∗ Please read this owner’s manual in its entirety before operating this equipment.
∗ After reading this manual, be sure to keep it in a handy place (e.g., glove compartment).
∗ Check the contents of the enclosed warranty card and keep it carefully with this manual.
∗ This manual includes the operating procedures of the iPod interface, CD changer, Satellite Radio
Receiver and TV tuner connected via the CeNET cable. The iPod interface, CD changer and TV
tuner have their own manuals, but no explanations for operating them are described.
1. When the inside of the car is very cold and the
player is used soon after switching on the
heater moisture may form on the disc or the
optical parts of the player and proper playback
may not be possible. If moisture forms on the
disc, wipe it off with a soft cloth. If moisture
forms on the optical parts of the player, do not
use the player for about one hour. The
condensation will disappear naturally allowing
normal operation.
This equipment has been tested and found to
comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable
protection against harmful interference in a
residential installation.
This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and
used in accordance with the instructions, may
cause harmful interference to radio
communications. However, there is no guarantee
that interference will not occur in a particular
installation.
If this equipment does cause harmful interference
to radio or television reception, which can be
determined by turning the equipment off and on,
the user is encouraged to consult the dealer or
an experienced radio/TV technician for help.
2. Driving on extremely bumpy roads which
cause severe vibration may cause the sound
to skip.
3. This unit uses a precision mechanism. Even
in the event that trouble arises, never open
the case, disassemble the unit, or lubricate
the rotating parts.
CAUTION
USE OF CONTROLS, ADJUSTMENTS, OR
PERFORMANCE OF PROCEDURES OTHER
THAN THOSE SPECIFIED HEREIN, MAY
RESULT IN HAZARDOUS RADIATION
EXPOSURE.
THE COMPACT DISC PLAYER SHOULD NOT
BE ADJUSTED OR REPAIRED BY ANYONE
EXCEPT PROPERLY QUALIFIED SERVICE
PERSONNEL.
CHANGES OR MODIFICATIONS NOT
EXPRESSLY APPROVED BY THE
MANUFACTURER FOR COMPLIANCE COULD
VOID THE USER’S AUTHORITY TO OPERATE
THE EQUIPMENT.
INFORMATION FOR USERS:.
CHANGES OR MODIFICATIONS TO THIS
PRODUCT NOT APPROVED BY THE
MANUFACTURER WILL VOID THE
WARRANTY AND WILL VIOLATE FCC
APPROVAL.
Bottom View of Source Unit
DXZ765MP38DXZ765MP
Motorized Face
This unit uses motorized face to make large-screen displays possible.
When you use the motorized face, be sure to close it.
CAUTION
BE CAREFUL NOT TO GET YOUR FINGERS
CAUGHT WHEN OPENING AND CLOSING
THE MOTORIZED FACE.
1. For safety’s sake, always close the
MOTORIZED FACE before leaving this unit
unused for a prolonged period or switching
OFF the ignition key.
If you switch OFF the ignition key with the
MOTORIZED FACE tilted, the MOTORIZED
FACE does not close.
2. Before the MOTORIZED FACE closes, there
may be a braking sound from the safety
mechanism. This is normal.
3. If you move the MOTORIZED FACE by hand,
this may create play. To correct this play, with
the power on for the unit, press the [Q]
button to close the MOTORIZED FACE.
4. After a disc is ejected, the MOTORIZED
FACE automatically returns to the tilted or
closed state. If there is any obstruction when
the MOTORIZED FACE tries to close, the
safety mechanism is triggered and the
MOTORIZED FACE returns to the open state.
If this happens, remove the obstruction, then
press the [Q] button.
5. To avoid scratching the compact disk, keep
the 12 or 8 cm CD level when inserting or
removing them.
Handling Compact Discs
•
Use only compact discs bearing the or
mark.
Do not play heart-shaped, octagonal, or other
specially shaped compact discs.
Some CDs recorded in CD-R/CD-RW mode
may not be usable.
Handling
•
Compared to ordinary music CDs, CD-R and
CD-RW discs are both easily affected by high
temperature and humidity and some of CD-R
and CD-RW discs may not be played. Therefore,
do not leave them for a long time in the car.
• New discs may have some roughness around
the edges. If such
discs are used, the
player may not work
or the sound may
skip. Use a ball-point
pen or the like to
remove any
roughness from the
edge of the disc.
•
Never stick labels on the surface of the compact
disc or mark the surface with a pencil or pen.
