Page 1
instructions
CKT2013 TOASTER
Page 2
CKT2013 Toaster
2
Description of Appliance
The following terms are used throughout the instruction manual
Bread toasting slots
3
Cable winde
r
Start button
Reheat button
Numbers indicating
the toast colour (from 1-6)
Segments representing
the remaining toasting time.
Display
Stop/cancel button
Defrost button
Control panel
Crumb tray
Page 3
3
Fig.1
CKT2013 Toaster
3
Thank you for choosing this De’Longhi Toaster.To get the best
results from your new appliance it is advisable to read these
instructions carefully before using the appliance.This is the only
way to ensure optimum results and maximum safety.
Using for the first time
To eliminate the "new" smell when using the appliance for
the first time, operate it without food for at least five minutes. During this operation, ventilate the room.
Using the Toaster
"Toasting" function
• Plug the appliance into the mains.You will hear a beep and a
flashing "3" and three black segments appear on the display, indicating that the toaster is set to an intermediate toast colour.
Use the +/- buttons to change the toast colour. The segments
corresponding to the toasting time change accordingly (fig.1).
During the selection phase, the toaster is in stand-by ready for
toasting;
• The first time you use the appliance, you are recommended to
use a medium toast colour.
• Place the slices of bread in the toasting slots and press the start
button .You will hear a beep.
The carriage is lowered automatically and three lines appear
on the display to indicate lowering. When the carriage has
reached the bottom, toasting begins (the number indicating the
selected toast colour and the segments corresponding to the
time remaining flash on the display).
As the toasting time progresses, the segments go out one by
one.You can modify the toast colour at any time during this
phase using the +/- buttons (both the numbers and segments
on the display change).
•To interrupt toasting, just press the stop/cancel button ;
•When toasting is completed, you will hear a beep and the carriage rises.Three flashing lines are displayed in sequence from
the bottom to the top.When the carriage is in the raised position, the last toast colour selected is displayed (flashing).
Once the start button has been pressed to begin toasting,
press the stop/cancel button to block the carriage or cancel the
toasting process. Lowering of the carriage will continue until it
reaches the bottom, then it will rise.
During the selection phase (stand-by), if no button is pressed
within two minutes, the flashing number disappears and the segments only are displayed (screen saver).
When any button is pressed, the display returns to stand-by and
the last selection made is displayed.
Page 4
Reheat function “ ” (reheating slices of bread
toasted previously)
• Place the slices of bread in the toasting slots and press the
reheat button.You will hear a beep and the symbol “ ”
appears on the display.
• During the selection phase, the function can be cancelled by
pressing the reheat button again.
• Begin the reheat process by pressing the start button.You will
hear a beep.The carriage is lowered automatically and the number corresponding to the toast colour on the display is replaced
by three lines to indicate lowering.
When the carriage is at the bottom, the reheat symbol reappears on the display and the last of the lit segments flashes.
During this function, the reheat times are preset and cannot be
altered (about one minute).
When reheating is completed, you will hear a beep and the carriage rises.Three flashing lines are displayed in sequence from
the bottom to the top.When the carriage is in the raised position, the last toast colour selected is displayed (flashing).
Be sure to unplug the waffle maker after each use.
• Remove the plates for cleaning after they have cooled down.
Use a damp cloth and a non-abrasive cleaning detergent. Rinse
and dry thoroughly. The plates are the only detachable parts
that can be cleaned separately.
•Never use sharp or pointed objects or any abrasive cleaning
agents for cleaning purposes.
• DO NOT IMMERSE IN WATER.
Defrost function “ “ (toasting frozen bread)
• Place the slices of frozen bread in the toasting slots and select
the toast colour required using the +/- buttons. Press the
defrost button.You will hear a beep and the symbol
“ “ appears on the display.
• During the selection phase, the function can be cancelled by
pressing the defrost button again.
• Begin the defrost process by pressing the start button .You will
hear a beep.The carriage is lowered automatically and the number corresponding to the toast colour on the display is replaced
by three lines to indicate lowering.
When the carriage is at the bottom, the defrost symbol reappears on the display and the last of the lit segments flashes.
During this function, the cooking times can be altered.
When defrosting is completed, you will hear a beep and the
carriage rises.Three flashing lines are displayed in sequence
from the bottom to the top.When the carriage is in the raised
position, the last toast colour selected is displayed (flashing).
CKT2013 Toaster
4
Page 5
Tips
-Never use the appliance empty (with no bread in the slots).
- Do not toast very thin or broken slices of bread.
- Do not toast foods which may drip during the cooking process.
In addition to making cleaning more difficult, these may cause
fire. It is also extremely important to always clean the crumb
tray of any drips before use.
- Do not use force to insert excessively bulky food into the slots.
- Do not insert forks or other utensils into the toaster to
remove the bread as this could damage the heating elements.
Unplug from the mains, turn the appliance upside down and
shake gently to remove.
Cleaning and maintenance
• Before cleaning or maintenance, always unplug from the mains
socket.
• Allow the appliance to cool down before cleaning.
•Use a damp cloth only to clean the outside of the appliance. •
Do not use abrasive detergents as these could ruin the surface.
• DO NOT IMMERSE IN WATER.
• After using the appliance, always unplug from the mains and
empty the crumb tray on the bottom of the toaster.
• If a slice of toast remains stuck in the slot, unplug the toaster
from the mains, turn upside down, and shake gently.
