DeLonghi BAR 32 User Manual

0 (0)
DeLonghi BAR 32 User Manual

EC190/200 GB 2-01-2003 10:24 Pagina 6

IMPORTANT SAFEGUARDS

When using electrical appliances, basic safety precautions should always be followed, including the following:

Read all instructions.

Do not touch hot surfaces. Use handles and knobs.

To protect against fire, electrical shock and personal injury, do not immerse cord, plug or appliance in water or other liquid.

Never allow the appliance to be used by children or unfit persons.

Unplug from the outlet when not in use and before cleaning. Allow to cool before fitting or taking off parts, and before cleaning the appliance.

Do not operate with a damaged cord or plug, or after the appliance malfunctions, or has been damaged in any manner. Return the appliance to the nearest authorized service facility for examination, repair or adjustment.

The use of accessory attachments or spare parts not recommended by the appliance manufacturer may result in fire, electrical shock or personal injury.

Do not use outdoors.

Do not let the cord hang over the edge of the table or counter, or touch hot surfaces.

Do not place on or near a hot gas or electrical burner, or in a heated oven.

Plug cord into the wall outlet. To disconnect, turn any control to “off”, then remove plug from wall outlet.

Do not use the appliance for other than the intended use. This appliance is to be utilized for domestic use only. Any other use is to be considered improper and therefore, dangerous.

DO NOT unscrew or remove boiler cap while the machine is in operation. Wait until brewing cycle is completed and all water and steam has been used up.

SAVE THESE INSTRUCTIONS

THIS PRODUCT IS FOR HOUSEHOLD USE ONLY

SHORT CORD INSTRUCTIONS

-A short power cord is provided to reduce risks resulting from becoming entangled in or tripping over a longer cord.

-Longer, detachable power supply cords or extension cords are available and may be used if care is exercised in their use.

-If an extension cord is used, the marked electrical rating should be at least as great as the electrical rating of the appliance. If the appliance is provided with 3- wire, grounding type cord, the extension should be a GROUNDING TYPE 3 - WIRE CORD. The longer cord should be arranged so that it will not drape over the counter-top or table top where it can be pulled on by children or tripped over.

-Your product is equipped with a polarized alternating current line plug (a plug having one blade wider than the other). This plug will fit into the power outlet only one way. This is a safety feature. If you are unable to insert the plug fully into the outlet, try reversing the plug. If the plug should still fail to fit, contact your electrician to replace your obsolete outlet. Do not defeat the safety purpose of the polarized plug.

6

EC190/200 GB 2-01-2003 10:24 Pagina 7

Thank you for choosing this coffee machine. To get the very best out of your new coffee machine it is advisable to read these instructions before using the appliance. This is the only way to ensure optimum results and maximum safety.

DESCRIPTION OF THE APPLIANCE

The following terms are used throughout the instruction manual

1Filter holder for ground coffee

2Filter for coffee powder with creamer

3Filter for pods (if fitted)

4Filter holder for pods (if fitted)

5Steam release knob

6Coffee tamper

7Black area inside for positioning cups

8Power supply cable

9OK’ light (coffee/water or steam)

10‘ON/OFF’ light

11Selector knob

12Espresso function

13“O” OFF position

14Steam position

15Coffee measuring spoon

16Boiler outlet

17Delivery tube

18Cappuccino function (for milk frothing)

19Water tank

20Lid for water tank

SAFETY WARNINGS

This machine has been built to “make coffee” and to “reheat beverages”; please be careful to avoid burns from the sprays of hot water or steam and avoid any improper use.

When the appliance is in use, do not touch any of the machine’s hot surfaces

After unpacking, make sure that the machine is complete and undamaged. In case of doubt, do not use the appliance and seek the advice of a qualified service professional.

Packaging materials (plastic bags, foam polystyrene, etc.) should not be left within the reach of children as

this could be a potential source of danger.

This appliance is to be utilized for domestic use only. Any other use is to be considered improper and

therefore, dangerous.

The manufacturer takes no responsibility for damage derived from improper use.

Never touch the appliance with wet or damp hands

The appliance is not intended for use by young

children or infirm persons without supervision.

Your children should be supervised to ensure that they do not play with the appliance.

In case of breakdown or malfunctioning, turn off the appliance immediately and do not touch it. For repairs, please contact a Service Centre authorized by the manufacturer and request the use of original replacement parts only. The lack of respect for this point may compromise the safe use of the appliance.

The power supply cable of this appliance must never be replaced by the user, because its replacement requires the use of special tools. If the cable should become damaged, or in case it needs to be replaced, please go to a Service Centre authorized by the manufacturer.

INSTALLATION

Place the coffee maker on flat work surface at a safe distance from taps and sinks.

Check that the voltage corresponds to that indicated on the appliance rating plate. The appliance must always be connected to a well-earthed socket rated at 10 A minimum. The manufacturer is not liable for damage caused by inadequate earthing of the appliance.

In the event of incompatibility between the plug on the appliance and the socket, have the plug replaced with another of the right type by a qualified professional.