• Never play a compact disc with any
cellophane tape or other glue on it or with
peeling off marks. If you try to play such a
compact disc, you may not be able to get it
back out of the CD player or it may damage
the CD player.
Ball-point pen
Roughness
Do not use compact discs that have large
scratches, are misshapen, cracked, etc. Use of
such discs may cause misoperation or damage.
•
To remove a compact disc from its storage case,
press down on the center of the case and lift the
disc out, holding it carefully by the edges.
• Do not use commercially available CD
protection sheets or discs equipped with
stabilizers, etc. These may damage the disc or
cause breakdown of the internal mechanism.
Storage
• Do not expose compact discs to direct sunlight
or any heat source.
• Do not expose compact discs to excess
humidity or dust.
• Do not expose compact discs to direct heat
from heaters.
Cleaning
• To remove fingermarks and dust, use a soft
cloth and wipe in a straight line from the center
of the compact disc to the circumference.
• Do not use any solvents, such as commercially
available cleaners, anti-static spray, or thinner
to clean compact discs.
• After using special compact disc cleaner, let
the compact disc dry off well before playing it.
English
Be sure to unfold and read the next page. / Veuillez déplier et vous référer à la page suivante.
Cerciórese de desplegar y de leer la página siguiente.
DXZ765MP4
English
3.CONTROLS / LES COMMANDES / CONTROLES
Source unit / Appareil pilote / Unidad fuente
Français
[
RELEASE
]
[
ADJ
[
]
ROTARY
]
[ ]
Español
[å] ,
[∂]
[
]
A-M
[
]
ISR
[
SRC]
[
SCN]
[
RPT]
[
]
RDM
With the MOTORIZED FACE opened / Ouvrez la FACE MOTORISÉE
Apertura del FRONTAL MOTORIZADO
[
DIRECT
]
[D]
[
IR-RECEIVER
[
BND
[DN], [UP]
[Q]
[
T
]
[C]
[Z]
]
]
[
CD SLOT
Note: Be sure to unfold this page and refer to the front diagrams as you read each chapter.
Remarque: Veuillez déplier cette page et vous référer aux schémas quand vous lisez chaque chapitre.
Nota: Cuando lea los capítulos, despliegue esta página y consulte los diagramas.
]
English
4. NOMENCLATURE
Note:
• Be sure to read this chapter referring to the front diagrams of chapter “3. CONTROLS” on page 5 (unfold).
Names of the Buttons and Their Functions
[RELEASE] button
• Deeply push in the button to unlock the DCP.
[ADJ] button
• Switches to the adjust mode.
[ROTARY] knob
• Turn to adjust the volume.
• Performs various settings.
[] button
• Plays or pauses a CD while in the CD/MP3/
WMA mode.
• Performs preset scan in the radio mode.
Press and hold for 2 seconds or longer to
perform auto store.
• Confirms various settings.
[Q] button
• Press to open the MOTORIZED FACE and
insert a CD into the CD SLOT.
• Press to eject a CD loaded in the unit.
[C] button
• Press to select display color.
• Press and hold for 1 second or longer to
select the user color.
[Z] button
•
Selects one of the 3 types of sound
characteristics preset in memory.
[T] button
• Switches the titles.
• Press and hold for 1 second or longer to
input or scroll the title.
[D] button
• Switches the display indication (main display,
title display).
• Press and hold the button for 1 second or
longer (do not over 4 seconds) to enter the
display adjust mode.
• Press and hold for 4 seconds or longer to
turn off the display while in the usual play,
ISR mode, telephone interrupt.
[IR-RECEIVER]
• Receiver for remote control unit. (Operating
range: 30° in all directions).
[BND] button
• Switches the band.
• Press and hold for 1 second or longer to
switch seek or manual tuning.
• Returns to a first track while in the CD/MP3/
WMA mode.
•
Press and hold for 1 second or longer to switch
the track type to play in the CD/MP3/WMA mode.
6DXZ765MP
• Press the button to change the character.
[UP], [DN] buttons
• Selects the folder. (MP3/WMA disc only)
[DIRECT] buttons
• Stores a station into memory or recalls it
directly while in the radio mode.
[RDM] button
• Performs random play while in the CD/MP3/
WMA mode.
• Press and hold for 1 second or longer to
perform folder random play while in the MP3/
WMA mode.
[RPT] button
• Repeats play while in the CD/MP3/WMA
mode.
