
De’Longhi Appliances via Seitz, 47 31100 Treviso Italia www.delonghi.com
1791028IDL/06.16

CGH1020D - CGH1030D
GRIGLIA A CONTATTO
CONTACT-GRILL
GRIL CONTACT
KONTAKTGRILL
CONTACTGRILL
GRILL DOBLE
GRELHADOR DE PLACAS
ΤΟΣΤΙΕΡΑ
ГРИЛЬ
KONTAKT GRILLSÜTŐ
KONTAKTNÍ GRIL
KONTAKTNÝ GRIL
OPIEKACZ
KONTAKTGRILL
KONTAKTGRILL
KONTAKTGRILL
KONTAKTIGRILLI
ТИГІЗІП ПІСІРУ ПЛИТАСЫ

IT
MultiGrill www.delonghi.com
pag. 4 page 21 page 38 S.55 pag. 74
EN
FR
DE
NL
ES
pág. 91 pág. 108 σελ. 125 с тр. 144
HU
old. 164 str. 182 str. 199 str. 216
NO
sid. 233 sid. 250 sid. 267 siv. 284 Бет. 301
ELECTRICAL CONNECTION
A) If your appliance comes tted with a plug, it will incorporate a 13 Amp fuse. If it does not t your socket, the plug should be
cut o from the mains lead, and an appropriate plug tted, as below. WARNING: Very carefully dispose of the cut o plug
after removing the fuse: do not insert in a 13 Amp socket elsewhere in the house as this could cause a shock hazard.
With alternative plugs not incorporating a fuse, the circuit must be protected by a 15 Amp fuse. If the plug is a moulded-on
type, the fuse cover must be re-tted when changing the fuse using a 13 Amp Asta approved fuse to BS 1362. In the event
of losing the fuse cover, the plug must NOT be used until a replacement fuse cover can be obtained from your nearest
electrical dealer. The colour of the correct replacement fuse cover is that as marked on the base of the plug.
B) If your appliance is not tted with a plug, please follow the instructions provided below:
PT
CS
SV
EL
SK
DA
RU
PL
FI
KZ
WARNING - THIS APPLIANCE MUST BE EARTHED
IMPORTANT
The wires in the mains lead are coloured in accordance with the following code:
Green and yellow: Earth
Blue: Neutral
Brown: Live
As the colours of the wires in the mains lead may not correspond with the coloured markings identifying the terminals in your
plug, proceed as follows: The green and yellow wire must be connected to the terminal in the plug marked with the letter E or
the earth symbol
the letter N or coloured black. The brown wire must be connected to the terminal marked with the letter L or coloured red.
or coloured green or green and yellow. The blue wire must be connected to the terminal marked with
2