the headphone output in channel 3

10. OUTPUT LEVEL CH. 4 - This knob controls the output level of channel 4.

11. OUTPUT CHANNEL 4 - This jack is used for the headphone output of channel 4.

12. OUTPUT LEVEL CH. 5

- This knob controls the output in channel 5.

13. OUTPUT CHANNEL 5 - This jack is used for the headphone output of channel 5.

14. OUTPUT LEVEL CH. 6 - This knob is used for the output level control in channel 6.

15. OUTPUT CHANNEL 6 - This jack is used for the headphone output of channel 6.

16. POWER SWITCH - This switch turns the AC power either On or OFF.

Note : To optimize the performance of the SR 460, it is recommended to use the AKG™ K270 Headphone.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

Headphone Amp Man. 6/8/99 10:57 AM Page 2

+ 2 hidden pages