• Press and hold for 1 second or longer to
perform folder repeat play while in the MP3/
WMA mode.
[SCN] button
• Performs scan play for 10 seconds of each
track while in the CD/MP3/WMA mode.
• Press and hold for 1 second or longer to
perform folder scan play while in the MP3/
WMA mode.
[SRC] button
• Press to turn on the power.
• Press and hold for 1 second or longer to turn
off the power.
• Switches the operation mode among the
radio mode, etc.
[ISR] button (Instant station recall)
• Recalls ISR radio station in memory.
•
Press and hold for 2 seconds or longer: Stores
current station into ISR memory (radio mode only).
[A-M] button
• Switches to the audio mode (SW VOLUME,
BASS, TREBLE, BALANCE, FADER).
• Press and hold for 1 second or longer to turn
on or off the MAGNA BASS EXTEND.
[å, ∂] lever
• Selects a station while in the radio mode or
selects a track while in the CD/MP3/WMA
mode.
•
This lever is used to make various settings.
•
Press the lever upward or downward and hold
in position for 1 second or longer to enter the
fast-forward or fast-backward mode.
[CD SLOT]
• CD insertion slot.
Major Button Operations When External Equipment is
Connected to This Unit
English
● When the CD/DVD changer/
iPod interface is connected
∗ For details, see the section “CD Changer
Operations”. For the DVD changer, refer
to the Owner’s Manual provided with the
DVD changer.
For the iPod interface, refer to the Owner’s
Manual provided with the iPod interface.
∗ Hereinafter, “iPod interface” is abbreviated
as iPod BB.
Regarding iPod BB (EA-1251B)
The iPod interface allows connection of an
iPod that can then be operated in the same
way as a 6 disc CD changer.
• When an iPod is connected to the iPod
BB, subsequent operations are as
performed from the main unit.
• Not all iPod functions can be controlled
from the main unit.
• iPod models usable with the iPod
interface include models supporting the
following software versions:
… iPod 3rd generation software Ver. 2.2
or later.
… iPod 4th generation software Ver. 3.0.1
or later.
… iPod mini software Ver. 1.2 or later.
… iPod photo (images cannot be
displayed).
* See your iPod Owner’s manual regarding
what software version is supported by
your iPod.
Notes:
• Scan play cannot be performed with the iPod
BB.
• In order to operate the iPod like a 6-disc CD
changer, a playlist must be constructed
beforehand.
• When connecting the iPod BB and CD
changer, set the address switch on the side
of the CD changer to “2”.
• For other precautions, consult the iPod BB
Owner’s manual.
•“iPod” is a trademark of Apple Computer,
Inc., registered in the U.S. and other
countries.
[] button
• Play or pause a CD, DVD or iPod BB.
[T] button
• Press the button, switches the user titles or
track titles, etc. while in the CD changer
mode.
• Use the button to input a title in the CD
changer mode.
• Use the button to scroll the title during CDtext play.
[BND] button
• Move the next disc in increasing order.
[UP], [DN] buttons
• Select the disc.
[RDM] button
• Perform random play. Also perform disc
random play when the button is pressed and
held.
[RPT] button
• Perform repeat play. When this button is
pressed and held, disc repeat play is performed.
[SCN] button
• Perform scan play for 10 seconds of each
track. Disc scan play is performed when the
button is pressed and held.
[å, ∂] lever
• Select a track when listening to a disc.
• Press the lever upward or downward and hold
in position for 1 second or longer to enter the
fast-forward or fast-backward mode.
DXZ765MP75DXZ765MP
Major Button Operations When External Equipment is Connected to This Unit
English
● When the TV is connected
∗
For details, see the section “TV Operations”.
[ADJ] button
• Press and hold the button for 1 second or
longer to switch to the TV picture mode or
VTR (external) picture mode.
[] button
• Perform preset scan while in the TV mode.
When the button is pressed and held, auto
store is performed.
[BND] button
• Switch the band.
• When the button is pressed and held, switch
seek tuning or manual mode.
● When the Satellite Radio
Receiver is connected
∗ For details, refer to the Owner’s Manual
provided with the Satellite Radio Receiver.
[DIRECT] buttons
• Stores a station into memory or recall it
directly.
[SRC] button
• Press the button to switch the operation
mode.
[ISR] button
• Select the CAT (Category).
[å, ∂] lever
• Select a station.
[DIRECT] buttons
• Store a station into memory or recall it
directly.