COATS 85608056, Air Line Water Separator User Manual

Air Line Water Separator

Kit 85608055

For use with COATS Tire Changers

Hennessy Industries • 1601 J. P. Hennessy Drive, LaVergne, TN USA 37086-3565 (800) 688-6359 • (615) 641-7533 • (615) 641-5104 FAX • www.ammcoats.com

Instructions

Before beginning this modification or attempting any maintenance, remove the electrical power and air source from the machine; also, bleed off any stored compressed air by exhausting through the air blast foot valve.

1. Air Unit - Locate hole on back of chassis as shown.

Electric Unit - Drill a 0.221 diameter hole 2-inches

below the ground screw as shown.

Air Unit -Locate Hole Back Of Chassis

Electric Unit

-Drill Hole 2" Below Ground Screw

Bracket Placement

Air Unit

Operation & Maintenance

The separator is equipped with an automatic drain and

should not normally need draining.

The separator has a replaceable filter element that should be changed when it becomes dirty. The element can be accessed by rotating the bowl to the left 45° and pulling down.

Service Parts

Part No. Description

85608058 Filter Bowl

85608057 Filter Element

85000749 Bracket

8106301 Screw

8184256 Elbow Fitting

Bracket Placement

Electric Unit

2. Attach bracket to chassis using screw provided.

3. Install elbow fittings to separator with the hose

barbs pointing down.

4. Remove clamp and fitting from unit inlet hose.

5. Slide new clamp on to hose, slide hose over hose

barb fitting on the right side of separator. Install clamp.

6. Repeat step 5 with the air supply hose, attaching it

to the left side of separator.

7. Place separator assembly into bracket.

8. Electric - Canadian Units Only - Apply supplied

decals (2) on air tank to replace the original decals that are now covered by the separator bracket.

9. Re-connect power sources and check for air leaks.

Correct as needed.