DAVIS Wheel A Weigh User Manual

#1489
TRANSOM BRACKET KIT
For use with Launching Wheels for
Inflatables #1487 and #1488
ASSEMBLY INSTRUCTIONS
This hardware allows these wheels to be installed on almost any boat with a hard transom of 12" (30 cm) high or more.
of inflatable
Template provided
with kit
3/8" Drill
Holes
TRANSOM
INTERIOR
of inflatable
Transom
Bolt
Rubber
Gasket
Rubber
Gasket
fused to
Steel
Washer
Nut
1. Position the left and right struts on the transom,
wheels facing out and spread well apart to provide lateral stability.
2. Mark the center of hole “TOP” for both struts or cen­ter in the hole that may already be there. It is impor­tant that the weight is carried by the strut brackets, not by the knob assemblies.
3. Using the template printed on the next page of this document, align hole “TOP” with the the left-hand mark on the transom. Make certain that the strut as outlined on the template is vertical. Mark the “LEFT” hole. Repeat for the right-hand strut and mark the “RIGHT” hole.
4. Drill through the transom at “RIGHT” and “LEFT” using a 3/8" (9.5 mm) drill.
5. Assemble the transom hardware as shown in drawing below. Bolt into place.
6. With everything positioned, check the alignment of hole “TOP” and drill using a 3/8" (9.5 mm) drill.
3465 Diablo Avenue, Hayward, CA 94545, U.S.A.
Phone (510) 732-9229 • Fax (510) 732-9188
info@davisnet.com
For information about our other fine products, visit
www.davisnet.com
1489_Ins.pdf October 2005
#1489
Transom Bracket Kit
TEMPLATE
Loading...