Never install the machine in an environment that can reach a temperature less than or equal to 0°C (if the water in it freezes, the coffee maker may be damaged).

When the machine is in operation, any additional cable can be stored in the machine by inserting it back into the cable supply outlet.

The power cable can be positioned to the right or left, depending on where the nearest power outlet to the appliance is located, by lodging it in the corresponding guides underneath the appliance (Fig. 1).

When changing the position of the power cable, check that it is properly secured by the special clips underneath the appliance (Fig. 1).

HOW TO PREPARE ESPRESSO COFFEE

FILLING THE WATER TANK:

To remove the water tank lid (fig.2) simply pull upwards (fig 3) and fill the tank at the sink (fig 4). Do not exceed the MAX level on the water tank. The tank may also be filled without removing it, simply by pouring water into it directly from a jug.

Replace the tank by connecting the valve at the bottom of the tank with the hole in the base on the machine.

7

EC190/200 GB 2-01-2003 10:24 Pagina 8

WARNING: it is completely normal for there to be water in the compartment under the tank; as a result, this compartment should be dried using a clean sponge.

Note: Do not operate the appliance without water in the tank and always remember to fill the tank when theater level goes below the MIN level

PREHEATING THE COFFEE MACHINE

To ensure your espresso coffee is dispensed at the right temperature it is essential that the coffee unit is preheated. Turn the selector knob so that the intended line on the selector knob points to the boiler on function (fig.5) at least half an hour before making the coffee, making sure that the filter holder is hooked to the machine

(always make sure that the steam knob is closed).

1.Attach the empty filter holder (without coffee) to the machine by positioning it under the boiler outlet with the handle towards the left (fig 6). Push upwards and at the same time turn the handle as far right as possible. It does not matter if the handle is not centrally aligned with the machine, as long as the filter holder is firmly attached to the appliance.

2.Position a cup under the filter holder. Use the same cup that the coffee will be served in, so that it may be preheated.

3.Wait until the orange “OK” light comes on (fig 7)

and turn the selector knob to the espresso function position (fig. 8) Allow water to flow until the orange “OK” light goes out, then stop the flow of water by turning the selector knob to the boiler on function (fig 5)

4.Empty the cup, wait until the “OK” pilot light comes on again and repeat the whole operation one more time.

HOW TO PREPARE ESPRESSO COFFEE:

1.After carrying out the preheating of the machine as described in the preceding section, place the filter for coffee powder with creamer in the filter holder, making sure the tab is correctly inserted in the corresponding slot, as shown in Fig. 9.

To prepare just one cup of coffee, fill the filter with 1 even measuring spoon of ground coffee, around 7 grams (Fig. 10). To prepare two cups of coffee, on the other hand, use the filter with the creamer and fill it with two scant measuring spoons of ground coffee (around 6+6 grams). Fill the filter in small doses to avoid spilling the coffee.

Note: use high quality, finely-ground coffee for espresso coffee makers.

2.Distribute the ground coffee uniformly and press it lightly with the pressing pad (Fig. 11).

3.Remove any excess coffee from around the edges of the filter.

4.Place the cup or cups (cups can be preheated by rinsing under hot water) on the black part of the removable drip

tray (fig 12). Ensure that the cup or cups line up with the dispensing holes on the filter holder.

5.Wait until the “OK” light comes on (fig 7) and turn the selector knob to the espresso function

position (fig 8). Allow water to flow until the desired quantity is reached, then stop the flow of water by turning the selector knob to the boiler on function (fig 5)

6.To detach the filter holder, turn the handle from right to left.

ATTENTION: to avoid spraying, never detach the filter holder while the machine in brewing coffee.

NOTE:Pressing the coffee is very important in order to prepare a food coffee. However if you press too hard, coffee will come out slowly and cream will be of a dark colour. If you press to light, coffee will come out too fast and cream will be a very light color.

7.To remove the used coffee, hold the filter locked with the special lever that is built into the handle and let

the coffee fall out by knocking the overturned filter holder (Fig. 13).

8.To switch off the coffee machine, turn the selector knob on the appliance to the OFF position “O” (fig. 14).

ATTENTION: The first time that coffee is prepared, it is necessary to wash all of the accessories and the internal circuits of the machine, preparing at least five coffees without using the ground coffee

HOW TO PREPARE COFFEE USING THE FILTER HOLDER FOR PODS (if fitted):

Preheat the machine as described in the ‘Preheating the Coffee Machine’ section, making sure to leave the filter holder attached to the unit. Following this procedure ensures that the coffee is delivered at a hotter temperature, as well as guaranteeing that the seal of the filter holder gaskets is more effective.

Press the filter holder button and insert the pod into

the filter (fig 15).

Note: Use pods which conform to the ESE standard: this will be indicated on the packaging by the following symbol:

The ESE standard is a system accepted by the leading coffee pod manufacturers, and allows espresso coffee to be prepared simply and without any mess.

8

Loading...
+ 4 hidden pages