This equipment has been t es t ed and f ound to comply
with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful
interference in a residential installation. This
equipment generates, use s and c an radi at e r adi o
frequency energy and, if not inst al l ed and us ed i n
accordance with the instructions, may cause harmful
interference to radio communications. However, there
is no guarantee that interference will not occur in a
particular inst al l at i on. If t hi s e qui pment does cause
harmful interference to radio or television reception,
which can be determined by turning t he equi pment off
and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
Page 3
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment
•
and the receiver.
Connect the equipment into an outlet on a circuit
•
different from that to which the receiver is
connected.
Consult the dealer or an experienced radio/TV
•
technician for help.
Shielded interface cables must be used in order to
comply with emission limits.
Changes or modifications not expressly approved by
user’s authority to operate this equipment.
VCCI B Warning for Model DE-805TP
CE Class B Warning
Rev. 04 (Aug. 1997)
6DE-805-TP.-.04
Printed in Taiwan
Page 4
Offices
8ï6ï$ï'ð/,1. 6<67(06ñ ,1&ï
&$1$'$'ð/,1. &$1$'$ñ ,1&ï
8ï.ï'ð/,1. õ(8523(ô /7'ï
*(50$1<'ð/,1. õ'(876&+/$1'ô *0%+ ,ï*ï
)5$1&('ð/,1. )5$1&(
6:('(1'ð/,1. $î%
'(10$5.'ð/,1. '(10$5.
6,1*$325('ð/,1. 6,1*$325( 37(ï/7'ï
$8675$/,$'ð/,1. $8675$/,$ 37<ï/7'ï
&+,1$'ð/,1. %(,-,1*
-$3$1'ð/,1. 72.<2
,1',$'ð/,1. õ,1',$ô 397ï /7'ï
7$,:$1'ð/,1. 7$,:$1
и 0XVLFN ,UYLQHс &$ длзме 86$
7(/г мржмйрйиирмзее )$;г мржмйрйиирлилм
A stabilizing stand has been provided with the hub.
It functions as a “foot” to provide a stable installation
on a desktop or other flat surface.
Connecting Power
Use an AC power adapter (optionally available from
your dealer). The AC power adapter provides a
stable source of power for the hub. This
lists the AC power adapters that can be used
Guide
1
User’s
Page 6
with the DE-805TP hub. Consult th i s li st if you need
to place an order.
Caution:
If you are going to supply your own
AC power adapter, carefully read
the input power specification of the
DE-805TP hub. No fus e is pr ovided
to protect the hub from high input
voltage or sudden power surges.
Using the wrong AC power adapter
may cause irreparable damage to
the hub.
Connecting Twisted-Pair Segments
Each of the hub’s five twisted-pair ports can be used
to connect a station or other device. Use a straightthrough twisted-pair cable with RJ-45 connectors on
both ends.
2
Page 7
The twisted-pair cable extended from a twisted-pair
port is called a “twisted-pair segment,” and it can be
up to 100 meters long.
Note:
To connect port 5 to a computer or
other non-hub device, make sure
that you set the switch on the
bottom of the hub to the “Normal”
position.
3
Page 8
Connecting Hubs Together
Connecting (cascading) hubs together allows you to
increase the number of ports available to the
network. All stations attached to the cascaded hubs
communicate with each other on the same network.
1.Use port 5 to connect the hubs together. Set this
port to the “Uplink” position using the switch on
the bottom of the hub.
2.Use a straight-through twisted-pair cable,
connect one end to one hub in the “Uplink”
position. Connect the other end to a hub in th e
“Normal” position. The length of this cable can
be up to 100 meters.
Note:
Do not connect more than f our hubs
together. If you must expand the
network to include more ports, use
hubs with higher port densities.
Regardless, the number of
4
Page 9
cascaded hubs MAY NOT exceed
four unless a bridge is used.
5
Page 10
Diagnostic LEDs
Power
•
If this LED is off, check to be certain you are using
the correct AC power adapter or if the adapter you
are using is damaged. (Note: if the other LEDs are
functioning, then it is possible that the Power LED is
bad and nothing is actually wrong.)
Collision
•
Excessive blinking of this LED indicates that the
traffic on the network is heavy. Since there are only
five ports on the DE-805TP, this situation generally
only occurs if multiple hubs are cascaded together. If
network speed is significantly affected, disconnect
non-essential stations or add a bridge.
Link/Rx
•
Ther e i s on e Li n k/ Rx LE D for each p ort . For por t 5 ,
this LED applies only when the port is set to the
“Normal” position. When the LED is on (for each
port), the data link between the port and the node
connected to it is functioning. If a node is connected
and the LED is off, check the cable, con nector and
the power status of the node. This LED blinks when
data is being received.
6
Page 11
Connector Pinouts
7
Page 12
List of AC Power Adapters for
Use with the DE-805TP Hub
7R REWDLQ DQ 50$ QXPEHU RU Z DUUDQW\ VHUYLFHñ FRQWDFW WKH 'ð/LQN
RIILFH QHDUHVW \RXï $ OLVW RI FRQWDFW DGGUHVVHV IRU 'ð/LQNªV
LQWHUQDWLRQ DO RI ILFHV F DQ EH IR XQG LQ WK LV 8VHUªV *XLGHï <R X U
:DUUDQW\ 5HJLVWUDWLRQ &DUG QHHGV WR EH ILOOH GðRXW DQG VHQW WR \RXU
UHJLRQDO 'ð/LQN RIILFHï
Page 16
Registration Card
Print, type or use block letters.
Your name: Mr./Ms________________________________________________
Organization:_____________________________ Dept. __________________
Your title at organization: ___________________________________________
Telephone:__________________________ Fax:________________________
Organization's full address: _________________________________________
________________________________________________________________
Country:______________ Date of purchase (Month/Day/Year):_____________
3URGXFW
0RGHO
3URGXFW
6HULDO 1R1
- 3URGXFW LQVWDOOHG LQ W\SH RI
FRPSXWHU +H1J1/ &RPSDT 7;9,
- 3URGXFW LQVWDOOHG
&RPSXWHU VHULDO 1R1
Product was purchased from:
Reseller's name: __________________________________________________
Telephone:_______________________ Fax:____________________________
Reseller's full address: _____________________________________________
________________________________________________________________
1. Where and how will the product primarily be used?
†
Home †Office †Travel †Company Business †Home Business †Personal
2. How many employees work at installation site?
†
1 employee †2-9 †10-49 †50-99 †100-499 †500-999 †1000 or more
3. What network protocol(s) does your organiza tion use ?