Delonghi HSX3320FTS Instruction manuals

IMPORTANT INFORMATION
Safety warnings

Danger!

Failure to observe the warning may result in life-threatening
injury by electric shock.

- The appliance must not be placed
immediately below a power socket.

- Do not use the heater close to bath,
wash-basin, shower and swimming
pool.

- If you intend to x your appliance to the
wall, make sure that the switch or other
control devices are not within reach of
persons in the bath or shower.

- If the power cable has been damaged, it
must be replaced by the manufacturer
or the service centre or by an expert
sta member so as to avoid all risks.

Important!

Failure to observe the warnings could result in injury or damage
to the appliance.

- The appliance can be used by children
at least 8 years old and by persons with
reduced physical, mental and sensory
capacities or with inadequate experience
and knowledge, as long as they are
carefully supervised or instructed on
how to safely use the appliance and
the hazards involved. Make sure that
children do not play with the appliance.
Cleaning and maintenance performed
by the user must not be performed by
children without supervision.

- Children less than 3 years old should be
kept away from the appliance unless
continuously supervised.

- Children between 3 and 8 years old
may only switch the appliance on and
o, provided that it has been placed
or installed in its normal operating
position, they are carefully supervised

and instructed concerning use of
the appliance in a safe way and they
understand the hazards involved.
Children between 3 and 8 years old
should not insert the plug, adjust
and clean the appliance or perform
maintenance on it. ATTENTION: Some
parts of the appliance can become very
hot and cause burns. Pay particular
attention when children and vulnerable
persons are present.

- ATTENTION: to avoid any danger caused
by an accidental reset of the safety
system, this appliance must not be
powered through an external timer.

- Do not use the appliance in small rooms
when they are occupied by persons that
are not capable of leaving the room on
their own, unless constant supervision
is provided.

Danger of burns!

Failure to observe these warnings may cause burns.

- ATTENTION: to avoid
overheating, do not cover the
appliance for any reason during
operation, this would cause dangerous
overheating.

- The use of an extension lead is not recommended as it
could overheat during operation of the appliance.

Note:

This symbol indicates recommendations and important
information for the user.

- Never use the appliance to dry laundry.

- Do not place the power cable on the appliance when it is
hot.

- For greater eciency position the device away from
draughts.

- Only use the heater in an upright position.

- The appliance must be positioned at a minimum distance
of 80cm from curtains or other movable objects sensitive
to heat.

- The rst time you use the appliance it may emit smells. It
is advisable to let it run for at least 15 minutes with the

8

thermostat at the maximum setting and then ventilate
the room. A little smoke may be emitted due to the
protective substances applied to the heating element
before transport.

- Do not position the appliance on deep-pile carpets or
rugs, to avoid obstruction to the air intake grille located
under it.

- Do not obstruct the hot air outlet grille or the air intake
grille on the bottom of the appliance.

- Position the appliance so that the plug and the power
socket can be easily reached after installation.

- Do not use this appliance in a room whose surface area is
less than 4 m2.

- An anti-tilt safety device turns the appliance o if it falls
over or is positioned inappropriately so as to jeopardise
safety. The appliance resumes operation after being
placed in an upright position again.

- The appliance is tted with a safety cuto device
which will switch the appliance o in case of accidental
overheating.

To reset the cuto, disconnect the plug from the power

socket for a few minutes, remove the cause of overheating
then reconnect the appliance. If this abnormal situation
happens several times, contact customer service.

This appliance conforms to the following EC directives:

- Low Voltage Directive 2006/95/EC and subsequent
amendments

- Directive 2004/108/EC on electromagnetic compatibility
(EMC) and subsequent amendments

Disposing of the appliance

The appliance must not be disposed of with household
waste but must be taken to an authorised waste
separation and recycling centre.

DESCRIPTION

A Warning lamp
B Thermostat
C Power selector
D Slider
E Timer

General instructions

Remove the appliance from the packaging.
Check that neither the appliance nor the power cable has
been damaged during transport. Do not operate the heater if
damaged. Remove all publicity material from the appliance.
The appliance is suitable for free-standing or wall-mounted
usage. Do not assemble the feet if wall-mounted.

Electrical connection

- Before connecting the appliance to the power socket,
check that the voltage indicated on the appliance rating
plate is the same as your electrical system and that it can
support the power consumption (Watt) indicated.

- If more than one appliance is used at the same time, it is
important to ensure that the electrical system is able to
support the power required.

Use on the oor, feet assembly

Tools required:
Screwdriver PH2x100 (crosshead)
2 supplied screws 3.5x13 PH (F)
Place the appliance on a stable surface.
For mounting the feet, proceed as follows:

- Insert the two hooks in the slots and rotate the foot until
it is engaged as shown in gure 2.

- Insert the two pins in their respective holes.

- Fix the foot with the screw (F) supplied (gure 3).

- See Figure 4 for the minimum distances of the device
from the walls. The measurements are indicated both for
models equipped with fan "" and for models without.

Important! never use the appliance without feet if it is

not mounted on the wall.

Installation on the wall

The kit for wall installation contains:
2 metal brackets for mounting above (G)
2 metal brackets for mounting below (H )
2 screws 3.5 x 9.5 PH (I )
4 screws 4.5 x 25 PH (J )
4 plastic wall plugs 6 x 30 ( K )

Tools required for installation and estimated time for
installation

Screwdriver PH 2x100 (crosshead)
Estimated time for installation: 30 minutes
Before installing the unit, ensure the following:

a. The device must not be placed directly under a

power socket.

b. The plug and power socket must be easy to reach

after installation.

c. No electric cables or other pipework could be

damaged during installation.

d. Keep away from curtains or ammable materials.

For wall mounting, proceed as follows:
Place the appliance on a stable surface. Use a screwdriver to x
the two brackets H with screws I as shown in Fig. 6.

1. Before drilling the wall, mark the exact spot, respecting

9