Delonghi XTJ 140 B, XTJ 140L B, X TJ 140R T Instructions Manual

IMPORTANT
• Read this manual carefully and keep for future reference.
• Before using the appliance, check that the mains supply voltage corresponds to the voltage indicated on the rating plate.
• Connect the appliance to sockets with a minimum current rating of 10 A only.
•When not in use or before cleaning or maintenance, always unplug the appliance from the mains socket.
• Never vacuum up liquids.
• Never leave the appliance turned on when unattended. Keep away from children and unfit persons.
• Use the appliance for domestic use only as described in the instructions.
• If the appliance appears defective, do not use.
• For repairs or to buy accessories, contact an authorised technical service centre only.
• The manufacturer cannot be held responsible for any damage caused by tampering or improper or incorrect use of the product.
• If the power cable is damaged, it must be replaced by the manufacturer or an authorised technical service centre in order to avoid all risk.
• Never allow the appliance to be used by persons (including children) with psychological, physical or sensory impairments or with insufficient knowledge, unless closely supervised and instructed by someone responsible for their safety. Always supervise children. Make sure they do not play with the appliance.
10
Never unplug the appliance by pulling the power cable or the appliance itself.
Make sure the power cable does not tangle in the wheels of the appliance.
Never vacuum up matches, ash or cigarette ends when still lit.
Never use the appliance on wet surfaces.
Do not obstruct the suction port or the air vent grille.
Never vacuum up needles, staples or wire.
The manufacturer reserves the right to modify appliances and tools without warning.
DESCRIPTION
11
A Telescopic tube (various, according to
model)
B Hose/handgrip C ON/OFF pedal D Cable wind pedal E Power regulator F Crevice tool G Dust bag full indicator
H Handle I Air outlet filter L Air outlet grille M Dust bag compartment release button N Two position carpet/floor brush
ASSEMBLY INSTRUCTIONS
Always unplug from the mains before attaching or removing tools.
Assembling the appliance
Insert the hose (B) in the coupling on the appliance and turn clockwise until it hooks into place (Fig.1). To remove, turn anticlockwise and pull out (Fig. 2).
Vacuum tubes
Connect the telescopic tube to the end of the hose handgrip.
Plastic telescopic tube
Once the telescopic tube has been attached to the handgrip, press the release button and hold it down while you pull the tube out (Fig. 2). When you have pulled out the required length, release the button. Now fit the chosen tool to the other end of the tube.
Metal telescopic tube
Once the telescopic tube has been attached to the handgrip, turn the release ring then hold it there while you pull the tube out (Fig. 4). When you have pulled it out to the required length, release the ring. Now fit the chosen tool to the other end of the tube.
USING THE CLEANING TOOLS
All vacuuming tools can be connected either directly to the hose handgrip or to the tele­scopic extension
Two position carpet/floor brush
Pos.1: to clean hard floors, bristles out (Fig.5). Pos.2: to clean carpets and rugs, bristles in (Fig. 6).
Crevice tool (Fig. 7)
To clean radiators, corners, edges, drawers, etc.
Loading...
+ 2 hidden pages