CENTRAL BRASS 0285 Installation Manual

Bar Faucet

Cast Brass

2.2 GPM Aerator

Gooseneck Spout

Compression Stems with

Replaceable Seats

0285 Series Contemporary-Styled Bar Faucet

Faucets with lever, wrist or elbow
handles and compression or ceramic
stem cartridges are ADA compliant.

Certified to
ANSI/NSF 61 Section9

CENTRAL BRASS MFG CO

2950 East 55th Street, Cleveland, Ohio 44127

Phone: [phone] Fax: [phone] Email: sales @CentralBrass.com

022803 I-0285

www.CentralBrass.com

CENTRAL BRASS

INSTALLATION

INSTRUCTIONS

1. Assemble hot & cold supply tubes to faucet body . Tighten tubes with open end wrench.

2. Apply a thin coat of plumber's putty on the bottom edge of the faucet body and place the faucet
shank thru the hole in the sink.

3. Install the washers and locknut on the faucet shank. Position the faucet and tighten the locknut.

4. The body should be positioned with the cold indexed handle on the right. Then install the spout,
tighten spout nut to body (if necessary).

5. Connect the supply tubes to the hot (left) and cold (right) supply lines. Do not kink supply tubes
when bending to connect with supply lines.

6. Turn on supply lines. Check all connections for leakage. Turn on hot and cold water for one
minute to flush out dirt and sediment that might have accumulated during installation. T urn off
water and assemble aerator. Check under sink connections for leakage.

CENTRAL BRASS MFG CO

2950 East 55th Street, Cleveland, Ohio 44127

Phone: [phone] Fax: [phone] Email: sales @CentralBrass.com

022803 I-0285

www.CentralBrass.com