Clarion CAA-185-200 User Manual

Printed in Japan 2006/12 284-8050-02

CCD Camera Power Supply Box

CAA- 185-200

Installation Instructions

1. Precautions

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15
of the FCC Rules.

These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance

with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation.

If this equipment does cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to consult the dealer or an experienced radio/TV technician
for help.

INFORMATION FOR USERS:.

CHANGES OR MODIFICATIONS TO THIS PRODUCT NOT APPROVED BY THE MANUFACTURER WILL
VOID THE WARRANTY AND WILL VIOLATE FCC APPROVAL.

2. Package Contents

1.

CCD camera power supply box: ·············

2. Bag of accessories: ················· 1 bag

Electro taps: ·············································· 2
Velcro:······················································· 1
Velcro:······················································· 1

3. Bag of accessories: ················· 1 bag

Tapping screws: ········································2

1

4. Bag of accessories: ················· 1 bag

Connector cable (red): ······························1
Connector cable (light green): ·················· 1
Connector cable (black): ··························· 1
Connector cable (red): ······························1

5. RCA cable ········································ 1

4. Mounting Procedure

Mounting the CCD Camera Power Supply Box

Mount the CCD camera power supply box in a location such as under a seat using either the
supplied tapping screws (ø4 x 12) or velcro.

■ Mounting Using Tapping Screws

ø4✕12

CCD camera
power supply box

ø4✕12

■ Mounting Using Velcro

CCD camera
power supply box

Velcro

*Thoroughly wipe any dirt from the mounting

surface.

* Remove the separator from the back of the

velcro and apply it to the mounting surface.

Fig.4Fig.3

CAUTION

1. If harnesses will come into contact with the sharp edges of metal plates, or the like, protect
them using grommets or insulation tubes.

2. Before drilling any holes in a vehicle, make sure that there are no electrical wires, brake fluid
pipes, or the like, running behind to surface to be drilled.

3. Making Connections

3-1. System Connection Example

CCD camera
power supply box

Light green

Black

Red

To ACC power supply (12 V)

3-2. Connecting the Supplied Cables

Hook up the supplied connector cables as shown in Fig. 2.

To reverse gear
signal (12 V)

GND

Fig.1

CCD camera

For making connections to a TV
or video monitor equipped
with a video input jack

Light
green

Black

Red

To reverse gear signal (12 V)

GND

To ACC power supply (12 V)

Used to provide a 12 V power supply

FIG.2

to an additional device.

3-3. Power Cable Connections

When connection cannot be made to the terminals, use the supplied Electro Tap to make
the connection as illustrated in the diagram.

As illustrated in the diagram, the intermediate
cable is brought against the stopper and bent
back in the direction of the arrow.

The tip of the cable is
cut at a convenient

From the vehicle side

Power cable

length.

Coupler connected
to another piece of
equipment

Not needed

Latch

From the unit

Stopper

From the unit

Hook

Power cable

Pass the vehicle-side cable through and
bend back in the direction of the arrow.

Vehicle-side wire

Close with pliers until the latch engages.

Unit-side cable

Vehicle-side cable

Clarion Co., Ltd.