Canon SX420 IS User Manual
Getting Started
ENGLISH
CEL-SW3PA211
Package Contents
Package Contents
Before use, make sure the following items are included in the package.
If anything is missing, contact your camera retailer.
Camera Battery Pack
Wrist Strap*
*1 Do not peel off the battery pack label.
*2 For attachment instructions, refer to the Camera User Guide that can be downloaded
from the Canon website.
• Printed matter is also included.
• A memory card is not included.
2
NB-11LH*
1
Lens Cap
(with cord)*
Battery Charger
CB-2LFE
2
Compatible Memory Cards
No memory card is included. Purchase one of the following kinds of card
as needed. These memory cards can be used, regardless of capacity. For
details on the number of shots and recording time per memory card, see
“Specifi cations” in the downloadable Camera User Guide.
• SD memory cards* • SDXC memory cards*
• SDHC memory cards*
* Cards conforming to SD standards. However, not all memory cards have been verifi ed
to work with the camera.
2
Manuals and Software
Manuals and Software
Initial Preparations
You can download manuals and software from the following
URL.
http://www.canon.com/icpd/
• With a computer connected to the Internet, access the above URL.
• Access the site for your country or region.
• Adobe Reader is required to view the manuals.
• You can also download software from the website. For instructions on
downloading and installing the software, refer to the Camera User Guide
available for download.
• You may be requested to enter the serial
number (body number) when downloading
the manuals and software.
In this case, enter the number printed on
the bottom of the camera.
Initial Preparations
Charging the Battery Pack
1 Insert the battery pack.
(1)
After aligning the marks on the battery
(2)
pack and charger, insert the battery pack
by pushing it in (1) and down (2).
2 Charge the battery pack.
Plug the power cord into the charger, then
plug the other end into a power outlet.
The charging lamp turns orange, and
charging begins.
When charging is fi nished, the lamp turns
green. Remove the battery pack.
For details on charging time and the
number of shots or recording time available
with a fully charged battery pack, refer
to “Specifi cations” in the downloadable
Camera User Guide.
3
Initial Preparations
Inserting the Battery Pack and Memory Card
(2)
1 Open the cover.
Slide the cover (1) and open it (2).
(1)
2 Insert the battery pack.
Holding the battery pack with the
terminals (1) facing as shown, press the
battery lock in the direction of the arrow
and insert the battery pack until the lock
clicks shut.
If you insert the battery pack facing the
(1)
(2)
wrong way, it cannot be locked into the
correct position. Always confi rm that the
battery pack is facing the right way and
locks when inserted.
To remove the battery pack, press the
battery lock in the direction of the arrow.
3 Check the card’s write-protect
tab and insert the memory card.
Recording is not possible on memory
cards with a write-protect tab when the
tab is in the locked position. Slide the tab
to the unlocked position.
(1)
Insert the memory card with the label (1)
facing as shown until it clicks into place.
To remove the memory card, push it in
until you feel a click, and then slowly
release it.
(1)
4 Close the cover.
Lower the cover (1) and hold it down as
(2)
you slide it, until it clicks into the closed
position (2).
4
Loading...