Denver DTX-1410 User Manual

RR

www.denver-electronics.com

14" COLOUR TELEVISION
ON SCREEN DISPLAY
REMOTE CONTROL
HYPERBAND TUNER
PERITELEVISION(SCART JACK)
NTSC PLAYBACK
TELETEXT

Description:

Job No.

Model:

Revised:0

Engineering Dept:

Artwork By:

Checked By:

Approved By:

MANUAL

14NI

Brand Name:

P/No.

Scale:

DENVER42088

Date:

Date:

Date:

02-18-04

DTX-1410

MANUAL

3Y

SPECIFICATIONS

Receiving System : BG , DK
Colour System : PAL / NTSC Playback
Picture Tube : 37cm ( ") diagonal
Ext. Antenna : 75 Ohm Coaxial Cable
Ext. In/Out :
Speaker : 16 O

Audio Output : > 3W
Power Consumption : AC 150-260V 50/60Hz, 60W
Dimension : 400(W) x 355(D) x 321(H)mm
Net Weight : 10.1 kg

REMOTE CONTROL
Transmitting System : Infrared
Power Supply :
Dimension : 55(W) x 184(L) x 34(D)mm
Net Weight : 130 g

Design and specifications are subject to change without prior notice.

14

Peritelevision(Scart Jack)

hm x 2

DC 3V (1.5 x 2)

-1-

SPECIFICATIONS

Thank you very much for your purchase of this product-the most natural Colour Television Receiver.
To enjoy your set to the full from the very beginning, read this manual carefully and keep it handy for ready

reference.

INSTALLATION

Locate the receiver in the room where direct light does not strike the screen.
Total darkness or a reflection on the picture screen can cause eyestrain. Soft and indirect lighting is

recommended for comfortable viewing.
Allow enough space between the receiver and the wall to permit ventilation.
Avoid excessively warm locations to prevent possible damage to the cabinet or premature component

failure.
This TV receiver can be connected to AC 150-260 Volts. 50/60 Hz. Never connect to DC supply or any

other power supply.
Do not install the receiver in a location near heat sources such as radiator, air ducts, direct sunlight, or in

a place somewhere like close compartment and close area.
Do not cover the ventilation openings when using the set.

CAUTION

Never tamper with any components inside your set, or any other adjustment controls not mentioned in
this manual. All television receivers are high voltage instruments. Your PICTURE TUBE is highly evacuation.
If broken, glass fragments will be violently expelled. Scratching, chipping or undue pressure is dangerous
and should be avoided. When you clean up dust or stick of a water drop on the PICTURE TUBE FACE or
CABINET, the power cord should be pulled out from the plug receptacle, then wipe the receiver with dried
soft cloth. During thunder and lighting, unplug the power cord and antenna cord to prevent your TV set
from damage. All "inside work" on your receiver should be performed only by the TV service personnel.

-1-

1. Main Switch

2. Power Indicator

3. Remote Sensor

4. AV/TV

5. Mute Button

6. Volume Down & Up Button

7. Program Down & Up Button

8. Menu Button

9. Speakers

10. Side AV in(Option)

11. AC Power Cord

12. Peritelevision (Scart Jack)

13. Terminal Antenna (75 Ohm)

CONTROL LOCATION

9

7 7 6 6 8 5 4

11

12

2 9

3

13

1

10

-2-