• NEVER TOUCH ANY PART OF THE TOASTER WITH SHARP
UTENSILS, ESPECIALLY INSIDE THE TOASTING SLOTS.
In the event of malfunction, the toaster is fitted with a safety
device to prevent damage to the lifting motor.
If “ “ appears on the display, take the toa
Safety Warnings
• The appliance is exclusively for the use for which it has been
manufactured. Any other use is to be considered inappropriate
and therefore dangerous. The manufacturer cannot be held
responsible for eventual damage caused by inappropriate,
improper or irresponsible use and/or for repairs made to the
product by unauthorised personnel.
• After removing the appliance from the packaging, make sure
that the product is complete and in perfect condition.
• The plastic bag in which the appliance was packaged should be
kept out of reach of children as it poses a suffocation hazard.
• In order to remove the dust that may have accumulated on
the appliance, simply dust it off with a soft cloth.
• Before inserting the plug into the electrical socket, make certain:
- The voltage of the socket corresponds to the value indicated
on the information label, attached to the appliance.
CKT2013 Toaster
5
E
Page 6
- The electrical socket is adequately earthed, the manufacturer
declines any responsibility for the lack of observation of this
norm.
• In the case of incompatibility between the socket and the plug
of the appliance, have it replaced by a qualified technician. The
use of adapters, multiple socket units and/or extension cables is
not recommended. Whenever it may be necessary to use such
equipment, it is advisable to use only simple or multiple
adapters or extension cables which comply with the current
safety standards, and make sure not to exceed the voltage limit
of the adapter or extension cable.
•When the appliance is plugged into the electrical socket and
whilst switched on never place hands into the bread toasting
slots.
•Never allow the appliance to be used by children or used without adult supervision.
• Do not touch the appliance with wet or damp hands.
• The metal sides of the toaster and the areas surrounding the bread
slots become very hot during use: operating the toaster should be
carried out touching only the plastic dials and handles.
•Bread is a foodstuff which may catch fire. Do not use this appliance under or next to curtains or other combustible material.
• Do not cover the appliance while it is in use.
• Do not use the appliance with bare or wet feet.
•Unplug the appliance from the electrical socket when it is not in use.
• Do not unplug the appliance from the outlet by pulling on the
cord.
• Do not leave the appliance exposed to the elements, (rain,
direct sunlight, frost, etc.).
• Before doing any cleaning unplug the appliance from the electrical socket. Do not immerse the appliance, the plug, or the electrical cable in water.
• In case of breakage or improper cable functioning of the appliance, turn off the appliance without tampering with it. For necessary repairs or replacement of the electrical cable, consult the
technical service centre authorised by the manufacturer.
• As with any electrical appliance, whilst the instructions aim to
cover as many eventualities as possible, caution and common
sense should be applied when opearating your appliance, particularly in the vicinity of young children.
This appliance conforms to the Directive 89/336/CEE relative to
electromagnetic compatibility.
The materials and the objects destined for contact with food products are in compliance with the regulations of the EEC directive
89/109.
CKT2013 Toaster
6
Page 7
CKT2013 Toaster
7
Electrical Requirements
Before using this appliance ensure that the voltage indicated on the product corresponds with the main voltage in
your home, if you are in any doubt about your supply contact your local electricity company.
The flexible mains lead is supplied connected to a B.S. 1363 fused plug
having a fuse of 13 amp capacity.Should this plug not fit the socket outlets in your home, it should be cut off and replaced with a suitable
plug, following the procedure outlined below.
Note: Such a plug cannot be used for any other appliance and should
therefore be properly disposed of, (having removed the fuse) and not
left where children might find it and plug it into a supply socket - with
the obvious consequent danger.
N.B. We recommend the use of good quality plugs and wall sockets
that can be switched off when the machine is not in use.
Important: the wires in the mains lead fitted to this appliance are
coloured in accordance with the following code:
As the colours of the wires in the mains lead of this appliance may not
correspond with the coloured markings identifying the terminals in
your plug, proceed as follows:
The wire which is coloured green and yellow must be connected to
the terminal in the plug which is marked with the letter E or by the
earth symbol or coloured green or green and yellow.
The wire which is coloured blue must be connected to the terminal
which is marked with the letter N or coloured black.
The wire which is coloured brown must be connected to the terminal
which is marked with the letter L or coloured red.
When wiring the plug, ensure that all strands of wire are securely
retained in each terminal. Do not forget to tighten the mains lead
clamp on the plug. If your electricity supply point has only two pin
socket outlets, or if you are in doubt, consult a qualified electrician.
Should the mains lead ever require replacement, it is essential that this
operation be carried out by a qualified electrician and should only be
replaced with a flexible cord of the same size.
If the plug is a moulded-on type the fuse cover must be refitted. If the
fuse cover is lost, the plug must not be used until a replacement cover
is obtained.The colour of the correct replacement fuse cover is that of
the coloured insert in the base of the fuse recess or elsewhere on the
plug.Always state this colour when ordering a replacement fuse cover.
Only 13amp replacement fuses which are asta approved to B.S. 1362
should be fitted.
This appliance conforms to the Norms EN 55014 regarding the suppression of radio interference.
GREEN AND YELLOW
BLUE
BROWN
EARTH
NEUTRAL
LIVE
Green and Yellow to
Earth
Blue to
Neutral
13 amp
Fuse
Brown to
Live
Cord Clamp
Warning
this appliance must be earthed
Page 8
Loading...