Danfoss TS3 Installation guide

TS3 Floor Sensor

Installation Instructions

Mounting

The  oor sensor is recommended to be placed
in an installation pipe.
The  oor sensor should be placed between two
pipes and near to the  oor surface.

Floor sensor wiring
to thermostat

Speci cations

10KΩ±2% @ 25ºC
Encapsulated in Ø8mm x 50mm long Copper
Tube 2 meter PVC cable.
With end-stripped outer sheath 10mm, inner
core insulation 5mm.

Wiring

Danfoss can accept no responsibility for possible errors in catalogues, brochures and other printed material. Danfoss reserves the right to alter its products without notice. This also
applies to products already on order provided that such alterations can be made without subsequential changes being necessary in speci cations already agreed.

Part No: 3498v01 08/07