Delonghi Bar390 Owner's Manual

6
SHORT CORD INSTRUCTIONS
- A short power cord is provided to reduce risks resulting from becoming entangled in or tripping over a longer cord.
- Longer, detachable power supply cords or extension cords are available and may be used if care is exercised in their use.
- If an extension cord is used, the marked electrical rating should be at least as great as the electrical rating of the appliance. If the appliance is provided with 3- wire, grounding type cord, the extension should be a GROUNDING TYPE 3 - WIRE CORD. The longer cord should be arranged so that it will not drape over the counter-top or table top where it can be pulled on by children or tripped over.
- Your product is equipped with a polarized alternating current line plug (a plug having one blade wider than the other). This plug will fit into the power outlet only one way. This is a safety feature. If you are unable to insert the plug fully into the outlet, try reversing the plug. If the plug should still fail to fit, contact your electrician to replace your obsolete outlet. Do not defeat the safety purpose of the polarized plug.
IMPORTANT SAFEGUARDS
When using electrical appliances, basic safety precautions should always be followed, including the following:
• Read all instructions.
• Do not touch hot surfaces. Use handles and knobs.
• To protect against fire, electrical shock and personal injury, do not immerse cord, plug or appliance in water or other liquid.
• Close supervision is necessary when any appliance is used by or near children.
• Unplug from the outlet when not in use and before cleaning. Allow to cool before fitting or taking off parts, and before cleaning the appliance.
• Do not operate with a damaged cord or plug, or after the appliance malfunctions, or has been damaged in any manner. Return the appliance to the nearest authorized service facility for examination, repair or adjustment.
• The use of accessory attachments or spare parts not recommended by the appliance manufacturer may result in fire, electrical shock or personal injury.
• Do not use outdoors.
• Do not let the cord hang over the edge of the table or counter, or touch hot surfaces.
• Do not place on or near a hot gas or electrical burner, or in a heated oven.
• Plug cord into the wall outlet. To disconnect, turn any control to “off”, then remove plug from wall outlet.
• Do not use the appliance for other than the intended use.
• DO NOT unscrew or remove boiler cap while the machine is in operation. Wait until brewing cycle is completed and all water and steam has been used up.
• Appliances with Glass Containers:
A. The container is designed for use with this appliance. It must never be used on a range top. B. Do not set a hot container on a wet or cold surface. C. Do not use a cracked container or a container having a loose or weakened handle. D. Do not clean container with cleansers, steel wool pads, or other abrasive material.
SAVE THESE INSTRUCTIONS
bar290 GB 25-10-2000 10:52 Pagina 6
7
Read this instruction booklet carefully before installing and using the machine. In this way, you will obtain the best possible results and maximum operating safety.
DESCRIPTION OF THE APPLIANCE
The following terms are used throughout the instructions manual.
1. Cup stand
2. Accessories holder
3. Steam control knob
4. Water tank
5. Power cord
6. Cup holder grill
7. Drip tray
8. 2-cup adaptor
9. “Cappuccino” nozzle
10.Steam and hot water nozzle
11.Boiler outlet
12.Measuring spoon
13.Filter thumb guard
14.Filter holder
15.1-cup filter
16.2-cup filter
17.Pod filter
18.Automatic coffee press
19.Steam switch
20.Coffee dispenser switch
21.ON/OFF switch ( )
22.ON/OFF indicator light ( )
23.“OK” indicator light
24.Steam indicator light
25.Coffee press
26.Pressure gauge (if fitted)
INSTALLATION
• Place the appliance on a flat work surface away from water sources such as taps or sinks.
• Check that the voltage of the electrical power line corresponds to the voltage indicated on the appliance label. Connect the appliance only to a power source having a minimum load capacity of 10 amps and having a proper grounding feature. The manufacturer takes no responsibility for any accidents caused by the lack of a grounding device for the appliance.
• In case of incompatibility between the plug and
your socket, have the socket replaced by a qualified electrician. The supply cable must not be replaced by the user, as this requires the use of special tools. If the supply cable is damaged, contact an authorized Service Centre.
• Never install the machine in an environment which can reach a temperature of less than or equal to 0°C (if the water inside the machine freezes, the machine might be damaged):
FILLING THE TANK
Remove the reservoir by pullling it sideways, at the same time lifting the tubes (fig. 1). Rinse the reservoir and fill with fresh water (fig. 2). Replace the reservoir in its housing, ensuring that the tubes are immersed in the water (fig. 3). A simpler way of filling the reservoir is to pull it out just enough to be able to pour in water directly from a jug. Never start up the appliance without water in the tank.
PRE-HEATING OF THE MACHINE
In order to obtain a coffee at the right temperature, it is necessary to pre-heat the machine by keeping it on by pushing the ON/OFF switch (fig.4), for at least a half-hour before making coffee. During this time,
it is necessary to
leave the filter holder attached to the boiler.
To attach the filter holder, position it under the boiler shower with the handle towards the left - see fig. 5; push upwards and at the same time rotate the handle towards the right; always rotate as far as it will go). After a half-hour the coffee can then be made as described below.
To speed up this operation, it is also possible: 1 To turn the machine on by pushing the
ON/OFF switch (fig.4).
2. To insert the filter holder in the boiler without coffee or coffee pod. Place a coffee cup beneath the filter holder.
3. To wait until the light "OK" turns on (fig. 6) and press the delivery switch (fig.7), letting the water exit until the “OK” light goes off; then stop the dispensing by pressing the coffee dispenser switch.
4. Then empty the water from the cup, wait until the “OK” light turns back on and repeat the same operation again.
bar290 GB 25-10-2000 10:52 Pagina 7
Loading...
+ 4 hidden pages