Delonghi CKT 2203 Instructions Manual

4

IMPORTANT

- The appliance is exclusively for the use for which
it has been expressly manufactured. Any other
use is to be considered inappropriate and
therefore dangerous. The manufacturer cannot
be held responsible for eventual damage caused
by inappropriate, improper or irresponsible use
and/or for repairs made to the product by
unauthorised personnel.

- After having removed the appliance from the
packaging, make sure that the product is complete
and in perfect condition.

- The plastic bag in which the appliance was
packaged should be kept out of reach of children
as it poses a suffocation hazard.
In order to remove the dust that may have
accumulated on the appliance, simply dust it off
with a soft cloth.

- Before inserting the plug into the electrical outlet,
make certain:

- the voltage of the outlet corresponds to the value
indicated on the information label, attached to
the appliance.

- the electrical outlet is adequately earthed: the

manufacturer declines any responsibility for the
lack of observation of this norm.

-The use of an extension lead is not recommended
as overheating of the extension lead may occur
during the operation of the toaster.

- When the appliance is plugged into the electrical
outlet, and moreover, while it is turned on, never
place hands into the bread toasting slots (B).

- Never allow the appliance to be used by children
or used without adult supervision.

- Do not touch the appliance with wet or damp
hands.

- The areas surrounding the bread slots (B) become
very hot during use: operating the appliance
should be carried out using only the plastic dials
+ handles.

-Bread is a foodstuff which may catch fire. Do not
use this appliance under or next to curtains or
other combustible material.

- Do not cover the appliance while it is in use.

- Unplug the appliance from the electrical outlet
when it is not in use.

- Do not unplug the appliance from the outlet by
pulling on the cord.

- Do not leave the appliance exposed to the
elements, (rain, direct sunlight, frost, etc.).

- Before doing any cleaning or operation, unplug
the appliance from the electrical outlet. Do not
immerse the appliance, the plug, or the electrical
cord in water.

-In case of break down or improper functioning of
the appliance, turn off the appliance without
tampering with it. For necessary repairs and for
the substitution of the electrical cord, consult the
technical service centre authorised by the
manufacturer.

This appliance conforms to the Directive
89/336/CEE relative to electromagnetic
compatibility.
The materials and the objects destined for contact
with food products are in compliance with the
regulations of the EEC directive 89/109.

GB

GB-326IDL 17-06-2004 8:40 Pagina 4

5

ELECTRICAL REQUIREMENTS (UK ONLY)

Before using this appliance ensure that the voltage indicated on the product corresponds
with the main voltage in your home, if you are in any doubt about your supply contact
your local electricity company.

The flexible mains lead is supplied connected to a
B.S. 1363 fused plug having a fuse of 13 amp
capacity.Should this plug not fit the socket outlets in
your home, it should be cut off and replaced with a
suitable plug, following the procedure outlined below.
Note: Such a plug cannot be used for any other
appliance and should therefore be properly disposed
of, (having removed the fuse) and not left where
children might find it and plug it into a supply socket ­with the obvious consequent danger.
N.B. We recommend the use of good quality plugs
and wall sockets that can be switched off when the
machine is not in use.
IMPORTANT: the wires in the mains lead fitted to
this appliance are coloured in accordance with the
following code:

As the colours of the wires in the mains lead of this
appliance may not correspond with the coloured
markings identifying the terminals in your plug,
proceed as follows:
The wire which is coloured green and yellow must
be connected to the terminal in the plug which is
marked with the letter E or by the earth symbol or
coloured green or green and yellow.

The wire which is coloured blue must be connected
to the terminal which is marked with the letter N or
coloured black.
The wire which is coloured brown must be
connected to the terminal which is marked with the
letter L or coloured red.
When wiring the plug, ensure that all strands of wire
are securely retained in each terminal. Do not forget
to tighten the mains lead clamp on the plug. If your
electricity supply point has only two pin socket
outlets, or if you are in doubt, consult a qualified
electrician.
Should the mains lead ever require replacement, it is
essential that this operation be carried out by a
qualified electrician and should only be replaced
with a flexible cord of the same size.
If the plug is a moulded-on type the fuse cover must be
refitted. If the fuse cover is lost, the plug must not be used
until a replacement cover is obtained. The colour of the
correct replacement fuse cover is that of the coloured
insert in the base of the fuse recess or elsewhere on the
plug. Always state this colour when ordering a
replacement fuse cover.
Only 13amp replacement fuses which are ASTA
approved to B.S. 1362 should be fitted.
This appliance conforms to the Norms EN 55014
regarding the suppression of radio interference.

GREEN AND YELLOW

BLUE

BROWN

EARTH

NEUTRAL

LIVE

WARNING - THIS APPLIANCE MUST BE EARTHED

Green and Yellow to

Earth

Blue to

Neutral

13 amp
Fuse

Brown to
Live

Cord Clamp

GB-326IDL 17-06-2004 8:40 Pagina 5