This information will be incorporated into the next revisions.
MN-CMR5995-IOM, Rev1, Section 4.3.11, Tuner Menu
MN-CMR6000-IOM, Rev1, Section 4.4.11, Tuner Menu
Change From:
Fill Rate:
Note: It is recommended that this value NOT be changed.
Change To:
Fill Rate:
This value should not be changed from the factory default setting (1,000,000) unless the receiver
is being utilized for low-latency traffic such as VoIP traffic. Comtech EF Data recommends
modifying this parameter to improve latency and jitter performance, to a setting greater than
5,000,000. The actual setting will depend upon traffic and may need to be set on a per case
basis. The valid value range is 0 to 10,000,000, with the default as 1,000,000. VoIP traffic may
require a setting between 5,000,000 to 10,000,000. Setting the Fill Rate to 10,000,000 (the
maximum setting) may lower the overall performance (packets per second and bits per second)
of the product by as much as 10%, so care must be taken when modifying this parameter.
Changes to:
MN-CMR5995-IOM, Rev1, Section 4.3.11, Tuner Menu
MN-CMR6000-IOM, Rev1, Section 4.4.11, Tuner Menu
October 8, 2008
ER-CMR6000-EA1
ER-CMR5995-EA1
ER-CMR6000-EA1
Agile CO Number
CO5247
AGILE DOC IDs: ER-CMR5995-EA1, ER-CMR6000-EA1 AGILE C05247
THIS DOCUMENT IS NOT SUBJECT TO REVISION Page 1
Notes:
AGILE DOC IDs: ER-CMR5995-EA1, ER-CMR6000-EA1 AGILE C05247
THIS DOCUMENT IS NOT SUBJECT TO REVISION Page 2
Errata B
Comtech EF Data Documentation Update
Subject:
Date:
Original Manual
Part Number:
Errata Number /
Agile Document ID
Changes to Appendix F. DVB-S/S2 BER Performance
June 26, 2009
MNCMR6000.IOM Rev 1
ER-CMR6000-EB1
Agile CO Number
C08557
Change Specifics:
This information will be incorporated into the next revision. Appendix F, p. F-1:
Test Configuration: Assumptions:
Symbol Rate: 20 Msps
Frame Size = 64,800 (Normal Frames) Es/No = C/N
Pilots: Off
Roll Off: 35%
Nominal Input Power: -51 dB
L-Band Frequency: 1,170 MHz
Input Range:
-25 to -61 dBm (2 Msps)
-25 to -60 dBm (6 Msps)
-25 to -59 dBm (10 Msps)
-25 to -57 dBm (20 Msps)
-25 to -56 dBm (32 Msps)
Receive signal level Monitor Accuracy ± 10 dB (-25 to -50 dBm)
QEF = 10
‐7
PER
AGILE DOC ID ER-CMR6000-EB1 THIS DOCUMENT IS NOT SUBJECT TO REVISION/UPDATE! AGILE C08557
1
AGILE DOC ID ER-CMR6000-EB1 THIS DOCUMENT IS NOT SUBJECT TO REVISION/UPDATE! AGILE C08557
2
Errata C
Comtech EF Data Documentation Update
Subject:
Date:
Original Manual
Part Number:
Errata Number /
Agile Document ID
Changes to DVB-S2 Pilot, Chapter 4 and Appendix D
October 5, 2009
MNCMR6000.IOM Rev 1
ER-CMR6000-EC1
Agile CO Number
C09574
Change Specifics:
This information will be incorporated into the next revision:
Added to Chapter 4, 4.2.14.1 Primary and Backup Tuner Configurations, p. 4-24:
Pilot
Enables or disables the Pilot for DVB-S2 mode of operation only.
Important: Pilots must be enabled for reliable operation below 6.0 Msps.
Added to Chapter 4, 4.3.3.1.2 Tuner Config, p. 4-35:
Pilot
Enables or disables the Pilot for DVB-S2 mode of operation only.
