CITIZEN 085X User Manual

USER’S GUIDE

Index

085X 2 3740 3 5861 4 B74 5 C50 6 C300 7 C320 8 C330 9 C605 10 D206 11

USER’S GUIDE

CAL. No.

008855XX

Features include:

• SOLID STAINLESS STEEL CASE AND BRACELET

• ALARM

• 1/20 SEC. CHRONOGRAPH MEASURES UP TO 60 MINUTES

• 80 DAY POWER RESERVE

• PUSH BUTTON SAFETY CLASP

• 100 METER WATER-RESISTANT

BEFORE USING

When the watch is not functioning properly, it may be insufficiently charged. Charge the watch for more than 6 hours, approximately 6 to 8 inches away from a fluorescent lamp. For faster results, charge watch under direct sunlight for more than 1 hour.

'0' POSITION ADJUSTMENT

• Press and release M until mode indicator points t '0'. The second and auxiliary hands should move to the 12 o'clock position. If these hands fail to move to the 12 o'clock position, the following steps must be taken to align the hands before the watch will work properly:

• Pull M out step

• Press and release A until the second hand aligns with the 12 o'clock position.(Press and hold for rapid advance).

• Press and release B until the auxiliary hand a aligns with the 12 o'clock position.

• Push M in gently to the normal position.

TO SET TIME

• Press and release M until the mode hand points to TME.

• Pull M out one step.

• Press B to advance time forward or C to move time backward. Set time to correct hour and minute, using the 24 hour dial to determine AM or PM.

• Push M back in to normal position.

TO SET DAILY ALARM

• Press and release M until the mode hand points to ALM.

• Pull M out one step.

• Press and hold B to advance time forward or C to move time backward. Alarm is automatically turned on.

• Press and release A to turn alarm on or off.

• Press M in to normal position.

TO USE CHRONOGRAPH

• Press and release M until the mode hand points to CHR.

• Press and release A to start and stop chronograph.

• Press and release C to reset to zero.

• Pressing C during chronograph measurement causes the chronograph split time to appear on display with a beep for confir- mation.

• Press C again, the next chronograph split time is displayed, along with a confirmation beep. The split time display is automat- ically canceled after 10 seconds and returns to chronograph measurement state.

For further instructions, see instruction manual

SETTING INSTRUCTIONS

MODELS: AP5070-57A High Tech Chrono

USER’S GUIDE

CAL. No.

33774400

Features include:

• SOLAR-POWERED

• DEPTH SENSOR

• DEPTH INDICATOR HAND

• ELAPSED-TIME BEZEL

• WATER SENSOR

• 50 MINUTE CHRONOGRAPH

• 200 METER WATER-RESISTANT

• RESERVE POWER INDICATOR

• RECHARGEABLE BATTERY

SETTING INSTRUCTIONS

1 - Mode selection. 2 - Chronograph start and stop. 3 - Crown.

CHANGING MODES

• To switch to chronograph mode while in normal time display mode, press and release 1. Depth, seconds and mode hands move to 12 o'clock position. To switch back press and release 1.

• To switch to dive mode, press and hold down I for 3 seconds. Mode hand moves to "DIV" and depth hand moves to 12 o'clock position. To switch back to time press and hold 1 down for 3 seconds.

TO USE CHRONOGRAPH

• Press and release 1 to enter Chronograph mode.

• Press and release 2 to start or stop chronograph.

• Press and hold 2 down for 3 seconds to reset chronograph.

TO USE DIVE METER

• Press and hold 1 down for 3 seconds to enter dive mode. Mode hand will move to "DIV" and depth indicator will move to "0" Ft. Watch is now ready for diving.

• To read the maximum depth memo for the last dive, press 2 while in time or dive mode and the depth indicator hand will point to the maximum depth of the last dive.

For further instructions see instruction manual.

MODELS: AY5000-05L Aqualand Chrono

USER’S GUIDE

CAL. No.

55886611

Features include:

• ELEKTRONIC DEPTH SENSOR

• ANALOG DEPTH INDICATOR

• MAXIMUM DEPTH MEMORY DISPLAY

• DEPTH ALARM INDICATOR

• RAPID ASCENT WARNING SIGNAL

• WATER-RESISTANT TO 200 METERS

• LOW BATTERY INDICATOR

• LUMINESCENT DIAL

• ONE WAY BEZEL

SETTING INSTRUCTIONS

A - Increases target depth while in the Depth Alarm mode and recalls maximum depth memory while out of depth mode. B - Decreases target depth while in the Depth Alarm mode. C - Advances watch through the various modes. D - Crown.

BEFORE USE

Set watch to 12:00 position. Unscrew crown until spring is released. Pull crown out two steps. Press A, B, C, simultaneously you will hear a confirmation beep upon release. Set large red Depth Hand to 12:00 position by pressing and holding A until hand approaches 12:00 position then release. Rapidly press and release A until hand exactly matches 12:00 position. Set thin red maximum depth hand by pressing and holding B until it aligns at 12:00 position. Press crown in two steps. This will point maxi- mum depth hand to EX.

TO SET TIME AND DATE

Turn crown counter clockwise to loosen. Then pull crown out two steps. Turn clockwise until date display changes by 1 day. This places the time in AM mode. Tom crown clockwise until desired time (AM or PM) is reached. Push crown in one step. Tom crown counter clockwise until the desired date is reached. Push crown in and turn clockwise to tighten. DEPTH ALARM Press and release C to move Maximum Depth hand to AL. To set target depth, hold A (to increase) or B (to decrease). To change in ten foot increments, press and release A (to increase) or B (to decrease). After one minute, watch will automatically return to time mode and retain depth alarm setting. To manually return to time mode, press and release C.

DIVING FUNCTIONS

Hold C for 3 seconds to move both red hands to 12:00 position. All functions are now in operational mode. Rapid Ascent W arning Signal automatically sounds if ascent rate exceeds 4.92 feet per 5 second. To return to time position, hold C for 3 seconds.

For further instructions, see instruction manual.

MODELS: AL0004-03W ANALOG AQUALAND

+ 7 hidden pages