Denon POA-2800 Service Manual
Specifications and Main Features
i. The rated output power is at a minimum of 200 W + 200 W RMS when diving into 8 ohms ranging from 20 Hz to 20 kHz.
ii. The total harmonic distortion can go below 0.01%.
iii. Intermodulation distortion has a measured angling of less than 0.002%.
iv. The measured power bandwidth is 5 Hz to 80 kHz supporting 8 ohms with a THD of 0.03%.
v. The frequency response ranges from 1 Hz to 150 kHz plus minus 3 dB when 1 W of input is applied.
vi. The input sensitivity power rating goes up to 1V.
vii. The input impedance value is set at 25 k ohms.
viii. The output impedance with an angle of 1 kHz is recorded at 0.1 ohm.
ix. The S/N ratio has been measured at 123 dB when IHF, and A-weighting has been applied.
x. The output terminals used are Speakers A or B paired with 4~16 ohms, A+B covering a range of 8~16 ohms.
xi. The UK and Australia Models requires AC 240 V/50 Hz, the US and Canada variants operate on AC 120 V/60 Hz, while Europe draws AC220V/50Hz and multi voltage models work on 50/60 Hz ranging from AC 110/120/220/240 V.
xii. The US and Canada model has imported power consumption rating at 9A while other models differ in usage with the IEC working a 500W and multi-voltage on 415W.
xiii. The dimensions of the product have been reported at 434 (W) x 186 (H) x 417 (D) mm.
xiv. The total weight does not go past 18 kg.
Frequently Asked Questions
i. The POA-2800 amplifier has a set rated output recording of 200 W+W RMS capable of working with 8 ohms.
- What is the total harmonic distortion of the amplifier?
- The total harmonic distortion is rated lower than a decimal 0.01 percent.
- What types of speaker systems can be connected to the amplifier?
- Speaker A and Speaker B have ranges of 4 to 16 ohms, while A and B Combined have a range of 8 to 16 ohms.
- What is the Input sensitivity of the amplifier?
- Valued at 1 V, Input sensitivity levels at such.
- Is the POA-2800 model multi voltage?
- Such a model does exist that values at an AC rating of 110/120/220/240V at 50/60Hz frequencies, allowing it to be multi voltage.
- What is the noise level of the amplifier?
- At an IHF and A weighted standard, the ratio of signal to internal noise is 123 dB.
- What power does the amplifier need?
- The Internation Electro technical Commission states that the amplifier rated at 500 watts.
- What are the measured dimensions of the POA-2800?
- With metric measurements: 434mm width, 186mm height, and 417mm depth.
- What is the weight of the amplifier?
- The amplifier did weigh around the ballpark of 18 kilograms or translating into pounds roughly equating 39.12oz.
User Manual
Loading...