Important: Pilots must be enabled for reliable operation below 6.0 Msps.
Added to Chapter 4, 4.4.11.1 Tuner Configuration Menu, p. 4-66:
Pilot
Enables or disables the Pilot for DVB-S2 mode of operation only.
Important: Pilots must be enabled for reliable operation below 6.0 Msps.
Added to Appendix D, D.2 Required Information for Setting up a Digicast Satellite Receiver, p. D-3:
8. Pilots @
Important: Pilots must be enabled for reliable operation below 6.0 Msps.
Added to Appendix D, D.5 Required Important Terms to Understand, p. D-7:
Pilots
Important: Pilots must be enabled for reliable operation below 6.0 Msps.
AGILE DOC ID ER-CMR6000-EC1 THIS DOCUMENT IS NOT SUBJECT TO REVISION/UPDATE! AGILE C09574
1
This page is intentionally blank.
AGILE DOC ID ER-CMR6000-EC1 THIS DOCUMENT IS NOT SUBJECT TO REVISION/UPDATE! AGILE C09574
Customer Support .................................................................................................................................... vii
About this Manual ................................................................................................................................... viii
Reporting Comments or Suggestions Concerning this Manual ............................................................ viii
Conventions and References ................................................................................................................... viii
Cautions and Warnings ......................................................................................................................... viii
Limitations of Warranty ........................................................................................................................... xi
4.3.3 LED Menu Display ................................................................................................................ 4-30
4.3.4 FAST ...................................................................................................................................... 4-36
D.2Required Information for Setting Up a Digicast Satellite Receiver ...................................... D–3
D.3Verify Frequency Values .......................................................................................................... D–4
iii
Digicast Media Router S2 Receiver CMR-6000 Revision 1
Table of Contents MN-CMR6000-IOM
D.4Configure the Equipment ......................................................................................................... D–5
D.5Important Terms to Understand .............................................................................................. D–7
APPENDIX E.CONFIGURING AND CONTROLLING THE DIGICAST CMR-6000 MEDIA ROUTER
WITH SNMP E–1
E.1Required SNMP Information for Configuring a Digicast Product ....................................... E–1
E.2Configuring the Digicast CMR-6000 Product for SNMP ...................................................... E–2
E.3SNMP and Digicast Products ................................................................................................... E–3
E.4MIB II ......................................................................................................................................... E–4
E.4.1 MIB II OIDs on the Digicast Media Router (Model CMR-6000) .......................................... E–5
Contact the Comtech EF Data Customer Support Department for:
• Product support or training
• Reporting comments or suggestions concerning manuals
• Information on upgrading or returning a product
A Customer Support representative may be reached at:
Comtech EF Data
Attention: Customer Support Department
2114 West 7th Street
Tempe, Arizona 85281 USA
480.333.2433 or 480.333.4357 (Customer Support Desk)
480.282.2850 (After Hours Support)
480.333.2161 FAX
To return a Comtech EF Data product (in-warranty and out-of-warranty) for repair or replacement:
• Contact the Comtech EF Data Customer Support Department. Be prepared to supply the
Customer Support representative with the model number, serial number, and a description of the
problem.
• Requesta Return Material Authorization (RMA) number from the Comtech EF Data Customer
Support representative.
• Pack the product in its original shipping carton/packaging to ensure that the product is not
damaged during shipping.
•Ship the product back to Comtech EF Data. (Shipping charges should be prepaid.)
For Online Customer Support:
An RMA number request can be requested electronically by contacting the Customer Support Department
through the online support page at
• Click on the “RMA Request Form” hyperlink, then fill out the form completely before sending.
• Send e-mail to the Customer Support Department at cdmipsupport@comtechefdata.com.
For information regarding this product’s warranty policy, refer to the Warranty Policy, p. xi.
Preface
www.comtechefdata.com/service.asp:
vii
Loading...
+ hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.