Clear-Com MD-XLR User Manual

MD-XLR

Dynamic Headset Adapter

INSTALLATION INSTRUCTIONS

The enclosed adapter is one of the following three types.

Model No. Connector Type

MD-XLR4M 4-Pin Male XLR
MD-XLR4F 4-Pin Female XLR
MD-XLR5F 5-Pin Female XLR

The adapter is used with various types of headsets that have a dynamic microphone and an
XLR connector which mates with one of the connector types shown above. Use the adapter to
connect the headset to your HME Beltpac as follows.

• Plug the mini-DIN connector at one end of the adapter into your Beltpac.

• Plug the headset connector into the other end of the adapter.

Figure 1. Connect mini-DIN connector to Beltpac and XLR adapter to headset

• The current version of MD-XLR adapters has up to 12dB more MIC GAIN than

previous versions. The current version can be identified by a blue sleeve.
Earlier versions have either a black sleeve or no sleeve at all.

• Use the enclosed clothing clips to

fasten the adapter and headset
cables to your belt or clothing.
Position the adapter as far from
the Beltpac as possible. Figure 2
shows the suggested position,
which helps to avoid loose­hanging cables and interference
from the Beltpac.

Figure 2. Clip cables to belt or clothing

HM ELECTRONICS, INC. 14110 Stowe Drive, Poway, CA 92064 USA • Phone: [phone] Fax: [phone]

HME# 400G561
Rev B 6/4/09