Bandwidth Power: amplifier rated at 5Hz to 80Khz (at 8 ohms, with THD of 0.01 percent).
Frequency response of an amplifier spanning from 1 Hertz to 300000 Hertz ± 0, dB - 3 dB metric with a power output of 1 Watt.
To operate with the amplifier from minimum sensitivity of 1 V (Normal), it operates efficiently at 1.41 V (High cut filter in).
18 k ohm normal cut (normal) impedance, 25 k ohm cut high sensitivity impedance, 18k cut high sensitivity.
Impedance at the output: 0.08 ohms when meter reads 1 kHz.
Signal to Noise Ratio: Effectively a measure of the energy of the desired output to that of the background noise the ratio is equal to 123 dB (A weighting).
High cut filter setting is at 40 kHz with a 6dB/octave rise from the cut level (in use).
Switch or adjust the subsonic filter to set the frequency from 16Hz initial level and raise the cutoff gradually at 6dB/octave.
slew rate positivity is at 500 volt / microsecond.
Peak level type indication is showcased on output level meter whilst the meter range calculation ranges from -50 dB to 5 dB with 0dB calculated effective power undervalued at 200W at 8 ohm.
Level meters have some defined frequency ranges through which they work. These ranges are 10 Hz to 100 kHz along with an (at 1 W) input of -3dB.
Speakers within the range of 6 to 16 ohm can be directly attached via output terminals.
There are multiple self diagnosing functions embedded within the machine which will alert the user if the operating temperature is abnormal or if there are malfunctions within the right or left channels.
Coming towards the Power, for Canada and USA the supply is AC 120V with a frequency of 60 Hz, for Europe and Hong Kong it is 220-240 V with 50Hz and for Singapore and Australia the supply is extended to 490W.
Including holding knobs, the dimensions for the machine are 493mm in width, 199mm in height and 480mm in depth.
The combined weight of the machinery is approximately 30 kg.
Frequently Asked Questions
What is the maximum power that the POA-30002 outputs?
A minimum guaranteed output of 250 watts via RMS is available at channel 8 ohms.
At any rated output what is the harmonic distortion present?
The rated output of 8 ohms can perfectly give a total harmonic distortion level of 0.002%.
What is the range for inputs that can be fed?
Within the normal setting 1 V can be input, while 1.41 V can be input while high cut filters are active.
Is it possible to determine amplifier input and output frequency response?
Yes, frequency response is 1 Hz – 300 KHz +0, –3 dB at 1w.
Do not amp models usually have an input impedance?
Yes, the input impedance of the amplifier usually ranges from 6 to 16 ohms.
Is it possible to tune Cool version of Audio Pulsar amplifier?
Yes, it has self-diagnostic functions which reflect faulty operating temperature and both channels and output transistors.
What amount of input power is required for the device to operate?
The values are 493 mm x (W) 199 mm, (H) 480 mm, (D), 30 kg.
User Manual
Loading...
+ 15 hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.
Loading...