D-link EH100 Quick Installation Guide

Before You Begin

• If you purchased this router to share your broadband Internet connection with
several computers, you must have either an Ethernet-based Cable or DSL
modem and an active Internet account with an Internet Service Provider.

• It’s best to use the same computer that is connected to your modem for
configuring the EH-100 Wireless G router. The EH-100 has a DHCP server
and will assign the necessary IP address information for your network.

Package Contents

• eHome EH100 Wireless G Broadband Router

• Power Adapter

• Ethernet Cable

• Manual and Warranty on CD

Note: Using a power supply with a different voltage rating than the one
included with the EH100 will cause damage and void the warranty for this
product.

If any of the above items are missing, please contact your reseller.

2eHome EH100 Quick Install Guide

Connecting the EH100 to your network

Connect the power adapter to the receptor on the rear panel of the

A.

EH100 and then plug the other end of the power adapter to a wall outlet or
power strip. The power LED will turn ON to indicate proper operation.

1. Power off your Cable or DSL modem. If the modem does not have a

B.

on/off button, unplug the power adapter.

2. Connect an Ethernet cable to the Ethernet port on the modem and
then power on the modem.

3. Connect the other end of the Ethernet cable to the WAN port
of the EH100. The WAN LED will illuminate to indicate a proper
connection.

Connect an Ethernet cable to LAN port 1 on the EH100 and connect

C.

the other end to an Ethernet network adapter on the computer that will
be used to configure the EH100.

Computers equipped with 802.11b/g wireless adapters will be able to

D.

connect to the EH100.

D. Antenna

Used to broadcast wireless network
an d re c i e v e c o n n e cti o n s f r o m

802.11 b/g wireless clients.

A. Power Receptor

Receptor for Power Adapter.

C. LAN Ports

Connects EH100 to Ethernet enabled
computers or devices.

B. WAN Port

Connects to Internet modem.

3 eHome EH100 Quick Install Guide

After completing the previous steps, connecting the EH100 to your computer,
reboot the computer.

Using additional Ethernet cables, connect any other Ethernet equipped
computers to the remaining LAN ports on the EH100. Proper intstallation and
operation will be indicated by the LEDs on the front panel of the EH100.

WLAN LED

A solid light indicates the wireless

WAN LED

A solid light indicates a connection on
the WAN port. This LED blinks during
data transmisison.

segment is ready. This LED blinks
during wireless data transmission.

LAN LEDs

A solid light indicates
a con n e c t i o n t o an
Ether net dev i c e o n
ports 1-4. These LEDs
b l i nk d u ri ng d a ta
transmission.

Status LED

A blinking light indicates the
EH100 is ready.

Power LED

A s o lid l ight i ndic a t e s a prope r
connection to the power supply.

4eHome EH100 Quick Install Guide