Daisy DPST52, DPST1250, DPSQ52, DPWM1255, DPSQ58 Installation Instructions Manual

1. Wrap paper template

around roller tube, the end you
want to install the Daisy Power
motor and controls

2. Without the drive motor

inside the tube, mark and drill
the 6 x 4.5mm holes through
the template with the 4.5mm
drill bit (3 around the end of the
tube and 3 around the inside
of the tube approximately
243mm from end of tube)

3. Insert the drive motor, (if

there is a feather plug in way,
remove, then replace after
motor install) then using the

4.5mm drill again, drill through
the 6 holes in the tube, through
the drive motor flange

daisy

P O W E R

daisy

pool covers & rollers

Installation

Instructions

Page 1

4. Insert and tighten the 6 x

mounting screws

5. Ensure drive motor wire is

running through the recess in
the housing on the end

6. Install the end frame, secure firmly 4 x

mounting bolts

7. Install the control housing, secure firmly the

4 x mounting bolts

8. Plug in the drive motor wire to the connector socket on the underside of the control housing

Note: each connector socket has labels for the correct appliance

Page 2