Comnet CNGE1IPS User Manual

INSTALLATION AND OPERATION MANUAL
CNGE1IPS
POWER OVER ETHERNET (POE+) MIDSPAN INJECTOR FOR 10/100/1000T(X)
The ComNet™ CNGE1IPS is an industrial power over Ethernet (PoE+) midspan injection module that injects 56 VDC at 0.625 amperes to any network cable. Operating power and 10/100/1000T(X) Ethernet data are easily combined on one cable, eliminating the need to install additional power outlets and electrical cabling. The CNGE1IPS is fully compliant with the requirements of IEEE 802.3at for Power Sourcing Equipment (PSE), and features auto detection of powered devices (PDs). Transmission distances of up to 330 feet (100 meters) are supported, and this injector supplies operating power for all PDs drawing a maximum of 30 watts. The unit provides AC line and powered device over-voltage and short circuit protection. Ideally suited to fiber optic, wireless, or other networks where it may be difficult to furnish operating power to the PDs, the CNGE1IPS is a true plug-and-play product requiring no user configuration or other set-up.
A single LED indicator confirms equipment operating status. Figure 3 on Page 2 describes the LED indicators for the unit.
INS_CNGE1IPS_REV–
06/21/11
PAGE 1
INSTALLATION AND OPERATION MANUAL CNGE1IPS
FIGURE 1 – CONNECTIONS
ETHERNET IN
POWER CONNECTOR
90 to 264 VAC ETHERNET & POE+ OUT
FIGURE 2 – PIN OUT
RJ-45 Input (Data Only) RJ-45 Output (Data & Power)
Pin Symbol Description Symbol Description
1 BI_DA+ Data Pair A+ BI_DA+ Data Pair A+
2 BI_DA- Data Pair A- BI_DA- Data Pair A-
3 BI_DB+ Data Pair B+ BI_DB+ Data Pair B+
4 BI_DC+ Data Pair C+ +V + BI_DC+ power(+) + Data Pair C+
5 BI_DC- Data Pair C- +V + BI_DC- power(+) + Data Pair C-
6 BI_DB- Data Pair B- BI_DB- Data Pair B-
7 BI_DD+ Data Pair D+ -V + BI_DD+ power(-) + Data Pair D+
8 BI_DD- Data Pair D- -V + BI_DD- power(-) + Data Pair D-
FIGURE 3 – LED INDICATOR
INSTALLATION CONSIDERATIONS
Units should be installed in dry locations protected from extremes of temperature and humidity.
COLOR STATUS
GREEN PoE Device Detected and Powered Up
OFF Unit Powered Down
RED Mains Power Applied But No PoE Device Detected
3 CORPORATE DRIVE | DANBURY, CT 06810 | USA T: 203.796.5300 | F: 203.796.5303 | TECH SUPPORT: 1.888.678.9427 | INFO@COMNET.NET
8 TURNBERRY PARK ROAD | GILDERSOME | MORLEY | LEEDS, UK LS27 7LE T: +44 (0)113 307 6400 | F: +44 (0)113 253 7462 | INFO-EUROPE@COMNET.NET
© 2014 Communica tions Networ ks Corporation. All Rights Reserve d. “ComNet” and the “ComNet Logo” are regis tered trademarks of C ommunication Network s, LLC.
IMPORTANT SAFEGUARDS: A) Elevated Operating Ambient - Consideration should be given to installing
the equipment in an environment compatible with the maximum ambient temperature (Tma) specified by the manufacturer.
B) Reduced Air Flow - Installation of the equipment should be such that
the amount of air flow required for safe operation of the equipment is not compromised.
INS_CNGE1IPS_REV–
06/21/11
PAGE 2
Loading...