DeLonghi CGH Series Manual

De’Longhi Appliances via Seitz, 47 31100 Treviso Italia www.delonghi.com
1791018IDL/12.13
CGH Series
CONTACT-GRILL
GRIL CONTACT

CONTACT-GRILLInstructions for use
2
ELECTRICAL CONNECTION UK ONLY
The exible mains lead is supplied connected to a B.S. 1363 fused plug having a fuse of 13 amp capacity.Should this plug not t the socket outlets in your home, it should be cut o and replaced with a suitable plug, following the procedure outlined below. Note: Such a plug cannot be used for any other appliance and should therefore be properly disposed of, (having removed the fuse) and not left where children might nd it and plug it into a supply socket - with the obvious consequent danger. If the plug is a moulded-on type the fuse cover must be retted. If the fuse cover is lost, the plug must not be used until a replacement cover is obtained. The colour of the correct replacement fuse cover is that of the coloured insert in the base of the fuse recess or elsewhere on the plug. Always state this colour when ordering a replacement fuse cover. N.B. We recommend the use of good quality plugs and wall sockets that can be switched o when the machine is not in use. important: the wires in the mains lead tted to this appliance are coloured in accordance with the following code:
As the colours of the wires in the mains lead of this appliance may not correspond with the coloured markings identifying the terminals in your plug, proceed as follows: The wire which is coloured green and yellow must be connected to the terminal in the plug which is marked with the letter E or by the earth symbol or coloured green or green and yellow. The wire which is coloured blue must be connected to the terminal which is marked with the letter N or coloured black. The wire which is coloured brown must be connected to the terminal which is marked with the letter L or coloured red. When wiring the plug, ensure that all strands of wire are securely retained in each terminal. Do not forget to tighten the mains lead clamp on the plug. If your electricity supply point has only two pin socket outlets, or if you are in doubt, consult a qualied electrician. Should the mains lead ever require replacement, it is essential that this operation be carried out by a qualied electrician and should only be replaced with a exible cord of the same size. Only 13amp replacement fuses which are asta approved to B.S. 1362 should be tted. This appliance conforms to the Norms EN 55014 regarding the suppression of radio interference.
green and yellow
blue
brown
earth
neutral
live
Green and Yellow to Earth
13 amp Fuse
Brown to Liv
e
Cord Clamp
Blue to Neutral
Loading...
+ 5 hidden pages